Bulk organisation and alignment in Langmuir and Langmuir–Blodgett films of tetrachloroperylene tetracarboxylic acid esters

Influence of chlorine atoms in bay positions of perylene-tetracarboxylic acids on their spectral properties in Langmuir-Blodgett films

The influence of chlorine atoms in the bay positions of the perylene-3,4,9,10-tetracarboxylic acids with the different alkyl chains length on their spectral properties in monomolecular films has been studied. The chlorinated (PCln) and for comparison non-chlorinated (Pn) perylene derivatives were deposited onto quartz plates using a Langmuir-Blodgett (LB) technique. The absorption spectra showed that the PCln and Pn dyes form in monolayers the I- and J-type aggregates, respectively. In turn, their steady-state and time-resolved emission spectra revealed presence of two emitter types, which we assigned to monomers and excimers. The luminescence lifetimes of the PCln monomers and excimers determined with a time-correlated single photon counting method (TCSPC) are significantly shorter than these obtained for the same emitter types in the Pn monolayers. In the case of the chlorinated dyes, the contribution of the monomer emission dominates over the excimer emission and is almost independent from the alkyl chain length. By contrast, the share of the Pn monomer emission increases strongly with a number of carbon atoms in their hydrocarbon chains. The luminescence quantum yields (LQY) of the Pn and PCln monolayers measured in an integrating sphere are in the range of 0.06-0.11. The presented results reveal that the PCln dyes exhibit lower tendency for aggregation than the non-chlorinated derivatives. It can be explained by limited intermolecular interaction between neighbouring PCln molecules caused by deformation of the perylene core as a result of strongly electronegative chlorine atoms in the bay positions of these dyes. Moreover, the strong influence of the alkyl chain length on the Pn aggregation contrary to the case of the PCln derivatives was observed.