Single and ternary competitive adsorption-desorption and degradation of amphenicol antibiotics in three agricultural soils

Urban agglomerations as an environmental dimension of antibiotics transmission through the "One Health" lens

The spatiotemporal distributions of antibiotics in different media have been widely reported; however, their occurrence in the environmental dimension of the Chinese urban agglomerations has received less attention, especially in bioaccumulation and health risks of antibiotics through the "One Health" lens. The review presents the current knowledge on the environmental occurrence, bioaccumulation, as well as health exposure risks in urban agglomerations through the "One Health" lens, and identifies current information gaps. The reviewed studies suggested antibiotic concentrations in water and soil were more sensitive to social indicators of urban agglomerations than those in sediment. The ecological risk and resistance risk of antibiotics in water were much higher than those of sediments, and the high-risk phenomenon occurred at a higher frequency in urban agglomerations. Erythromycin-H2O (ETM-H2O), amoxicillin (AMOX) and norfloxacin (NFC) were priority-controlled antibiotics in urban waters. Tetracyclines (TCs) posed medium to high risks to soil organisms in the soil of urban agglomerations. Health risk evaluation based on dietary intake showed that children had the highest dietary intake of antibiotics in urban agglomerations. The health risk of antibiotics was higher in children than in other age groups. Our results also demonstrated that dietary structure might impact health risks associated with target antibiotics in urban agglomerations to some extent.

Development of MoS2-stainless steel catalyst by 3D printing for efficient destruction of organics via peroxymonosulfate activation

Herein, a novel MoS2-stainless steel composite material was first synthetized via a 3D printing method (3DP MoS2-SS) for peroxymonosulfate (PMS) activation and organics degradation. Compared with MoS2-SS powder/PMS system (0.37 g/(m2/min)), 4.3-fold higher kFLO/SBET value was obtained in 3DP MoS2-SS/PMS system (1.60 g/(m2/min), resulting from the superior utilization of active sites. We observed that 3DP MoS2-SS significantly outperformed the 3DP SS due to the enhanced electron transfer rate and increased active sites. Moreover, Mo4+ facilitated the Fe2+/Fe3+ cycle, resulting in the rapid degradation of florfenicol (FLO). Quenching experiments and electron paramagnetic resonance spectra indicated that •OH, SO4•-, O2•- and 1O2 were involved in the degradation of FLO. The effect of influencing factors on the degradation of FLO were evaluated, and the optimized degradation efficiency of 98.69% was achieved at 1 mM PMS and pH of 3.0. Six degradation products were detected by UPLC/MS analyses and several possible degradation pathways were proposed to be the cleavage of C-N bonds, dechlorination, hydrolysis, defluorination and hydroxylation. In addition, 3DP MoS2-SS/PMS system also demonstrated superior degradation performance for 2-chlorophenol, acetaminophen, ibuprofen and carbamazepine. This study provided deep insights into the MoS2-SS catalyst prepared by 3DP technology for PMS activation and FLO-polluted water treatment.

Performance and degradation pathway of florfenicol antibiotic by nitrogen-doped biochar supported zero-valent iron and zero-valent copper: A combined experimental and DFT study

Fluorinated compounds are a class of organic substances resistant to degradation. Although zero-valent iron (Fe0) has a promising reducing capability, it still fails to degrade fluorine-containing antibiotics (i.e., florfenicol) efficiently. In this study, we applied a simple one-pot pyrolytic approach to synthesize nitrogen-doped biochar supported Fe0 and zero-valent copper (Cu0) composite (Fe/Cu@NBC) and investigated its performance on florfenicol removal. The results clearly showed that approximately 91.4% of florfenicol in the deionized water was removed by Fe/Cu@NBC within 8 h. As the reaction time was extended to 15 d, the total degradation rate of florfenicol reached 96.6%, in which the defluorination and dechlorination rates were 73.2% and 82.1%, respectively. Both experimental results and density functional theory calculation suggested that ∙OH and ·O2- triggered β-fluorine elimination, resulting in defluorination prior to dechlorination. This new finding was distinct from previous viewpoints that defluorination was more difficult to occur than dechlorination. Fe/Cu@NBC also had a favorable performance for removal of florfenicol in surface water. This study provides a new insight into the degradation mechanism and pathway of florfenicol removal in the Fe/Cu@NBC system, which can be a promising alternative for remediation of fluorinated organic compounds in the environment.

