Design of anion species/strength responsive membranes via in-situ cross-linked copolymerization of ionic liquids

Nitrogen Self-Doping Carbon Derived from Functionalized Poly(Vinylidene Fluoride) (PVDF) for Supercapacitor and Adsorption Application

A new synthetic strategy has been developed for the facile fabrication of a N-doped porous carbon (NC-800) material via a facile carbonization of functionalized poly(vinylidene fluoride) (PVDF). The prepared NC-800 exhibits good specific capacitance of 205 F/g at 1 A/g and cycle stability (95.2% retention after 5000 cycles at 1 A/g). The adsorption capacity of NC-800 on methylene blue and methyl orange was 780 mg/g and 800 mg/g, respectively. The facile and economical method and good performance (supercapacitor and adsorption) suggest that the NC-800 is a promising material for energy storage and adsorption.

Dependable Performance of Thin Film Composite Nanofiltration Membrane Tailored by Capsaicin-Derived Self-Polymer

To address trade-off and membrane-fouling challenges during the development of nanofiltration membranes, a thin-film composite membrane was prepared on the basis of interfacial polymerization regulated by adjusting the capsaicin-derived self-polymer poly N-(2-hydroxy-5-(methylthio) benzyl) acrylamide (PHMTBA) on the polysulfone substrate in this study. Through the self-polymerization of the monomer HMTBA with varied contents, microwave-assisted technology was employed to develop a variety of PHMTBAs. It was discovered that PHMTBA is involved in the interfacial polymerization process. Piperazine and PHMTBA competed for the reaction with trimesoyl chloride, resulting in a flatter and looser membrane surface. The PHMTBA-modified membrane presented a typical double-layer structure: a thicker support layer and a thinner active layer. The addition of PHMTBA to membranes improved their hydrophilicity and negative charge density. As a result, the PHMTBA-modified membrane showed dependable separation performance (water flux of 159.5 L m⁻² h⁻¹ and rejection of 99.02% for Na₂SO₄) as well as enhanced anti-fouling properties (flux recovery ratio of more than 100% with bovine serum albumin-fouling and antibacterial efficiency of 93.7% against Escherichia coli). The performance of the prepared membranes was superior to that of most other modified TFC NF membranes previously reported in the literature. This work presents the application potential of capsaicin derivatives in water treatment and desalination processes.

Planning of smart gating membranes for water treatment

The use of membranes in desalination and water treatment has been intensively studied in recent years. The conventional membranes however have various problems such as uncontrollable pore size and membrane properties, which prevents membranes from quickly responding to alteration of operating and environmental conditions. As a result the membranes are fouled, and their separation performance is lowered. The preparation of smart gating membranes inspired by cell membranes is a new method to face these challenges. Introducing stimuli-responsive functional materials into traditional porous membranes and use of hydrogels and microgels can change surface properties and membrane pore sizes under different conditions. This review shows potential of smart gating membranes in water treatment. Various types of stimuli-response such as those of thermo-, pH-, ion-, molecule-, UV light-, magnetic-, redox- and electro-responsive gating membranes along with various gel types such as those of polyelectrolyte, PNIPAM-based, self-healing hydrogels and microgel based-smart gating membranes are discussed. Design strategies, separation mechanisms and challenges in fabrication of smart gating membranes in water treatment are also presented. It is demonstrated that experimental and modeling and simulation results have to be utilized effectively to produce smart gating membranes.

Intelligent antibacterial surface based on ionic liquid molecular brushes for bacterial killing and release

The prevention of bacteria-induced infections has been increasing in importance in both clinical surgery and biomedical engineering. Although great attention has been paid to designing intelligent antibacterial surfaces, the fabrication processes are still not facile and universal enough, and the antibacterial efficiencies of these surfaces are also not ideal. Herein, ionic liquid (IL) molecules of 3-(12-mercaptododecyl)-1-methyl-1H-imidazol-3-ium bromide (IL(Br)) were synthesized with the minimum inhibitory concentrations as low as 4 and 8 μg mL-1 against Staphylococcus aureus (S. aureus) and Escherichia coli (E. coli), respectively. By simply immersing a polymeric substrate into the IL(Br) solution, an antibacterial surface with high killing efficiency of 99% against S. aureus (94% against E. coli) was achieved via a mussel-inspired approach. Subsequently, 97% S. aureus and 95% E. coli on the substrate could be released by simple ion-exchange of Br- with (CF3SO2)2N- due to the ion sensitivity of the IL molecular brushes. Thus, the proposed facile strategy towards a superior efficiency surface could be potentially used in intelligent antibacterial fields.

