Evaluation of experimental, analytical, and computational methods to determine long-bone bending stiffness

The Effects of Different Femoral Component Materials on Bone and Implant Response in Total Knee Arthroplasty: A Finite Element Analysis

Due to the high stiffness of the biomaterials used in total knee arthroplasty, stress shielding can lead to decreased periprosthetic bone mineral density and bone resorption. As different materials and 3D-printed highly porous surfaces are available for knee femoral components from the industry nowadays, this study aimed to compare the effects of two same-design cruciate-retaining femoral components, made with CoCr and titanium alloy, respectively, on periprosthetic bone stresses through a finite element model of the implanted knee in order to evaluate the induced stress shielding. Moreover, the effect of the cementless highly porous surface of the titanium implant was analyzed in comparison to the cemented interface of the CoCr implant. The von Mises stresses were analyzed in different periprosthetic regions of interest of the femur with different configurations and knee flexion angles. The titanium component induced higher bone stresses in comparison with the CoCr component, mostly in the medial compartment at higher knee flexion angles; therefore, the CoCr component led to more stress shielding. The model was revealed to be effective in describing the effects of different femoral component materials on bone stress, highlighting how a cementless, highly porous titanium femoral component might lead to less stress shielding in comparison to a cemented CoCr implant with significant clinical relevance and reduced bone resorption after total knee arthroplasty.

The normal stiffness of the edentulous alveolar process

The normal stiffness of the jawbone is seldom considered, as opposed to the mechanical properties of its individual cortical and trabecular components. Our standpoint is essentially structural, rather than purely material-oriented, as the jawbone is considered as a natural load-bearing structure. Throughout the work, 3 representative sections in the mandible and the maxilla are modelled and compared. Specifically, we evaluate the sections' elastic structural stiffness numerically, according to the recent geometrical classification proposed by Shemtov Yona (2021). Each case is modelled using two extreme configurations for the cortical-trabecular interaction, namely bonded and unbonded. Those two configurations reflect extreme interfacial conditions, though the bonded one is more physical. For the unbonded cases, the structural stiffness is the sum of the individual stiffnesses of the components. By sharp contrast, the bonded case results in a much larger stiffness than that obtained by the simple sum of the individual stiffnesses, indicating a strong synergistic stiffening effect between the components through their interface. We also investigate the role of the elastic moduli, whose reported values vary widely in the literature, emphasizing the role of the trabecular Poisson's coefficient, whose stiffening effect is evidenced when it exceeds about 0.3. The bone's structural stiffness shown here complements the geometrical classification of the jawbone types with a fundamental mechanical/structural property delineating the coupling between the mechanical properties and the geometry. The adopted approach is not limited to the jawbone and applies in principle to other bone types. From a clinical standpoint, the results presented here complement not only the basic mechanical aspects of the geometrical characterization, but also provide a starting point for future studies on dental implant placement and stability, the latter being directly related to the structural stiffness.