Hip position influences shear wave elastography measurements of the hamstring muscles in healthy subjects

Is thoracolumbar fascia shear-wave modulus affected by active and passive knee flexion?

The purpose of this study was to examine the effect of passive and active knee flexion efforts on the stiffness of the thoracolumbar (TLF), semitendinosus (STF), and semimembranosus fascia (SMF). Fourteen young healthy males participated in this study. Using ultrasound shear-wave elastography, fascia elastic modulus was measured at rest (passive condition) and during submaximal isometric knee flexion efforts (active condition) with the hip at neutral position and the knee flexed at 0°, 45°, and 90°. Analysis of variance designs indicated that when the knee was passively extended from 90° to 0°, shear modulus of the TLF, SMF, and STF increased significantly (p < 0.05). Similarly, active knee flexion contractions caused a significant increase in TLF, SMF, and STF shear modulus (p < 0.001). Compared to hamstring fascia, the TLF showed greater thickness but a lower shear modulus (p < 0.05) while STF modulus was greater compared that to SMF during active contraction (p < 0.05). These results indicate that exercising the hamstring muscles can remotely influence the stiffness of the fascia which surrounds the lumbar area.

Suitable ultrasound screening method for older adults with disability to identify low muscle mass

Objective

This study aimed to investigate the accuracy and consistency of different ultrasound protocols for the measurement of gastrocnemius muscle (GM) thickness and to identify a suitable ultrasound scheme that can be used to detect the low muscle mass in older with disability.

Materials and methods

In this cross-sectional study, each participant underwent three different ultrasound protocols for the measurement of the GM thickness, and each measurement was repeated three times. The three measurement schemes were as follows: method A, lying on the examination bed in a prone position with legs stretched and relaxed and feet hanging outside the examination bed; method B, lateral right side lying position with legs separated (left leg flexed and right leg in a relaxed state); and method C, right side lying position with legs together and lower limb muscles in a relaxed state. The low muscle mass was determined by averaging two or three measurements of the GM thickness determined using different sonographic protocols.

Results

The study included 489 participants. The difference in the prevalence of low muscle mass identified between two and three replicates of the same measurement protocol ranged from 0 to 1.3%. Considering the three repeated measurements of the method A as the reference, the area under the curve (AUC) in different measurement schemes were 0.977-1 and 0.973-1 in males and females, respectively. Furthermore, male and female Kappa values from low to high were 0.773, 0.801, 0.829, 0.839, and 0.967 and 0.786, 0.794, 0.804, 0.819, and 0.984, respectively.

Conclusion

Different ultrasound measurement protocols showed high accuracy and consistency in identifying low muscle mass. Repeating the measurements two or three times was found to be feasible.

Hamstrings force-length relationships and their implications for angle-specific joint torques: a narrative review

Temporal biomechanical and physiological responses to physical activity vary between individual hamstrings components as well as between exercises, suggesting that hamstring muscles operate differently, and over different lengths, between tasks. Nevertheless, the force-length properties of these muscles have not been thoroughly investigated. The present review examines the factors influencing the hamstrings’ force-length properties and relates them to in vivo function. A search in four databases was performed for studies that examined relations between muscle length and force, torque, activation, or moment arm of hamstring muscles. Evidence was collated in relation to force-length relationships at a sarcomere/fiber level and then moment arm-length, activation-length, and torque-joint angle relations. Five forward simulation models were also used to predict force-length and torque-length relations of hamstring muscles. The results show that, due to architectural differences alone, semitendinosus (ST) produces less peak force and has a flatter active (contractile) fiber force-length relation than both biceps femoris long head (BFlh) and semimembranosus (SM), however BFlh and SM contribute greater forces through much of the hip and knee joint ranges of motion. The hamstrings’ maximum moment arms are greater at the hip than knee, so the muscles tend to act more as force producers at the hip but generate greater joint rotation and angular velocity at the knee for a given muscle shortening length and speed. However, SM moment arm is longer than SM and BFlh, partially alleviating its reduced force capacity but also reducing its otherwise substantial excursion potential. The current evidence, bound by the limitations of electromyography techniques, suggests that joint angle-dependent activation variations have minimal impact on force-length or torque-angle relations. During daily activities such as walking or sitting down, the hamstrings appear to operate on the ascending limbs of their force-length relations while knee flexion exercises performed with hip angles 45–90° promote more optimal force generation. Exercises requiring hip flexion at 45–120° and knee extension 45–0° (e.g. sprint running) may therefore evoke greater muscle forces and, speculatively, provide a more optimum adaptive stimulus. Finally, increases in resistance to stretch during hip flexion beyond 45° result mainly from SM and BFlh muscles.

