Insight into luminescent iridium complexes: Their potential in Light-Emitting Electrochemical Cells

Cationic Ir(III) Complexes with 4-Fluoro-4'-pyrazolyl-(1,1'-biphenyl)-2-carbonitrile as the Cyclometalating Ligand: Synthesis, Characterizations, and Application to Ultrahigh-Efficiency Light-Emitting Electrochemical Cells

Light-emitting electrochemical cells (LECs) promise low-cost, large-area luminescence applications with air-stabilized electrodes and a versatile fabrication that enables the use of solution processes. Nevertheless, the commercialization of LECs is still encountering many obstacles, such as low electroluminescence (EL) efficiencies of the ionic materials. In this paper, we propose five blue to yellow ionic Ir complexes possessing 4-fluoro-4'-pyrazolyl-(1,1'-biphenyl)-2-carbonitrile (ppfn) as a novel cyclometalating ligand and use them in LECs. In particular, the device within di[4-fluoro-4'-pyrazolyl-(1,1'-biphenyl)-2-carbonitrile]-4,4'-di-tert-butyl-2,2'-bipyridyl iridium(III) hexafluorophosphate (DTBP) shows a remarkable photoluminescence quantum yield (PLQY) of 70%, and by adjusting the emissive-layer thickness, the maximal external quantum efficiency (EQE) reaches 22.15% at 532 nm under the thickness of 0.51 μm, showing the state-of-the-art value for the reported blue-green LECs.

Hybrid nanospheres of silica covalently containing yellow-emitting cationic iridium(III) complex: preparation and application in white light-emitting diodes

A yellow-emitting cationic iridium(III) complex [(dfppy)2Ir(TBD)]PF6 (TBD: N4,N4'-bis(3-(triethoxysilyl)propyl)-[2,2'-bipyridine]-4,4'-dicarboxamide; dfppy: 2-(2,4-difluorophenyl)pyridine) containing hydrolysable alkoxysilanes was synthesized. Then, a series of silica-based hybrid nanospheres with diameters of around 400 nm was prepared via the hydrolysis of this complex together with tetraethyl orthosilicate (TEOS, a silica source). When the amount of the complex used was 5.0 wt%, hybrid nanospheres showed the best photoluminescence (PL) properties, relative to the PL quantum yield of pure solid [(dfppy)2Ir(TBD)]PF6 (12.7%), that of hybrid nanospheres increased to 26.2%. Moreover, the thermal decomposition temperature (Td) of pure solid [(dfppy)2Ir(TBD)]PF6 was 331 °C, the Td of the complex in hybrid nanospheres increased to 447 °C. However, the yellow light emission was almost unchanged and was still located at 500-750 nm with a maximum wavelength (λem,max) of 577 nm. Under the excitation of blue-emitting chips (λem,max ≈ 455 nm), cold/neutral/warm white light-emitting diodes (WLEDs) with good luminous quality can all be fabricated using these hybrid nanospheres as phosphors in epoxy resin at different blending concentrations. Compared with two or three iridium(III) complexes being contained in silica-based particles as phosphors as described in literatures, in this study, silica-based hybrid nanospheres covalently containing only one yellow-emitting cationic iridium(III) complex as phosphors provide a more effective and simpler method for preparation high-performance WLEDs.

Deep-blue light-emitting cationic iridium(III) complexes featuring diamine ancillary ligands: Experimental and theoretical investigations

Deep-blue emitters based on combining two approaches are reported here. In the first approach, the nitrogen content of the cyclometallated ligand is increased using 2,4'-bpy ligands, leading to a low highest occupied molecular orbital energy. In the second approach, 2,2'-bpy is replaced with a lower electron donating ligand, leading to a high lowest unoccupied molecular orbital (LUMO) energy. Thus, three new ionic transition metal complexes of [Ir(2,4'-bpy)2(NN)]PF6 [where NN is 2,2'-bpy (1), o-phenylenediamine (2), and 4-methoxy-o-phenylenediamine (3)] were synthesized, and their electronic and photophysical features were studied. In solution, [Ir(2,4'-bpy)2bpy]PF6 emits blue light centered at 396 nm, which is blue-shifted compared to [Ir(ppy)2bpy]PF6. The low electron donation of the diamine ancillary ligands introduces the contribution of the cyclometallated ligand to the LUMO, changing the nature of the emission and leading to different photophysical features. Density functional theory calculations indicate the long bond distances of Ir-Ns at the diamine ligands, suggesting weak metal-ligand interactions and low quantum yields.1.

