Validation and optimization of a membrane system for carbon dioxide removal in anesthesia circuits under realistic patient scenarios

Modification strategies to improve the membrane hemocompatibility in extracorporeal membrane oxygenator (ECMO)

ABSTRACT

Since extracorporeal membrane oxygenator (ECMO) has been utilized to save countless lives by providing continuous extracorporeal breathing and circulation to patients with severe cardiopulmonary failure. In particular, it has played an important role during the COVID-19 epidemic. One of the important composites of ECMO is membrane oxygenator, and the core composite of the membrane oxygenator is hollow fiber membrane, which is not only a place for blood oxygenation, but also is a barrier between the blood and gas side. However, the formation of blood clots in the oxygenator is a key problem in the using process. According to the study of the mechanism of thrombosis generation, it was found that improving the hemocompatibility is an efficient approach to reduce thrombus formation by modifying the surface of materials. In this review, the corresponding modification methods (surface property regulation, anticoagulant grafting, and bio-interface design) of hollow fiber membranes in ECMO are classified and discussed, and then, the research status and development prospects are summarized.

Recovery of Sevoflurane Anesthetic Gas Using an Organosilica Membrane in Conjunction with a Scavenging System

Approximately 95% of the anesthetic gas administered to a patient is exhaled and ultimately released into the atmosphere. Most anesthetic gases have high global warming potential and so this approach adds significantly to the global greenhouse gas footprint. In this work, we develop a feasible means to capture such an anesthetic gas (sevoflurane) before it is released to the hospital scavenging system so that it is retained within the anesthetic circuit. Sevoflurane is retained using a microporous 1,2-bis(triethoxysilyl)ethane (BTESE) membrane prepared by a sol-gel method. The use of a ceramic membrane facilitates sanitization at high temperatures. A rapid thermal processing (RTP) technique is employed to reduce production time and to create a looser organosilica network, resulting in higher gas permeances, compared with the membrane synthesized from conventional thermal processing. The RTP membrane shows a slight decline in gas permeance when used with a dry mixture of CO₂/N₂/sevoflurane. This permeance falls again under 20% relative humidity feed conditions but the CO₂/sevoflurane selectivity increases. The membrane performance shows little variation when the relative humidity is further increased. These promising results demonstrate that this microporous BTESE membrane has great potential for the recovery of sevoflurane in an anesthetic application.