Effect of hip and knee joint angles on resting hamstring muscles rigidity in men and women

PURPOSE

Hamstring muscle strains are one of the most common injuries in sports practice, for both men and women. However, sex disparities in the rate of muscle injuries have been observed. As these muscular injuries usually occur at long muscle length, this study aimed to determine the effect of sex on hamstring muscles' resting rigidity under different stretching conditions.

METHODS

The shear wave speed (SWS) of resting hamstring muscles was measured in 12 men and 12 women in different hip and knee positions (hip extended with knee flexed, hip flexed with knee extended, both joints extended and both joints flexed).

RESULTS

Combining all the positions, the SWS of the semitendinosus was higher in men than in women (2.96 vs. 2.71 m.s^-1). Regardless of sex, a significant rise in SWS was systematically observed when the semimembranosus was stretched (1.86, 2.37, 2.76 and 4.39 m.s^-1) but it was neither the case for the semitendinosus (p = 0.82) nor for the biceps femoris (p = 0.50). Finally, differences in SWS among the hamstring muscles were only observed at the longest muscle length, with greater SWS values for the semimembranosus and semitendinosus in comparison with the biceps femoris (4.39 and 4.12 vs. 3.38 m.s^-1 respectively).

CONCLUSION

In conclusion, a sex difference was only observed in the resting semitendinosus rigidity. Independently of sex, the increase in resting hamstring muscles SWS with stretch was muscle specific.

Is there a correlation between the femoral anteversion angle and the elasticity of the hip muscles in cases of intoeing gait due to increased femoral anteversion angle?

Purpose

One of the common causes of gait disturbance in children is increased femoral anteversion. There are not enough publications in the literature on muscles related to the hip joint in increased femoral anteversion. The aim of this study was to evaluate the relationship between the femoral anteversion angle and hip muscle elasticity in children walking inward, using shear wave elastography (SWE).

Material and methods

Seventeen children with bilateral increased femoral anteversion angle in computed tomography were prospectively included in this study. Elasticity values of the hip muscles (adductor magnus (adductor), iliopsoas (flexor), gluteus medius (abductor), gluteus maximus (extensor) muscles) were evaluated by ultrasound elastography by two observers. Quantitative measurements of the shear wave velocities were performed using virtual touch tissue imaging quantification.

Results

There was excellent harmony between the femoral anteversion angle measurements performed by the two observers and a good congruence between the muscle elastography evaluations. While there was a moderate significant correlation between the femoral anteversion angle and the elasticity values of the iliopsoas and adductor magnus muscles, no significant correlation was found with other muscle elasticity measurements.

Conclusion

Iliopsoas muscle and adductor magnus muscle elasticity are correlated with the femoral anteversion angle. With further studies, we think that physical therapy methods for the elasticity of the muscles associated with the femoral anteversion angle can reduce the complaints of the patients.

Ultrasonic characterization of localized passive elastic properties of human pennate muscle with a single-probe setup

Quantitative evaluation of passive elastic properties of an individual skeletal muscle in vivo is among the major challenges of biomechanics, and its clinical application is severely limited. By combining shear-wave elastography (SWE) and B-mode imaging techniques, this study develops a novel non-invasive method to measure the local elastic modulus-fascicle strain curve of human pennation muscle during passive stretching using a single probe. Physiologically meaningful parameters are estimated and compared in subjects with different ages or pathological conditions. The in vivo experimental group comprised 12 healthy subjects (four children, four adults, and four seniors) and eight patients (four suffering from pseudohypertrophy, four from atrophy). Their gastrocnemius muscles were passively stretched using an ankle joint motion instrument. Local elastic moduli of the muscle were measured using SWE imaging frames and a built-in 'F-ROI' tool. The corresponding fascicle strains were simultaneously obtained using B-mode imaging frames and a gradient Radon transform. Three parameters (η, μ, G0) were estimated from a normalized elastic modulus-strain curve using the Gauss-Newton method. The measured elastic modulus-strain curves all agreed with models of the estimated parameters (0.910 < R2 < 0.999) and presented different patterns among normal and diseased subjects. η values were lower for pseudohypertrophies (1.93 ± 0.12), but higher for atrophies (63.40 ± 98.89), compared with normal ones (6.02 ± 2.53). In addition, μ values were higher for pseudohypertrophies (22.65 ± 16.40), but lower for atrophies (0.28 ± 0.41), compared with normal ones (1.07 ± 1.22). The proposed method may provide novel insight into the biomechanics of pennate muscle and has the potential to serve for clinical musculoskeletal medical diagnosis, as the single-probe scanning setup is broadly accepted.