Application of solidification of floating organic drop microextraction for inorganic anions: Determination of phosphate in water samples

Preconcentration of phosphate ions on graphene oxide decorated with lanthanum oxide from waters followed by energy dispersive X-ray fluorescence spectrometric determination

A method for energy dispersive X-ray fluorescence spectrometric (EDXRF) determination of phosphate ions via the PKα line in diverse types of water samples is described. The method is based on ultrasonically assisted dispersive micro-solid phase extraction (USA-DMSPE) using lanthanum oxide supported on graphene oxide (La2O3-GO) as a solid adsorbent. Under optimal preconcentration conditions, i.e. sample pH = 5, sample volume 50 mL, adsorbent dose 0.8 mg, sonication time 30 min, a linear response was obtained between the phosphate concentration and the measured analytical signal in the range of 2-300 ng mL-1 with a correlation coefficient of 0.9995. The developed procedure is characterized by good detection and quantification limits of 0.4 and 1.32 ng mL-1. The inter-day and infra-day precision of the method tested at analyte ion concentrations of 5, 50, and 200 ng mL-1 ranges from 1.1 to 4.4% and 1.2-4.7%, respectively. The accuracy of the method was verified by the standard addition method and the inductively coupled plasma atomic emission spectrometry (ICP-OES) comparative technique. The method was implemented for the analysis of various water samples, including artificial seawater. The phosphate content in studied water samples ranges from 23.8 to 121 ng mL-1. Recoveries in samples enriched with phosphates with a known concentration of 94-102%, as well as a relative difference of 1.5-3.8% between results obtained by USA-DMSPE/EDXRF and ICP-OES indicate the usefulness of the method for the quantitative determination of phosphate ions in natural waters. Moreover, the mechanism of chemisorption in the tested system was discussed and the maximum adsorption capacity of La2O3-GO towards phosphate ions (90.1 mg g-1) was determined.

Current development of bioanalytical sample preparation techniques in pharmaceuticals

Sample preparation is considered as the bottleneck step in bioanalysis because each biological matrix has its own unique challenges and complexity. Competent sample preparation to extract the desired analytes and remove redundant components is a crucial step in each bioanalytical approach. The matrix effect is a key hurdle in bioanalytical sample preparation, which has gained extensive consideration. Novel sample preparation techniques have advantages over classical techniques in terms of accuracy, automation, ease of sample preparation, storage, and shipment and have become increasingly popular over the past decade. Our objective is to provide a broad outline of current developments in various bioanalytical sample preparation techniques in chromatographic and spectroscopic examinations. In addition, how these techniques have gained considerable attention over the past decade in bioanalytical research is mentioned with preferred examples. Modern trends in bioanalytical sample preparation techniques, including sorbent-based microextraction techniques, are primarily emphasized.

•

Bioanalytical sampling techniques are described with suitable applications in pharmaceuticals.

•

The pros and cons of each bioanalytical sampling techniques are described.

•

Relevant biological matrices are outlined.

Colorimetric determination of trace orthophosphate in water by using C18-functionalized silica coated magnetite

In this study, we customized magnetic sorbents by functionalizing silica coated magnetite with octadecyl(C₁₈)silane (Fe₃O₄@SiO₂@C₁₈). This sorbent was intended for the determination of trace orthophosphate (o-PO₄³⁻) in unpolluted freshwater samples. The o-PO₄³⁻ was transformed to phosphomolybdenum blue (PMB), a known polyoxometalate ion. Then the PMB were coupled with cetyl trimethyl ammonium bromide (CTAB), cationic surfactant, in order to hydrophobically bound with the Fe₃O₄@SiO₂@C₁₈ particles through dispersive magnetic solid-phase extraction (d-MSPE) as part of sample preconcentration. The PMB–CTAB–magnetic particles are simply separated from the aqueous solution by the external magnet. The acidified ethanol 0.5 mL was used as PMB-CTAB eluent to produce an intense blue solution, which the absorbance was measured using a UV–Vis spectrophotometer at 800 nm. The proposed method (employing 2 mg of Fe₃O₄@SiO₂@C₁₈) yielded an enhancement factor of 32 with a linear range of 1.0–30.0 µg P L⁻¹. Precision at 6.0 µg P L⁻¹ and 25.0 µg P L⁻¹ were 3.70 and 2.49% (RSD, n = 6) respectively. The lower detection limit of 0.3 µg P L⁻¹ and quantification limit of 1.0 µg P L⁻¹ allowed trace levels analysis of o-PO₄³⁻ in samples. The reliability and accuracy of the proposed method were confirmed by using a certified reference material. Our method offers highly sensitive detection of o-PO₄³⁻ with simple procedures that can be operated at room temperature and short analysis time.

