The difference of in-shoe plantar pressure between level walking and stair walking in healthy males

Effects of heel apex position, apex angle and rocker radius on plantar pressure in the heel region

Introduction

Rocker shoes and insoles are used to prevent diabetic foot ulcers in persons with diabetes mellitus and loss of protective sensation, by reducing the plantar pressure in regions with high pressure values (>200 kPa) (e.g., hallux, metatarsal heads and heel). However, forefoot rocker shoes that reduce pressure in the forefoot inadvertently increase pressure in the heel. No studies focused on mitigating the negative effects on heel pressure by optimizing the heel rocker midsole, yet. Therefore, we analyze the effect of different heel rocker parameters on the heel plantar pressure.

Methods

In-shoe pressure was measured, while 10 healthy participants walked with control shoe and 10 different heel rocker settings. Peak pressure was determined in 7 heel masks, for all shoes. Generalized estimating equations was performed to test the effect of the different shoes on the peak pressure in the different heel masks.

Results

In the proximal heel, a rocker shoe with distal apex position, small rocker radius and large apex angle (100°), shows the largest significant decrease in peak pressure compared to rocker shoes with more proximally located apex positions. In the midheel and distal heel, the same rocker shoes or any other rocker shoes, analyzed in this study, do not reduce the PP more than 2 % compared to the control shoe. For the midheel and distal heel region with high pressure values (>200 kPa), rocker shoes alone are not the correct option to reduce the pressure to below 200 kPa.

Conclusion

When using rocker shoes to reduce the pressure in the forefoot, a heel rocker midsole with a distal apex position, small rocker radius and apex angle of 100°, mitigates the negative effects on proximal heel pressure. For the midheel and distal heel, other footwear options as an addition or instead of rocker shoes are needed to reduce the pressure.

In-shoe plantar pressure depends on walking speed and type of weight-bearing activity in people with diabetes at high risk of foot ulceration

BACKGROUND

In evaluating therapeutic footwear, in-shoe plantar pressure is usually obtained during mid-gait steps at self-selected walking speed in a laboratory setting. However, this may not accurately represent plantar pressures or indicate the cumulative stress experienced in daily life. We investigated the effects of walking speed and different weight-bearing activities on in-shoe plantar pressure in people with diabetes at high risk of ulceration.

METHODS

In a cross-sectional study including 30 participants we compared in-shoe plantar pressures between three standardized walking speeds (0.8, 0.6 and 0.4 m/s) and between walking at self-selected speed and eight other weight-bearing activities (3 components of the Timed Up and Go test, accelerating, decelerating, stair ascending and descending, and standing). Mean forefoot regional peak plantar pressure and pressure-time integral were statistically assessed per foot using linear mixed models (α < 0.05) with Holm-Bonferroni correction.

FINDINGS

With increasing walking speed, peak pressures increased and pressure-time integrals decreased (P ≤ 0.014). Peak pressures during standing, decelerating, stair ascending and Timed Up and Go test were lower (P ≤ 0.001), and with other activities not different to walking at self-selected speed. Pressure-time integrals during stair ascending and descending were higher (P ≤ 0.001), during standing lower (P ≤ 0.009), and with other activities not different to walking at self-selected speed.

INTERPRETATION

In-shoe plantar pressure depends on walking speed and type of weight-bearing activity. Only measuring pressures to evaluate footwear at self-selected walking speed in a laboratory setting may not accurately represent the stress on the foot in daily life of the high-risk patient; a more comprehensive assessment is suggested.