Behavior and mechanisms of ciprofloxacin adsorption on aged polylactic acid and polyethlene microplastics

Microplastics (MPs) and antibiotics are emerging pollutants in aquatic environments. MPs can absorb antibiotics, resulting in compound pollution. Batch adsorption experiments were used to investigate the adsorption behavior of CIP on polylactic (PLA) and polyethlene (PE) under various environmental conditions. After a lengthy aging process, both MPs underwent significant physicochemical changes. The equilibrium adsorption capacities of aged PLA and PE were 0.382 mg/g and 0.28 mg/g, respectively, which increased by 18.06% and 75% compared to pristine PLA and PE. The sorption capacity of MPs increased when the pH of the solution approached the dissociation constant (6.09, 8.74) of CIP. When the salinity of the solution was 3.5%, the adsorption capacity of MPs was reduced by more than 65%. The adsorption capacity of MPs rapidly decreased when 20 mg/L fulvic acid was added. Because norfloxacin (NOR) competes for adsorption sites on the microplastic, CIP adsorption is inhibited. Based on the adsorption models, FTIR, and XPS spectra, we demonstrated that the process was monolayer adsorption, with chemical and physical mechanisms including hydrogen bonding, π-π conjugation, ion exchange, and electrostatic interactions controlling it. Thus, PLA and PE microplastics may be a potential vector for CIP in water, and their interaction is mainly influenced by the physicochemical properties of the MPs and environmental factors.

Effects of natural nanoparticles on the acute toxicity, chronic effect, and oxidative stress response of phenicol antibiotics in Daphnia magna

Natural nanoparticles (NNP) are ubiquitous in natural water and can interact with other contaminants, causing ecotoxic effects on aquatic nontarget organisms. However, the impact of NNPs on the ecotoxicity of antibiotics remains largely unknown. This work investigated the acute toxicity, chronic effect, and oxidative response and damage in Daphnia magna co-exposed to phenicol antibiotics (chloramphenicol, thiamphenicol) and different concentrations of NNPs (10 mg/L: environmentally relevant concentration; 100 mg/L: a high concentration that caused no apparent immobilization in D. magna). The results showed that the acute toxicity of chloramphenicol was increased by 10 mg/L NNPs but decreased by 100 mg/L NNPs; both concentrations of NNPs increased and decreased acute toxicities of thiamphenicol and chloramphenicol + thiamphenicol treatments, respectively. After long-term exposure, phenicol antibiotics (1 μg/L) and NNP (10 mg/L) mixtures in environmentally relevant concentrations significantly affected the reproduction of D. magna but did not influence their growth. The catalase activity, reduced glutathione level, and malonaldehyde content in D. magna also varied with the NNPs concentrations. Notably, the lowest concentration of thiamphenicol and chloramphenicol + thiamphenicol combined with NNPs significantly increased the malondialdehyde content in D. magna compared with the control, indicating membrane lipid peroxidation occurred in daphnids. This study suggests that the toxic effects of contaminants and NNPs on aquatic organisms should be considered thoroughly to avoid underestimating the hazard of these pollutants in the actual aquatic environment.

Preparation of MnO2-Carbon Materials and Their Applications in Photocatalytic Water Treatment

Water pollution is one of the most important problems in the field of environmental protection in the whole world, and organic pollution is a critical one for wastewater pollution problems. How to solve the problem effectively has triggered a common concern in the area of environmental protection nowadays. Around this problem, scientists have carried out a lot of research; due to the advantages of high efficiency, a lack of secondary pollution, and low cost, photocatalytic technology has attracted more and more attention. In the past, MnO₂ was seldom used in the field of water pollution treatment due to its easy agglomeration and low catalytic activity at low temperatures. With the development of carbon materials, it was found that the composite of carbon materials and MnO₂ could overcome the above defects, and the composite had good photocatalytic performance, and the research on the photocatalytic performance of MnO₂-carbon materials has gradually become a research hotspot in recent years. This review covers recent progress on MnO₂-carbon materials for photocatalytic water treatment. We focus on the preparation methods of MnO₂ and different kinds of carbon material composites and the application of composite materials in the removal of phenolic compounds, antibiotics, organic dyes, and heavy metal ions in water. Finally, we present our perspective on the challenges and future research directions of MnO₂-carbon materials in the field of environmental applications.