Multifunctional negatively-charged poly (ether sulfone) nanofibrous membrane for water remediation

Multifunctional materials, which can effectively and simultaneously remove various water-soluble contaminants like dyes and heavy metal ions, and separate oil from water, are urgent to meet increasing challenges on wastewater remediation. Herein, a cross-linked poly (acrylic acid) (PAA) modified poly (ether sulfone) nanofibrous membrane (NFM) was fabricated by a facile in-situ pre-reaction followed by electrospinning. The as-prepared NFM showed excellent hydrophilicity and underwater lipophobicity, therefore expressed excellent water permeability with high water flux (about 5142 L m² h^-1). As a result, under solely driven by gravity, the NFM was capable to separate emulsified oil/water emulsion and a wide range of oil/water mixtures. Moreover, repeating separation tests indicated that the NFM had great long-term sustainability even after ten separation cycles. In addition, due to the introduction of PAA and the large surface-to-volume ratio, the NFM also expressed rapid adsorption capacity for cationic dyes as well as heavy metal ions; thus could simultaneously remove these contaminants during the oil/water separation process. Furthermore, the NFM could be also decorated by Ag NPs to endow the membranes with remarkable antibacterial ability against both E. coli and S. aureus. Our findings strongly suggested that the multifunctional NFM may have great potential in treating complicated wastewater.

Design of Robust Thermal and Anion Dual-Responsive Membranes with Switchable Response Temperature

In this study, poly(ionic liquids/ N-isopropylacrylamide) (PIL/NIPAM) modified poly(ether sulfone) microporous membranes were prepared using a pore-filling method. Due to the anion-sensitive wettability of the PIL and the thermal-sensitive phase transformation of PNIPAM, the permeability of the modified membranes showed robust anion and thermal dual-responsive behaviors. In addition, the response temperature of the membranes could be adjusted precisely from 30 to 55 °C by anion exchange, which was attributed to the cooperative interaction of the PIL and PNIPAM. The switchable response temperature and the dual-responsive performances of the membranes were demonstrated by measuring the water fluxes under various conditions. The results indicated that the membrane permeabilities increased when exchanging the counteranions (CAs) from hydrophilic to hydrophobic ones; the thermal response behaviors were also obvious, and the sensitivity increased when increasing the hydrophobicity of the CA (the fluxes could be adjusted from 0 to 3800 mL/m² mmHgh by controlling the temperature and CAs). At last, filtration tests were designed with the membranes, and the results indicated that by controlling the temperature and/or CA species, three different poly(ethylene glycol) molecules could be easily separated according to their molecule sizes in a single step.

Anion-Responsive Poly(ionic liquid)s Gating Membranes with Tunable Hydrodynamic Permeability

Novel anion-responsive "intelligent" membranes with functional gates are fabricated by filling polyethersulfone microporous membranes with poly(ionic liquid)s (PILs) gels. The wetting properties of the PILs could be controlled by changing their counteranions (CAs), and thus, the filled PILs gel gates in the membrane pores could spontaneously switch from the "closed" state to the "open" one by recognizing the hydrophilic CAs in the environment and vice versa. As a result, the fluxes of the "intelligent" membranes could be tuned from a very low level (0 mL/m²·mmHg for Cl^-, Br^-, and BF₄^-) to a relatively high one (430 mL/m²·mmHg for TFSI). The anion-responsive gating behavior of the PILs filled membranes is fast, reversible, and reproducible. In addition, the "intelligent" membranes are sensitive to contact time and ion concentrations of the hydrophobic CA species. The proposed anion-responsive "intelligent" membranes are highly attractive for ion-recognizable chemical/biomedical separations and purifications.

Novel Slightly Reduced Graphene Oxide Based Proton Exchange Membrane with Constructed Long-Range Ionic Nanochannels via Self-Assembling of Nafion

A facile method to prepare high-performance Nafion slightly reduced graphene oxide membranes (N-srGOMs) via vacuum filtration is proposed. The long-range connected ionic nanochannels in the membrane are constructed via the concentration-dependent self-assembling of the amphiphilic Nafion and the hydrophilic-hydrophobic interaction between graphene oxide (GO) and Nafion in water. The obtained N-srGOM possesses high proton conductivity, and low methanol permeability benefitted from the constructed unique interior structures. The proton conductivity of N-srGOM reaches as high as 0.58 S cm^-1 at 80 °C and 95%RH, which is near 4-fold of the commercialized Nafion 117 membrane under the same condition. The methanol permeability of N-srGOM is 2.0 × 10^-9 cm² s^-1, two-magnitude lower than that of Nafion 117. This novel membrane fabrication strategy has proved to be highly efficient in overcoming the "trade-off" effect between proton conductivity and methanol resistance and displays great potential in DMFC application.