Micelle-based restricted access ion-pair microextraction of phosphate at trace levels in water samples for separation, preconcentration and determination

A new and simple micelles-rich restricted access supramolecular solvent-based liquid phase microextraction method (RASUPRASs-LPME) based on the ion-pair complex formation of phosphate (PO4 3-) ions with ammonium heptamolybdate and malachite green in acidic medium was developed. The phosphate ion concentration after microextraction of the ion-pair complex to the hexagonal aggregates of decanoic acid (DA) was measured with micro-volume UV-Vis spectrophotometer at 625 nm. All analytical parameters which are effective on the method such as acid type and concentration, supramolecular solvent volume, amount of the components forming the complex, sample volume, were optimized. The preconcentration factor (PF), limit of detection (LOD) and limit of quantification (LOQ) for the developed method was found to be 15, 9.6 and 32.1, respectively. The RA-SUPRAs-LPME method was finally applied for the analysis of the phosphate content of different types of water samples.

Fast room temperature cloud point extraction procedure for spectrophotometric determination of phosphate in water samples

A novel fast room temperature cloud point extraction (RT-CPE) procedure for preconcentration and spectrophotometric determination of phosphate based on the heteropoly blue formation was developed. The proposed method includes the formation of yellow molybdoantymonatophosphoric heteropoly complex, its extraction into Triton X-100 micellar phase obtained at room temperature and reduction of heteropoly complex by ascorbic acid solution in ethanol and absorbance measurement of heteropoly blue at 790 nm. Under optimal conditions (1% (v/v) of Triton X-100 and 0.05 M of ammonium benzoate for initiating of RT-CPE; 0.13 M ethanolic solution of ascorbic acid for reduction of heteropoly complex and dilution of surfactant rich phase), the calibration graph is linear in the range of phosphate concentrations of 1.58-63 μg L^-1. The proposed RT-CPE procedure has been successfully applied to preconcentration phosphates and its spectrophotometric determination in water samples.

The alternative use of layered double hydroxides as extraction medium coupled with microcomplexation for determination of phosphate in water samples

A simple, rapid, in situ, and green extraction combined with a microcomplexation has been developed for the spectrophotometric determination of phosphate in water samples. Through their formation, layered double hydroxides (LDHs) were employed as the extraction medium, instantly commenced by a rapid addition of a mixed solution of Mg²⁺ and Al³⁺ ions into alkaline phosphate solution. After the extraction, LDH precipitate containing phosphate was dissolved by sulfuric acid and the released phosphate was subsequently detected via its complexation with molybdate in the presence of antimonyl and ascorbic acid. Under optimum conditions, the linearity in the range of 5-200μgL^-1, with the correlation coefficient (r²) of 0.9969, and the enrichment factor (EF) of 14 were obtained. The limit of detection (LOD) of 5μgL^-1 and good precision, with the relative standard deviations (RSDs) less than 8.16%, were achieved. The proposed method was successfully applied to determine phosphate in water samples and the relative recoveries of 72.97-115.32% were obtained.

Europium-based infinite coordination polymer nanospheres as an effective fluorescence probe for phosphate sensing

Uniform europium-based infinite coordination polymer nanospheres have been successfully fabricated as an effective fluorescence probe for phosphate sensing.

Devising new lipid-coated calcium phosphate/carbonate hybrid nanoparticles for controlled release in endosomes for efficient gene delivery

New hybrid nanoparticles can efficiently deliver dsDNA/siRNA to cancer cells, with the gene release precisely controlled in the endosomal pH range.

Effervescence-assisted dispersive liquid–liquid microextraction based on the solidification of a floating ionic liquid with a special collection method for the rapid determination of benzoylurea insecticides in water samples

Dispersion liquid–liquid microextraction based on the solidification of a floating ionic liquid.