Physio-chemical reactions in recycle aggregate concrete

Mechanical Performance of Eco-Friendly Concretes with Volcanic Powder and Recycled Concrete Aggregates

At present, reducing the environmental impact of the construction industry is a major subject of study. In terms of the use of recycled concrete aggregates (RCA), most recently conducted studies have shown that the use of a limited percentage of those aggregates does not significantly affect the properties of concretes. This work analysed the mechanical properties of medium-strength concretes with a high contribution to sustainability, where cement and natural coarse aggregates (NCA) were partially replaced by volcanic powder (VP) and RCA, respectively. Three mixing ratios of VP replacement were tested in concretes without RCA and concretes with 30% RCA replacing NCA. Results show that when VP is used without RCA, up to 10% of the cement can be replaced by VP without a significant loss in the mechanical properties. When a combination of 5% VP and 30% RCA is used, the weakness of the recycled concrete is strengthened, obtaining stronger concretes than a control concrete with no recycled materials. Finally, the greenhouse gas assessment showed that the simultaneous incorporation of VP and RCA reduces CO2 emissions produced in the manufacture of concrete by up to 13.6%.

Experimental investigation of photocatalytic effects of concrete in air purification adopting entire concrete waste reuse model

This research investigated the capacities of recycled aggregate concrete adopting entire concrete waste reuse model in degrading NO_2. Two major issues within environmental sustainability were addressed: concrete waste reuse rate and mitigation of hazards substances in the polluted air. The study consisted of two stages: identification of proper replacement rates of recycled concrete wastes in new concrete mixture design, and the evaluation of photocatalytic performance of recycled aggregate concrete in degrading NO₂. It was found that replacement rates up to 3%, 30%, and 50% for recycled power, recycled fine aggregate, and recycled coarse aggregate respectively could be applied in concrete mixture design without deteriorating concrete strength. Recycled aggregates contained both positive attributes ("internal curing") and negative effects (e.g., lower hardness) to concrete properties. It was found that 30%-50% of natural coarse aggregate replaced by recycled coarse aggregates coated with TiO₂ would significantly improve the photocatalytic performance of concrete measured by degradation rate of NO₂. Micro-structures of recycled aggregates observed under microscope indicated that soaking recycled aggregates in TiO₂ solution resulted in whiskers that filled the porosity within recycled aggregates which enhanced concrete strength.