Appropriate timing of blood sampling for blood gas analysis in the ventilated rabbit

Real-time fetal monitoring using photoacoustic measurement of placental oxygen saturation in a rabbit hypoxia model

INTRODUCTION

Ensuring adequate fetal oxygenation is an essential aim of fetal monitoring. The purpose of this study was to establish a basic technique for real-time measurement of blood oxygen saturation of the placenta by photoacoustic (PA) technique as a new fetal monitoring method.

METHODS

The hypoxia model established in our previous study was applied to 7 pregnant rabbits. Three phases were induced: normal phase, hypoxia phase, and recovery phase. Three methods were simultaneously used for real-time fetal monitoring: fetal heat rate (FHR) monitoring, oxygen saturation (SO2) measurement by near-infrared spectroscopy (SNO2), and placenta SO2 measured by PA technique (SplO2). The maternal hypoxia was assessed by skin SO2 measured by PA technique (SsO2), and arterial blood SO2 by blood gas analysis (SaO2).

RESULTS

The average of SplO2 in normal phase was 52.6 ± 13.9 %. The averages of SNO2, SSO2, and SplO2 in the seven rabbits changed in parallel from the normal phase to hypoxia phase. In the recovery phase, the SplO2 rose in parallel with recovery of SaO2. There was lag in increase of the FHR compared to the change in the other values. In the detailed analysis of PA signals from the labyrinth and decidua, a unique change in oxygen saturation was seen in one case.

DISCUSSION

Results of this study showed that sensitivity of our novel PA technique in detecting tissue hypoxia was similar to near-infrared spectroscopy (NIRS). As an advantage, unlike NIRS, monitoring with PA technique was unaffected by ischemia and surface changes in oxygen saturation because of its higher spatial resolution. We conclude that PA technique provides more accurate information about fetal blood placenta than NIRS. Ultrasound imaging, combined with oxygen saturation monitoring by PA technique, would improve fetal monitoring and fetal diagnosis in the future.

Prevention of LPS-induced acute respiratory distress syndrome in sheep by bone marrow-derived mesenchymal stem/stromal cells

MATERIALS AND METHODS

In this study, 10 male Shall sheep were used in two groups and bone marrow samples were collected and BM-MSCs isolated. Then experimental model of ARDS was induced by intrapulmonary injection of LPS to dose of 400 μg/kg. Twenty-four hours after LPS injection, 5 × 10⁷ cells of BM-MSCs were autologous transferred in the group of treatment and 1 ml PBS was infused in the group of control as intrapulmonary. Then, the symptoms of clinical, complete blood count, analysis of arterial blood gases and the concentrations of IL6,IL10,TNF-α,total protein, Ig M and albumin BAL were determined before and at times of 3,6,12,24,48,72, and 168 after transplantation/infusion.

KEY FINDINGS

The results of the investigations 24 h post-LPS injection(time 0) indicated the occurrence of acute inflammation which confirmed ARDS model. These changes included increase in RR, HR and RT, decrease in PO2 and SatO2 and increase in PCO2, WBC, neutrophils, macrophages, total protein,IL6,IL10, TNF-α,Ig M and albumin. But the stem/stromal cells transplantation reduced the severity of clinical signs induced by LPS, caused significant increase in PO₂, SatO₂ and IL-10 and significant decrease in PCO₂, the total protein, TNF-α,IL-6, Ig M, albumin, WBCs, neutrophils and macrophages at different times of sampling both in compared with before transplantation(time 0) and in compared with the group of control. While in the control group, inflammation continued until the end of the study.

SIGNIFICANCE

These results showed that BM-MSCs are able to reduce inflammation and have an important role in reconstruction of the damaged lung.

Mesenchymal stem/stromal cells: the therapeutic effects in animal models of acute pulmonary diseases

The pulmonary diseases are one of the most important causes of death in the world. The successful therapies in the field of lung diseases are very limited and the medical treatments available are ineffective in many of the lung diseases. Many studies have evaluated the new therapies in the acute pulmonary diseases, and the transplantation of mesenchymal stem/stromal cells (MSCs), which is a branch of cell therapy, has a special place among the new medical techniques. The MSCs are present throughout the body and are thought to play a role in tissue regeneration and inflammation control. In the event of injury, the local MSCs traverse the shortest possible distance from the tissue or blood vessels to reach the affected site. But, there are few undifferentiated cells in the tissues. The exogenous MSCs are used to immunity modify or regenerative treatments in preclinical models of acute pulmonary diseases. Several studies have shown the positive effects of MSCs replacement in the acute lung disorders. The effection mechanism of the MSCs include the differentiation ability and the secretion of paracrine agents such as the anti-inflammatory mediators. Many studies suggest that this treatment method is safe and is probably to be widely used in future clinical trials. This review will describe the therapeutic effects of the MSCs in the experimental models of the acute pulmonary diseases for use as a method of treatment in clinical trials in future.

Measurement of blood-oxygen saturation using a photoacoustic technique in the rabbit hypoxemia model

The golden standard method to obtain accurate blood oxygen saturation is blood gas analysis that needs invasive procedure of blood sampling. Photoacoustic technique enables us to measure real-time blood oxygen saturation without invasive procedure. The aim of this study is to use the photoacoustic technique, an optical method, for accurately determining oxygen saturation in vivo. We measured induced photoacoustic signals of arterial blood in the rabbit model of stable hypoxemia after irradiation at 750 and 800 nm. Oxygen saturation was calculated from the photoacoustic signals using two calibration curves. Calibration curve 1 is a conventional curve derived from the absorbance coefficient of hemoglobin, whereas calibration curve 2 is derived from the photoacoustic signals obtained from the original blood vessel model. Simultaneously, blood-gas analysis was performed to obtain the reference standard of oxygen saturation. Regression analysis and Bland-Altman analysis were performed to assess the accuracy of oxygen saturation obtained using the two methods. The oxygen saturation calculated using calibration curves 1 and 2 showed strong correlations with the reference standard in regression analysis (R = 0.965, 0.964, respectively). The Bland-Altman analysis revealed better agreement and precision with calibration curve 2, whereas there was significant underestimation of values obtained using calibration curve 1. Photoacoustic measurement of oxygen saturation using calibration curve 2 provided an accurate estimate of oxygen saturation, which was similar to that obtained using a portable blood-gas analyzer.