Nanosized amine-rich spheres embedded polymeric beads for Cr (VI) removal

The construction of coupling degradation system low temperature plasma and microbiological denitrification: Interfacial reaction process and synergistic mechanism

The degradation of antibiotic wastewater by low-temperature plasma and the removal of excess nitrogen by biological denitrification with Pseudomonas stutzeri (P. stutzeri) reducing secondary pollution has rarely been reported. In this study, iron and phenolic resin doped carbon-based porous nanofiber membranes are prepared (named RFe2-CNF) by electrostatic spinning technique, where the optimization of structure and composition endows low-temperature plasma system better catalyst performance than that of without catalyst (a 58% increase). Microbiological treatment experiments show that the plasma-degraded solution inhibits the denitrification of the P. stutzeri, but overall shows a strong denitrification effect (93.1%). In the coupling process of advanced oxidation technology and microbial denitrification technology, the possible interfacial reaction process, synergistic degradation mechanism, and products toxicity analysis are studied in detail. In addition, LC-MS and DFT are used to derive possible degradation pathways of pollutants. This work provides a new strategy to improve the degradation performance meanwhile reducing secondary pollution by low-temperature plasma-coupled microbiological treatment.

A floating biosorbent of polylactide and carboxylated cellulose from biomass for effective removal of methylene blue from water

A floating adsorbent bead was prepared from polylactide (PLA) and maleic anhydride (MAH)-modified cellulose in a one-pot process (OP bead). Cellulose was extracted from waste lemongrass leaf (LGL) and modified with MAH in the presence of dimethylacetamide (DMAc). PLA was then added directly into the system to form sorbent beads by a phase separation process that reused unreacted MAH and DMAc as a pore former and a solvent, respectively. The chemical modification converted cellulose macrofibres (55.1 ± 31.5 μm) to microfibers (8.8 ± 1.5 μm) without the need for grinding. The OP beads exhibited more and larger surface pores and greater thermal stability than beads prepared conventionally. The OP beads also removed methylene blue (MB) more effectively, with a maximum adsorption capacity of 86.19 mg⋅g-1. The adsorption of MB on the OP bead fitted the pseudo-second order and the Langmuir isotherm models. The OP bead was reusable over five adsorption cycles, retaining 88 % of MB adsorption. In a mixed solution of MB and methyl orange (MO), the OP bead adsorbed 96 % of the cationic dye MB while repelling the anionic dye MO. The proposed method not only reduced time, energy and chemical consumption, but also enabled the fabrication of a green, effective and easy-to-use biosorbent.

Novel efficient capture of hexavalent chromium by polyethyleneimine/amyloid fibrils/polyvinyl alcohol aerogel beads: Functional design, applicability, and mechanisms

The harmful effects of hexavalent chromium (Cr(VI)) on the environment and human health have aroused wide public concern. In this study, bulk spherical aerogel beads (PAP) were synthesized from polyethyleneimine (PEI), protein amyloid fibrils (AFL), and polyvinyl alcohol (PVA) through green technology and its removal of Cr(VI) from wastewater was comprehensively studied. The results showed that although the bulk PAP beads (∼ 5 mm) only had an average pore size of 16.88 nm and a BET surface area of 12 m²/g, its maximum adsorption capacity for Cr(VI) reached 121.44 mg/g (at 298 K). Cr(VI) adsorption onto PAP conformed to pseudo-second-order adsorption kinetics and was endothermic. The adsorption of Cr(VI) decreased stepwise with the increase of solution alkalinity (pH = 2: 91.97%; pH = 10: 0.04%). Importantly, PAP showed high selectivity towards Cr(VI) in mixed heavy metal solutions (Cr(VI) > Pb(II) > Ni(II) > Cu(II) > Cd(II)) and good reusability (removal efficiency > 88% after 5 cycles). PAP had excellent anti-interference ability against FA and HCO₃^- with the overall removal rate exceeding 87% in the presence of 5 - 25 mg/L of these ions. Cations such as Na⁺, Mg²⁺, and other heavy metal ions at high concentrations could promote the removal efficiency of Cr(VI). The removal rates of Cr(VI) and Cr(III) by PAP in a tannery wastewater were 34.4% and 59.3%, respectively. Meanwhile, the removal rates of Cr(VI) in a electroplating wastewater and a contaminated soil leachate reached 84.4∼89.7%, showing high practicability. Mechanism studies revealed that electrostatic attraction, hydrogen bonding, reduction, and complexation were the main reactions for Cr(VI) removal by PAP. In general, the study of PAP provides a new insight into using bulk monolith materials for treating Cr(VI) contaminated wastewater.

