A facile general route for ternary Fe 2 O 3 @TiO 2 @nanometal (Au, Ag) composite as a high-performance and recyclable photocatalyst

How can heteroatoms boost the performance of photoactive nanomaterials for wastewater purification?

Photocatalysis, as an alternative for treating persistent water pollutants, holds immense promise. However, limitations hinder sustained treatment and recycling under varying light conditions. This comprehensive review delves into the novel paradigm of metal and non-metal doping to overcome these challenges. It begins by discussing the fundamental principles of photocatalysis and its inherent limitations. Understanding these constraints is crucial for developing effective strategies. Band gap narrowing by metal and non-metal doping modifies the band gap, enabling visible-light absorption. Impurity energy levels and oxygen vacancies influenced the doping energy levels and surface defects. Interfacial electron transfer and charge carrier recombination are the most important factors that impact overall efficiency. The comparative analysis of nanomaterials are reviewed on various, including nanometal oxides, nanocarbon materials, and advanced two-dimensional structures. The synthesis process are narratively presented, emphasizing production yields, selectivity, and efficiency. The review has potential applications in the environment for efficient pollutant removal and water purification, economic cost-effective and scalable production and technological advancement catalyst design, in spite of its challenges in material stability, synthesis methods and optimizing band gaps. The novelty of the review paper is on the proposal of a new paradigm of heterojunctions of doped metal and non-metal photocatalysts to promise highly efficient water treatment. This review bridges the gap between fundamental research and practical applications, offering insights into tailored nano photocatalysts.

Photocatalysis air purification systems for coronavirus removal: Current technologies and future trends

Air pollution causes extreme toxicological repercussions for human health and ecology. The management of airborne bacteria and viruses has become an essential goal of air quality control. Existing pathogens in the air, including bacteria, archaea, viruses, and fungi, can have severe effects on human health. The photocatalysis process is one of the favorable approaches for eliminating them. The oxidative nature of semiconductor-based photocatalysts can be used to fight viral activation as a green, sustainable, and promising approach with significant promise for environmental clean-up. The photocatalysts show wonderful performance under moderate conditions while generating negligible by-products. Airborne viruses can be inactivated by various photocatalytic processes, such as chemical oxidation, toxicity due to the metal ions released from photocatalysts composed of metals, and morphological damage to viruses. This review paper provides a thorough and evaluative analysis of current information on using photocatalytic oxidation to deactivate viruses.

Synthesis of mesoporous Ag/α-Fe2O3/TiO2 heterostructures with enhanced and accelerated photo/-catalytic reduction of 4-nitrophenol

4-Nitrophenol (4-NP) is reported to originate disadvantageous effects on the human body collected from industrial pollutants; therefore, the detoxification of 4-NP in aqueous contamination is strongly recommended. In this study, the heterojunction mesoporous α-Fe₂O₃/TiO₂ modulated with diverse Ag percentages has been constructed via a sol-gel route in the occurrence of a soft template P123. The formation of biphasic crystalline TiO₂ anatase and brookite phases has been successfully achieved with the average 10 nm particle sizes. The photo/-catalytic reduction of 4-NP has been performed utilizing NaBH₄ as a reducing agent with and without visible illumination. All Ag/Fe₂O₃/TiO₂ nanocomposites exhibited significantly higher photo/-catalytic reduction efficiency than pure Fe₂O₃, TiO₂ NPs, and Fe₂O₃/TiO₂ nanocomposite. 2.5% Ag/Fe₂O₃/TiO₂ nanocomposite was considered the highest and superior photocatalytic reduction efficiency, and it almost achieved 98% after 9 min. Interestingly, the photocatalytic reduction of 4-NP was accelerated 9 times higher than the catalytic reduction over 2.5% Ag/Fe₂O₃/TiO₂; its rate constant value was 709 and 706 times larger than pure TiO₂ and Fe₂O₃ NPs, respectively. The enhanced photocatalytic reduction ability of Ag/Fe₂O₃/TiO₂ nanocomposite might be referred to as significantly providing visible light absorption and a large surface area, and it can upgrade the effective separation and mobility of electron holes. The stability of the synthesized catalysts exhibited that the obtained catalysts can undergo a slight decrease in reduction efficiency after five successive cycles. This approach highlights a novel route for constructing ternary nanocomposite systems with high photo/-catalytic ability.

Au@Ag bimetallic nanoparticles deposited on palygorskite in the presence of TiO2 for enhanced photodegradation activity through synergistic effect

Herbicides are hazardous organic pollutants that contribute to the risk of environmental contamination. The aim of this work was to investigate the synergistic effect of silver (Ag) and gold (Au) bimetallic nanoparticles deposited on palygorskite (PAL) in the presence of TiO₂ for photodegradation of bentazone (BTZ) herbicide under UV light. Ag and Au@Ag nanoparticles exhibited an average size below 75 nm and surface charge values less than - 30 mV. UV-Vis spectroscopy indicates the formation of core@shell bimetallic nanoparticles. XRD results showed the interactions between the NPs and the palygorskite structure. SEM images clearly illustrate the presence of small spherical particles distributed in the clay fibers. The control of the size and distribution of the nanoparticles played an important role in the properties of the composites. The degradation of the herbicide BTZ showed that nanoparticles, clay, and only TiO₂ did not produce satisfactory results; however, when Ag-Pal and Au@Ag-Pal were in the presence of the TiO₂, the degradation was efficient. The best photodegradative system was Au@Ag-Pal+TiO₂, which was maintained after the third cycle. The bentazone photodegradation using Au@Ag-PAL+TiO₂ exhibited toxicity against Artemia salina. Therefore, Au@Ag-PAL+TiO₂ photocatalyst showed that the synergy of bimetallic nanoparticles deposited on clay for enhanced photodegradation activity of bentazone herbicide.

Photocorrosion resistant Ag2CO3@Fe2O3/TiO2-NT nanocomposite for efficient visible light photocatalytic degradation activities

Ternary nanocomposite Ag₂CO₃@Fe₂O₃/TiO₂-NT (AFT), compared with binary Fe₂O₃/TiO₂-NT (FTNT) and TiO₂ nanotube (TNT), showed remarkably enhanced performance for catalytic photodegradation of phenol compounds in the presence of solar irradiation. AFT nanocomposite performed high degradation efficiency (96.5%) and high degree of sustainability. The unique catalytic properties of the nanocomposite such as synergetic light absorption, efficient charge separation-transfer and resistance toward photocorrosion suggested three possible alternative mechanisms for transferring photogenerated electrons. Ag₂CO₃@Fe₂O₃/TiO₂-NT nanocomposite may have a potential application for the industrial treatment of wastewater containing toxic organic contamination.