Fate and exposure risk of florfenicol, thiamphenicol and antibiotic resistance genes during composting of swine manure

Livestock manure is an important source of antibiotic resistance genes (ARGs) spreading to the environment, posing a potential threat to human health. Here, we investigated the dissipation of florfenicol (FF) and thiamphenicol (TAP), and their effects on the bacterial community, mobile genetic elements (MGEs), and ARGs during composting. The results indicated that FF and TAP dissipated rapidly in compost, with half-life values of 5.1 and 1.6 d, respectively. However, FF could not be completely removed during composting. The FF and TAP residues in manure could reduce the elimination of ARGs and MGEs during composting, and had a negative effect on the physicochemical factors of the compost. Significant correlations were found between floR and intI1, indicating that floR in manure may more easily diffuse to the soil environment. Meanwhile, the presence of FF in manure could increase the abundance of floR. Network analysis showed that Proteobacteria and Firmicutes were the dominant bacterial communities and important potential pathogen hosts carrying ARGs. The predicted environmental concentration of FF in the soil was over 100 μg kg^-1, which indicates that FF poses a potential risk to the natural environment, and we verified this result through field experiments. The results showed that FF dissipated in the soil after it migrated from manure to soil. In contrast, TAP in manure posed lower environmental risk. This study highlights that changed in composting conditions may control the rate of removal of ARGs. Further studies are needed to investigate the best environmental conditions to achieve a faster degradation of FF and a more comprehensive elimination of ARGs during composting.

Molecular Mechanisms Underlying the Inhibition of Proliferation and Differentiation by Florfenicol in P19 Stem Cells: Transcriptome Analysis

Florfenicol (FLO), which is widely used in veterinary clinics and aquaculture, can disrupt the protein synthesis of bacteria and mitochondria and, thus, lead to antibacterial and toxic effects in plants, insects, and mammals. FLO was found to repress chicken embryonic development and induce early embryonic death previously, but the underlying mechanism is not fully understood. Clarifying the mechanism of FLO-induced embryonic toxicity is important to the research and development of new drugs and the rational use of FLO to ensure human and animal health and ecological safety. In this study, the effects of FLO on pluripotency, proliferation, and differentiation were investigated in P19 stem cells (P19SCs). We also identified differentially expressed genes and performed bioinformatics analysis to obtain hub genes and conducted some functional analysis. FLO inhibited the proliferation and pluripotency of P19SCs and repressed the formation of embryoid bodies derived from P19SCs. A total of 2,396 DEGs were identified using RNA-Seq in FLO-treated P19SCs, and these genes were significantly enriched in biological processes, such as angiogenesis, embryonic organ development, and morphogenesis of organs. Kyoto encyclopedia of genes and genome-based pathway analysis also showed that five relevant pathways, especially the canonical Wnt pathway, were engaged in FLO-induced toxicity of pluripotent stem cells. We further analyzed modules and hub genes and found the involvement of ubiquitin-mediated proteolysis, DNA replication, and cell cycle machinery in regulating the pluripotency and proliferation of FLO-treated P19SCs. In summary, our data suggest that FLO disrupts the signaling transduction of pathways, especially the canonical Wnt pathway, and further inhibits the expression of target genes involved in regulating DNA replication, cell cycle, and pluripotency. This phenomenon leads to the inhibition of proliferation and differentiation in FLO-treated P19SCs. However, further experiments are required to validate our findings and elucidate the potential mechanisms underlying FLO-induced embryonic toxicity.