Site blocking effect on the conformation of adsorbed cationic polyacrylamide on a solid surface

Bioflocculants from wastewater: Insights into adsorption affinity, flocculation mechanisms and mixed particle flocculation based on biopolymer size-fractionation

HYPOTHESIS

Microbial extracellular polymeric substances (EPS) produced from wastewater are generally heterodispersed, which is expected to influence their flocculation performances and mechanism, particularly in mixed particle systems. The different molecular weight (MW) fractions should contribute to the overall adsorption affinity and flocculation mechanism of EPS in single and dual clay systems.

EXPERIMENTS

EPS harvested from bioreactors were size-fractionated into high, medium and low MW fractions (HMW, MMW, LMW, respectively). The harvested mixed EPS and its fractions were characterised by diverse analytical techniques coupled with optical reflectometry to investigate the role of each EPS fraction in the overall flocculation mechanism of EPS in kaolinite and montmorillonite clay systems.

FINDINGS

In single clay systems, both the harvested mixed EPS and the HMW-EPS fraction showed comparable flocculation performances. However, mixed EPS proved to be more efficient than the HMW-EPS fraction for dual clay flocculation. Site blocking effects were observed in mixed EPS: the LMW and MMW EPS first adsorbed to the surface due to higher diffusivities and faster mass transfer to the interface, while the HMW-EPS were slowly transported but were attached to the surface irreversibly and stronger than the LMW/MMW-EPS. We propose from this, a mixed EPS adsorption mechanism: extended anionic polymer tails in solution, thereby enhancing particle flocculation.

Adsorption and flocculation by polymers and polymer mixtures

Polymers of various types are in widespread use as flocculants in several industries. In most cases, polymer adsorption is an essential prerequisite for flocculation and kinetic aspects are very important. The rates of polymer adsorption and of re-conformation (relaxation) of adsorbed chains are key factors that influence the performance of flocculants and their mode of action. Polyelectrolytes often tend to adopt a rather flat adsorbed configuration and in this state their action is mainly through charge effects, including 'electrostatic patch' attraction. When the relaxation rate is quite low, particle collisions may occur while the adsorbed chains are still in an extended state and flocculation by polymer bridging may occur. These effects are now well understood and supported by much experimental evidence. In recent years there has been considerable interest in the use of multi-component flocculants, especially dual-polymer systems. In the latter case, there can be significant advantages over the use of single polymers. Despite some complications, there is a broad understanding of the action of dual polymer systems. In many cases the sequence of addition of the polymers is important and the pre-adsorbed polymer can have two important effects: providing adsorption sites for the second polymer or causing a more extended adsorbed conformation as a result of 'site blocking'.