Synthesis and Characterization of Iridium(III) Complexes with Substituted Phenylimidazo(4,5-f)1,10-phenanthroline Ancillary Ligands and Their Application in LEC Devices

In this work, we report on the synthesis and characterization of six new iridium(III) complexes of the type [Ir(C^N)2(N^N)]+ using 2-phenylpyridine (C1-3) and its fluorinated derivative (C4-6) as cyclometalating ligands (C^N) and R-phenylimidazo(4,5-f)1,10-phenanthroline (R = H, CH3, F) as the ancillary ligand (N^N). These luminescent complexes have been fully characterized through optical and electrochemical studies. In solution, the C4-6 series exhibits quantum yields (Ф) twice as high as the C1-3 series, exceeding 60% in dichloromethane and where 3MLCT/3LLCT and 3LC emissions participate in the phenomenon. These complexes were employed in the active layer of light-emitting electrochemical cells (LECs). Device performance of maximum luminance values of up to 21.7 Lx at 14.7 V were observed for the C2 complex and long lifetimes for the C1-3 series. These values are counterintuitive to the quantum yields observed in solution. Thus, we established that the rigidity of the system and the structure of the solid matrix dramatically affect the electronic properties of the complex. This research contributes to understanding the effects of the modifications in the ancillary and cyclometalating ligands, the photophysics of the complexes, and their performance in LEC devices.

Mononuclear copper(I) complexes bearing a 3-phenyl-5-(pyridin-4-yl)-1,2,4-triazole ligand: synthesis, crystal structure, TADF-luminescence, and mechanochromic effects

Three new mononuclear heteroleptic copper(I) halide complexes, [CuL(PPh3)2X] (X = Cl, Br, I), based on 3-phenyl-5-(pyridin-4-yl)-1,2,4-triazole (L) and triphenylphosphine (PPh3) ligands, have been prepared by reaction of CuX (X = Cl, Br, I), L and PPh3 in a molar ratio of 1 : 1 : 2 in MeCN solutions. The synthesized complexes exhibit blue light emission in solutions and bright green emission in the crystal state with quantum yields of up to 100%. The luminescence decay analysis and density functional theory calculations revealed that the emission of solid samples at room temperature corresponds to the thermally activated delayed fluorescence, while that at 77 K is assigned to phosphorescence. Utilizing the studied complexes in OLED heterostructures resulted in high-performing green-emitting devices with an external quantum efficiency of up to 13.4%.

Enhanced stability and complex phase behaviour of organic-inorganic green-emitting ionic manganese halides

Light-emitting materials based on earth-abundant metals, such as manganese hold great promise as emitters for organic lighting devices. In order to apply such emitter materials and, in particular, to overcome the problem of self-quenching due to cross-relaxation, we investigated a series of tetrabromidomanganate ([MnBr₄]^2-) salts with bulky tetraalkylphosphonium counter cations [P_nnn]⁺, namely [P_nnnn]₂[MnBr₄] (n = 4 (1), 6 (2) and 8 (3)), which can be obtained by a straightforward reaction of the respective phosphonium bromide and MnBr₂. Variation of the cation size allows control of the properties of the resulting ionic materials. 1 and 3 qualify as ionic liquids (ILs), where 1 features a melting point of 68 °C, and 3 is liquid at room temperature and even at very low temperatures. Furthermore, 1 and 2 show the formation of higher-ordered thermotropic mesophases. For 1 a transition to a thermodynamically metastable smectic liquid crystalline phase can be observed at room temperature upon reheating from the metastable glassy state; 2 appears to form a plastic crystalline phase at ∼63 °C, which persists up to the melting point of 235 °C. The photoemission is greatly affected by phase behaviour and ion dynamics. A photoluminescence quantum yield of 61% could be achieved, by balancing the increase in Mn²⁺-Mn²⁺ separation and reducing self-quenching through increasingly large organic cations which leads to adverse increased vibrational quenching. Compared to analogous ammonium compounds, which have been promoted as ̈inorganic hybrid perovskites̈, the phosphonium salts show superior performance, with respect to photoluminescent quantum yield and thermal and air/humidity stability. As the presented compounds are not sensitive to the atmosphere, in particular moisture, and show strong visible electroluminescence in the green region of light, they are important emitter materials for use in organic light-emitting devices.

Phenanthroimidazole as molecularly engineered switch for efficient and highly long-lived light-emitting electrochemical cell

Light-emitting electrochemical cells (LECs) based on Ir(III) complexes owing to the superior advantages exhibit high potential for display and lighting applications. Herein, a series of Ir(III) complexes based on phenanthroimidazole (PI) as an ancillary ligand were synthesized to achieve efficient and highly stable yellow-to-orange LEC devices with fast response. These complexes exhibit appropriate electrochemical stability and significant suppression of concentration quenching in the thin films compared to the archetype complex. The fabricated LECs showed remarkably long device lifetimes over 1400 and 2100 h and external quantum efficiency of 2 and 3% for yellow and orange-LECs, respectively. The obtained t1/2 for yellow LEC is much higher than archetype [Ir(ppy)2(phen)]+ and their phenanthroline-based analogues reported so far. The incorporation of an ionic tethered functional group on PI, improved the mobility of the emissive layer and reduced the device turn-on time by 75-88%. This study shows a facile functionalization and characterization of the PI ligand as well as its potential application in optoelectronic devices (OLED).