Cyclic loading moves the peak stress to the cartilage surface in a biphasic model with isotropic solid phase properties

Stress distribution and consolidation in cartilage constituents is influenced by cyclic loading and osteoarthritic degeneration

The understanding of load support mechanisms in cartilage has evolved with computational models that better mimic the tissue ultrastructure. Fibril-reinforced poroelastic models can reproduce cartilage behaviour in a variety of test conditions and can be used to model tissue anisotropy as well as assess stress and pressure partitioning to the tissue constituents. The goal of this study was to examine the stress distribution in the fibrillar and non-fibrillar solid phase and pressure in the fluid phase of cartilage in axisymmetric models of a healthy and osteoarthritic hip joint. Material properties, based on values from the literature, were assigned to the fibrillar and poroelastic components of cartilage and cancellous and subchondral compact bone regions. A cyclic load representing walking was applied for 25 cycles. Contact stresses in the fibrillar and non-fibrillar solid phase supported less than 1% of the contact force and increased only minimally with load cycles. Simulated proteoglycan depletion increased stresses in the radial and tangential collagen fibrils, whereas fibrillation of the tangential fibrils resulted in increased compressive stress in the non-fibrillar component and tensile stress in the radial fibrils. However neither had an effect on fluid pressure. Subchondral sclerosis was found to have the largest effect, resulting in increased fluid pressure, non-fibrillar compressive stress, tangential fibril stress and greater cartilage consolidation. Subchondral bone stiffening may play an important role in the degenerative cascade and may adversely affect tissue repair and regeneration treatments.

Recent advances in computational mechanics of the human knee joint

Computational mechanics has been advanced in every area of orthopedic biomechanics. The objective of this paper is to provide a general review of the computational models used in the analysis of the mechanical function of the knee joint in different loading and pathological conditions. Major review articles published in related areas are summarized first. The constitutive models for soft tissues of the knee are briefly discussed to facilitate understanding the joint modeling. A detailed review of the tibiofemoral joint models is presented thereafter. The geometry reconstruction procedures as well as some critical issues in finite element modeling are also discussed. Computational modeling can be a reliable and effective method for the study of mechanical behavior of the knee joint, if the model is constructed correctly. Single-phase material models have been used to predict the instantaneous load response for the healthy knees and repaired joints, such as total and partial meniscectomies, ACL and PCL reconstructions, and joint replacements. Recently, poromechanical models accounting for fluid pressurization in soft tissues have been proposed to study the viscoelastic response of the healthy and impaired knee joints. While the constitutive modeling has been considerably advanced at the tissue level, many challenges still exist in applying a good material model to three-dimensional joint simulations. A complete model validation at the joint level seems impossible presently, because only simple data can be obtained experimentally. Therefore, model validation may be concentrated on the constitutive laws using multiple mechanical tests of the tissues. Extensive model verifications at the joint level are still crucial for the accuracy of the modeling.