The controlled oxidation of kraft lignin in mild conditions using ionic liquid as a crucial point in fabrication of antibacterial hybrid materials

Boosting photo-induced antimicrobial activity of lignin nanoparticles with curcumin and zinc oxide

Lignin nanoparticles have gained increasing attention as a potential antimicrobial agent due to their biocompatibility, biodegradability, and low toxicity. However, the limited ability of lignin to act as an antibacterial is a major barrier to its widespread use. Thus, it is crucial to develop novel approaches to amplify lignin's biological capabilities in order to promote its effective utilization. In this study, we modified lignin nanoparticles (LNPs) with photo-active curcumin (Cur), zinc oxide (ZnO), or a combination of both to enhance their antimicrobial properties. The successful modifications of LNPs were confirmed using comprehensive characterization techniques. The antimicrobial efficacy of the modified LNPs was assessed against both gram-positive and gram-negative bacterial strains. The results showed that the modification of LNPs with Cur and ZnO have much higher antibacterial and antibiofilm activities than unmodified LNPs. Moreover, photo illumination resulted in even higher antibacterial activity. Furthermore, atomic force microscopy revealed bacterial cells lysis and membrane damage by ZnO/Cur modified LNPs. Our research demonstrates that ZnO/Cur modified LNPs can serve as novel hybrid materials with enhanced antimicrobial capabilities. In addition, the photo-induced enhancement in antibacterial activity not only demonstrated the versatility of this hybrid material but also opened up interesting potential for bioinspired therapeutics agents.

Switchable Deep Eutectic Solvents for Lignin Dissolution and Regeneration

Deep eutectic solvents (DESs) are promising for lignin dissolution and extraction. However, they usually possess high polarity and are difficult to recycle. To overcome this drawback, a variety of switchable ionic liquids (SILs) composed of 1,8-diazabicyclo[5.4.0]undec-7-ene (DBU) and alcohols was synthesized and screened. According to the thermodynamic modeling suggestions, the selected DBU-HexOH SIL was coupled with hydrogen-bond donors to form switchable-DES (SDES) systems with moderated viscosity, conductivity, and pH while maintaining switchability. The SDESs produced a well-improved lignin and lignin model compound solubility compared with those of SILs; charging CO2 into SDES (SDESCO2) caused a further increase in solubility. The solubility (25 °C) of syringic acid, ferulic acid, and milled wood lignin in SDESCO2 reached 230.57, 452.17, and 279.12 mg/g, respectively. Such SDES-dissolved lignin can be regenerated using acetone as an anti-solvent. The SDES-regenerated lignin exhibited a well-preserved structure with no noticeable chemical modifications. Furthermore, the SDESCO2 lignin possessed a higher molecular weight (Mw = 10,340 g/mol; Mn = 7672 g/mol), improved uniformity (polydispersity index = 1.35), and a higher guaiacyl lignin unit content compared with the original milled wood lignin. The SDES system proposed in the present work could benefit the fractionation of lignin compounds and facilitate downstream industrial processes.

Kinetic, thermodynamic and physical-chemical study of the removal of copper from cachaça using coconut fibers

The use of coconut fiber as a copper adsorbent in cachaça was optimised, and changes in the chemical quality of the beverage were observed by analytical techniques. The influence of the adsorbent mass and copper concentration parameters was investigated using the Central Composite Design, and the optimum condition was obtained through the use of Response Surface Methodology. The equilibrium of the adsorption reaction was obtained within 120 min. The kinetic data were better adjusted for the Elovich model (Elovich and Zhabrova 1939) and the isotherm data for the Sips model (Sips 1948). The maximum adsorption capacity was 1.38 mg g^-1. Slight changes in the physicochemical quality of the beverage were observed, including a decrease in volatile acidity and alcohol content. Copper levels in cachaça decreased from 8.57 mg L^-1 to 4.97 mg L^-1 after adsorption. Therefore, the use of biomass as a metal ion adsorbent in beverages can be successfully employed.