An efficient Egeria najas-derived biochar supported nZVI composite for Cr(VI) removal: Characterization and mechanism investigation based on visual MINTEQ model

Egeria najas is a submerged aquatic plant, and the literatures on resourcification of submerged aquatic plant biochar remain limited. Until now, there has been no study on submerged aquatic plant biochar supported nZVI that is widely applied for removal of diversified contaminants in solution. In this study, an efficient approach to the preparation of Egeria najas-derived biochar supported nZVI composite is first developed for Cr(VI) removal in wastewater. The adsorption behavior and mechanism of Cr(VI) removal on the as-prepared Egeria najas-derived biochar/nZVI (EN@nZVI) composite were investigated. The results of FTIR and XPS indicate that the EN@nZVI surface had many functional groups such as R-COOH, R-OH, R-NH₂ and R-C-O-C, etc, which could provide active sites during the adsorption process. The BET results showed that the EN@nZVI had large specific surface area and average pore, which were 142.49 m²/g and 9.85 nm, respectively. EN@nZVI demonstrated high reactivity for Cr(VI) removal. Compared with nZVI, Cr(VI) removal efficiency by EN@nZVI is 50% higher than that of nZVI within 0.5 h. Furthermore, the maximum adsorption capacity of Cr (VI) was 56.79 mg/g and the energy of activation (E_a) was 31.30 kJ/mol. The adsorption process was well described by the pseudo-second order model and Sips adsorption isotherm model. The reaction mechanism of Cr(VI) removal was a multi-step removal mechanism, involving adsorption, surface complex formation, reduction and ion exchange reaction.

Efficient removal of Cr(VI) from water by the uniform fiber ball loaded with polypyrrole: Static adsorption, dynamic adsorption and mechanism studies

A novel adsorbent, the uniform fiber ball (UFB) loaded with polypyrrole (UFB-PPy), was synthesized for Cr(VI) removal from water in this paper. The structure of the UFB and UFB-PPy were characterized by SEM, EDS, FT-IR, BET, XPS and TG. The adsorption properties of UFB-PPy towards Cr(VI) were investigated by the effects of temperature, initial concentration of Cr(VI), interfering ions and contact time in batch experiments, the isothermal models (Langmuir, Freundlich and Temkin) and the kinetic models (Pseudo first-order kinetic, Pseudo second-order kinetic and Intra-particle diffusion models) were used to describe the adsorption behavior. The effects of the initial concentration and flow rate of the Cr(VI) solution in the column experiments were also studied, and the dynamic models (Yoon-Nelson, Adams-Bohart and Wolborska model) were applied to predict the adsorption performance. The Cr(VI) removal mechanism of UFB-PPy was revealed by studying the effect of pH on adsorption, testing of Cl^-, and analyzing the XPS. The results showed that UFB-PPy exhibited excellent adsorption properties for Cr(VI) both in batch and column adsorption. The possible adsorption mechanism involved electrostatic attraction, ion exchange and reduction. Conveniently, the chromium resources can be recovered with the form of high-purity Cr₂O₃ by simple calcination of Cr(VI)-captured UFB-PPy (UFB-PPy-Cr).

Facile Functionalization of Natural Peach Gum Polysaccharide with Multiple Amine Groups for Highly Efficient Removal of Toxic Hexavalent Chromium (Cr(VI)) Ions from Water

The development of low-cost adsorbent with excellent adsorption property remains a big challenge. Herein, the functionalization of natural peach gum polysaccharide (PGP) with multiple amine groups for the removal of toxic Cr(VI) ions from water was studied. The obtained PGP-NH₂ gel exhibited high-removal efficiency (>99.5%) toward Cr(VI) ions, especially with relatively low initial concentration of Cr(VI) ions (≤250 mg/L). The influences of pH, ionic strength, contact time, initial concentration, and temperature on the adsorption of Cr(VI) ions were systematically investigated. The PGP-NH₂ gel showed rapid adsorption rate and could reach adsorption equilibrium within about 40 min. The Cr(VI) ion uptake process could be described by pseudo-second-order kinetic and Langmuir isotherm models. The maximum adsorption capacity of PGP-NH₂ gel could reach 188.32 mg/g. Thermodynamic investigation results indicated the spontaneous and exothermic characteristic of the uptake process. Moreover, the PGP-NH₂ gel also exhibited favorable reusability, and 135.52 mg/g of adsorption capacity was retained even after being reused for five times. Considering its low cost and superior uptake property, the PGP-NH₂ gel holds a great promise for employing as an adsorbent to treat Cr(VI) ion-containing wastewater.