Grain boundary sliding associated with low strain rate at 1000 °C in recrystallized ODS ferritic steel

Recent Progress on Creep Properties of ODS FeCrAl Alloys for Advanced Reactors

In order to meet the growing energy demand, more environmentally friendly and efficient GEN-IV reactors have emerged. Additionally, nuclear structural materials need larger more safety margins for accident scenarios as a result of the Fukushima accident. In order to extend the failure time and lessen the effect of accidents, this design method for accident-tolerant fuel materials calls for cladding materials to maintain good corrosion resistance and mechanical properties during a beyond design basis accident (BDBA). Accidents involving nuclear reactors would undoubtedly result in higher temperatures, which would make it much harder for materials to withstand corrosion. Oxide dispersion strengthened (ODS) FeCrAl alloys have shown promise as candidate materials because of their extraordinarily slow reaction rates under high-temperature steam. However, the addition of the Al element renders the alloy's high-temperature mechanical properties insufficient. In particular, studies on the alloy's creep properties are extremely rare, despite the fact that the creep properties are crucial in the real service environment. Therefore, this paper focuses on the creep properties of ODS FeCrAl alloy, summarizes and analyzes the research results of this material, and provides a reference for future research and applications.

Structural Evolution and Transitions of Mechanisms in Creep Deformation of Nanocrystalline FeCrAl Alloys

FeCrAl alloys have been suggested as one of the most promising fuel cladding materials for the development of accident tolerance fuel. Creep is one of the important mechanical properties of the FeCrAl alloys used as fuel claddings under high temperature conditions. This work aims to elucidate the deformation feature and underlying mechanism during the creep process of nanocrystalline FeCrAl alloys using atomistic simulations. The creep curves at different conditions are simulated for FeCrAl alloys with grain sizes (GS) of 5.6-40 nm, and the dependence of creep on temperature, stress and GS are analyzed. The transitions of the mechanisms are analyzed by stress and GS exponents firstly, and further checked not only from microstructural evidence, but also from a vital comparison of activation energies for creep and diffusion. Under low stress conditions, grain boundary (GB) diffusion contributes more to the overall creep deformation than lattice diffusion does for the alloy with small GSs. However, for the alloy with larger GSs, lattice diffusion controls creep. Additionally, a high temperature helps the transition of diffusional creep from the GB to the dominant lattice. Under medium- and high-stress conditions, GB slip and dislocation motion begin to control the creep mechanism. The amount of GB slip increases with the temperature, or decreases with GS. GS and temperature also have an impact on the dislocation behavior. The higher the temperature or the smaller the GS is, the smaller the stress at which the dislocation motion begins to affect creep.