Modification of Surface Properties of Colloidal Suspensions of NixOy-SiO2 Mixed Oxides with Different Ni Contents by the Adsorption Layers of Poly(Vinyl Alcohol)

The adsorption and electrokinetic properties of hybrid silica materials composed of nickel and silicon oxides (NixOy-SiO2), characterized by different contents of nickel oxide (from 0.5 to 3 mmol/g SiO2), were examined. These solids were also modified by poly(vinyl alcohol) to change their surface characteristics. The polymer is non-toxic and very well soluble in water. Due to incomplete hydrolysis of the polymer acetate groups, its macromolecules become negatively charged. The limited range of studied pH (6–10) resulted from high solubility of nickel oxide at more acidic pH values. The spectrophotometric, surface charge and electrophoretic measurements indicated that PVA exhibits higher adsorption affinity for the surfaces of mixed oxide with a larger content of nickel in its structure. Moreover, the presence of polymeric layers on the solid surface influences considerably the structure of electrical double layer formed at the mixed oxide-aqueous solution interface.

Fabrication of litchi-like lignin/zinc oxide composites with enhanced antibacterial activity and their application in polyurethane films

Lignin has been demonstrated to be green and effective for the modification of ZnO-based materials. In this work, quaternized lignin/zinc oxide nanostructured hybrid composites (QLS/ZnO NCs) were synthesized with good dispersion and uniform particle size via a facile hydrothermal method. Sodium lignosulfonate (LS) was modified by quaternization to endow the positive charges, which effectively captured bacteria due to the electrostatic interactions. Interestingly, QLS/ZnO NCs show a litchi-like morphology consisting of nanorods with diameters of 5-10 nm, which further resulted in damage to the bacterial cell membrane. Owing to the surface charge and rough surface topology for bacterial capture, QLS/ZnO NCs exhibited greatly enhanced antibacterial activity compared with bare ZnO. After being treated with QLS/ZnO NCs for 90 min, the sterilization rates of Escherichia coli (E. coli) and Staphylococcus aureus (S. aureus) reached 97.54% and 99.55%, respectively. Due to the reactive oxygen species (ROS) produced by ZnO under light irradiation, the antibacterial activity of QLS/ZnO NCs could be further enhanced. In addition, the minimal inhibition concentrations (MICs) of QLS/ZnO NCs towards E. coli and S. aureus were both 100 μg/mL, and the minimum bactericidal concentrations (MBCs) were 100 μg/mL and 200 μg/mL, respectively. Moreover, with the incorporation of QLS/ZnO NCs into polyurethane films, the composite films showed excellent antibacterial activity, strong tensile strength and enhanced ultraviolet light blocking performance.

Lignin-Based Spherical Structures and Their Use for Improvement of Cilazapril Stability in Solid State

Biopolymer-based spherical particles exhibit unique properties including narrow sizes and many functional groups on their surfaces. Therefore, they show great potential for application in many scientific and industrial processes. The main aim of this study was to prepare lignin-based spherical particles with the use of a cationic surfactant, hexadecyl(trimethyl)ammonium bromide (CTAB). In the first step, different preparation procedures were tested with varying parameters, including biopolymer and surfactant ratios, lignin filtration, and experimental time. The morphological and dispersion characteristics of the materials were determined to select the best samples with the most promising properties, which could then be tested for their acute toxicity. It was observed that almost all materials were characterized by spherical shapes in micro- and nanosizes. The sample with the best physicochemical properties was used for further analysis and then tested for medical applications: the improvement of the stability of a drug molecule, cilazapril (CIL). The formulated material (CIL@LC-2a 1:1 wt./wt.) exhibited outstanding properties and significantly improved the stability of cilazapril as tested in conditions of increased temperature and humidity. Lignin spherical particles may be employed as a promising material for shielding other active compounds from decomposition.

Hydrothermal-assisted synthesis of highly crystalline titania-copper oxide binary systems with enhanced antibacterial properties

Binary oxide systems containing TiO₂ and CuO were synthesized using hydrothermal treatment and shown to have enhanced antibacterial properties. A detailed investigation was made of the effect of the molar ratio of components (TiO₂:CuO = 7:3, 5:5, 3:7, 1:9) on the physicochemical parameters and antibacterial activity. Analysis of morphology (SEM, TEM and HRTEM) confirmed the presence of spherical and sheet-shaped particles. On the XRD patterns for the binary oxide materials, two crystalline forms (anatase and monoclinic CuO) were observed. It was found that an increase in CuO content led to a decrease in the BET surface area of the TiO₂-CuO binary oxide systems. The synthesized TiO₂-CuO materials exhibited very good antibacterial activity against both Gram-positive (methicillin-resistant Staphylococcus aureus and Bacillus cereus) and Gram-negative (Salmonella Enteritidis and Pseudomonas aeruginosa) bacteria. The obtained results show that TiO₂-CuO oxide materials may have applications in the biomedical and food industries.