A novel naphthalimide-based probe for highly sensitive and selective recognition of fluoride ion

Bromine atom introduction improves the F- sensing ability of an indolo[3,2-b]carbazole-salicylaldehyde-based fluorescence turn-on sensor

The heavy-atom effect usually quenches fluorescence, but scarcely enhances it. Herein, fluorescence turn-on sensors without or with a bromine atom for F- detection are presented, achieving fast response time within 1 min, and the LODs of 1.9 × 10-7 and 8.5 × 10-8 M, reflecting that halogen atom introduction is beneficial for F- detection ability improvement. The sensing mechanism of -OH unit deprotonation is confirmed based on the results of a 1 : 2 stoichiometric ratio, 1H NMR titration and TD-DFT calculation. The water environment F- detection and spiked recovery experiments demonstrate their potential for real sample detection.

Manipulation of excited-state intramolecular proton transfer by electron-donor substitution for high performance fluoride ions sensing

Excited-state intramolecular proton transfer (ESIPT) molecules has been using as a variety of functionalityled molecular systems. To investigate the relationship between the electron-donor substitution and luminescent properties of ESIPT luminogens, four 2-(2-hydroxyphenyl) benzothiazole derivatives with donor-π-acceptor (D-π-A)-structured were synthesized. The distinct fluorescence properties of them were found to be highly dependent on the electron-donor moiety (triphenylamine and anthracenyl), its substituent position (para and meta position) and solvent polarity. The M-TPA, P-En, and M-En showed ESIPT emission in organic solvents, while the P-TPA showed intramolecular charge transfer process (ICT) emission. It is due to the synergistic effect of the aggregation-induced emission (AIE) and ESIPT, that M-TPA and M-En exhibited high solid-state quantum yields and large Stokes shifts. They were used as a probe for detecting F-, which resulted in rapid colorimetric, high sensitivity and good selectivity. The M-TPA was a turn-on fluorescent probe, which had the best detection property, and the limit of detection was as low as 11 nM. Because M-TPA displayed phenol anion emission in DMSO and F- causes the deprotonation of the M-TPA, which led to significant red shift of the absorption band and enhancement of fluorescence emission. This work provides a reliable strategy for designing high-performance fluorescent sensor via ESIPT manipulation.

Sensing mechanism of a fluorescent probe for thiophenols: Invalidity of excited-state intramolecular proton transfer mechanism

Simple and effective detection of thiophenols has attracted great attention. A fluorescent probe 1 with high selectivity and sensitivity is designed and synthesized based on the excited-state intramolecular proton transfer (ESIPT) in experiment. However, we conclude that the ESIPT process fails to happen actually based on the calculation results. In the present work, the density functional theory (DFT) and time-dependent density functional theory (TD-DFT) methods are employed to investigate the real sensing mechanism. The calculated absorption and emission spectra agree well with the experimental results. By comparing the energy of enol and keto configurations and the constructed potential energy surfaces (PESs) in the ground (S₀) and excited (S₁) states of 3-(benzo[d]thiazol-2-yl)-10-butyl-10H-phenothiazin-2-ol (dye 2), the ESIPT process is confirmed impossible because of the relatively high keto form energy and potential energy barrier. Besides, the transition state of dye 2 is optimized to offer the accurate potential energy barrier. The results of calculated frontier molecular orbitals (FMOs) and spectra indicate that it is the photoinduced electron transfer (PET) process that results in the fluorescence quenching of probe 1. After adding thiophenols, the thiolysis of 2,4-dinitrophenyl ether bond is triggered and dye 2, which emits strong fluorescence because of the absence of PET process, is obtained. Consequently, our study has demonstrated that probe 1 can act as a fluorescent probe to detect thiophenols through the off-on fluorescence variation based on the PET mechanism but not the ESIPT process.

Detection of toxic fluoride ion via chromogenic and fluorogenic sensing. A comprehensive review of the year 2015-2019

Fluoride ion (F^-) contamination can be accumulated along the water and the food chain and cause serious risk to public health. It is of the greatest importance that selects the suitable chromophores and fluorophores for the design and synthesis of outstanding selective, sensitive chromogenic and fluorogenic probes for detection of fluoride ion. In this review is mainly focused on the current progress of fluoride ion detection according to their receptors into several categories like anthracene, azo, benzothiazole, BODIPY, calixarene, coumarin, imidazole, diketopyrrolopyrrole, hydrazone, imidazole, naphthalene, naphthalimide, quantum dots, Schiff base and urea group sensing in the year 2015-2019.

Highly Sensitive Ratiometric Fluorescent Paper Sensors for the Detection of Fluoride Ions

Two sensitive and ratiometric fluorescent probes (probe I and probe II) were developed for the detection of fluoride ions. Probe I can detect fluoride ions quantitatively within a range of 0-6 μM and a detection limit of 73 nM, while probe II has a range of 0-40 μM and a detection limit of 138 nM. The test strips from probe I are quickly able to recognize F- (5 min) inside of the F- safety level in drinking water (1.0 mg/L, ∼5 μM) under 254 nm ultraviolet light, and the test strips from probe II quickly recognize F- (12 min) in dangerously high F- levels in water (4.0 mg/L, ∼21 μM) under 254 nm ultraviolet light. This combination of fluorescent paper sensors from probe I and probe II can be used as a simple and convenient tool to determine whether water is safe to drink or dangerous.