Virtual unenhanced dual-energy computed tomography for photon radiotherapy: The effect on dose distribution and cone-beam computed tomography based position verification

First linac-mounted photon counting detector for image guided radiotherapy: Planar image quality characterization

BACKGROUND

Image guided radiotherapy (IGRT) with cone-beam computed tomography (CBCT) is limited by the sub-optimal soft-tissue contrast and spatial resolution of energy-integrating flat panel detectors (FPDs) which produce quasi-quantitative CT numbers. Spectral CT with high resolution photon-counting detectors (PCDs) could improve tumor delineation by enhancing the soft-tissue contrast, spatial resolution, dose-efficiency, and CT number accuracy.

PURPOSE

This study presents the first linac-mounted PCD. On the journey to developing spectral cone-beam CT for IGRT, the planar image quality of a linac-mounted PCD is first fundamentally characterized and compared to an FPD in terms of the 2D spatial resolution, noise, and contrast.

METHODS

A Medipix3RX-based PCD was mounted to the kV FPD of an x-ray volume imaging (XVI) system on an Elekta linac and the PCD acquisition was synchronized with the pulsed kV source. The energy calibration of the Medipix3RX was determined with various radioisotope gamma emissions up to 60 keV. To compare the 2D spatial resolution and noise between the PCD and FPD, the pre-sampling modulation transfer function (MTF) and normalized noise power spectrum (NPS) were measured using an RQA5 spectrum and a fluoroscopy phantom was imaged to determine the limiting resolution of line pairs. Spectral planar images of phantom inserts containing two different concentrations of calcium (60 and 240 mg/cc) and iodine (5 and 15 mg/cc) were optimally energy weighted to maximize the contrast using tube voltages of 60, 80, 100, and 120 kV. To account for drifts in the sensor temperature, the PCD was dynamically translated in and out of the insert shadow during acquisitions to obtain flat field corrections per frame. The raw contrast of the resultant planar images was compared to the energy-integrating FPD.

RESULTS

The energy calibration of the Medipix3RX was observed to be linear up to 60 keV. The limiting resolution observed on the fluoroscopy phantom was 2 lp/mm for the FPD and 5 lp/mm for the PCD. The pre-sampling MTF was higher across all frequencies comparing the PCD to the FPD. The normalized NPS of the PCD did not vary with frequency, whereas the spectrum for the FPD decreased monotonically and was lower than the PCD noise power across most of the spatial frequency range studied due to optical light spreading. Optimal energy weights were applied to the dynamically acquired PCD images and the raw contrast of the 60 mg/cc calcium insert increased by factors of1.12 ± 0.09 $1.12\pm 0.09$ and1.52 ± 0.22 $1.52\pm 0.22$ at 60 and 120 kV respectively compared to the FPD.

CONCLUSIONS

A Medipix3RX-based PCD was successfully integrated with the kilovoltage imaging system on an Elekta linac. The initial planar image quality characterization indicated improvements in the MTF and energy-weighted contrast compared to the FPD. Future work will focus on obtaining linac-mounted spectral CBCT images with a translate-rotate geometry, however this initial study indicates that variations in the PCD sensor response during acquisitions must be addressed to realise the full potential of linac-mounted spectral CBCT.

Generation of deep learning based virtual non-contrast CT using dual-layer dual-energy CT and its application to planning CT for radiotherapy

This paper presents a novel approach for generating virtual non-contrast planning computed tomography (VNC-pCT) images from contrast-enhanced planning CT (CE-pCT) scans using a deep learning model. Unlike previous studies, which often lacked sufficient data pairs of contrast-enhanced and non-contrast CT images, we trained our model on dual-energy CT (DECT) images, using virtual non-contrast CT (VNC CT) images as outputs instead of true non-contrast CT images. We used a deterministic method to convert CE-pCT images into pseudo DECT images for model application. Model training and evaluation were conducted on 45 patients. The performance of our model, 'VNC-Net', was evaluated using various metrics, demonstrating high scores for quantitative performance. Moreover, our model accurately replicated target VNC CT images, showing close correspondence in CT numbers. The versatility of our model was further demonstrated by applying it to pseudo VNC DECT generation, followed by conversion to VNC-pCT. CE-pCT images of ten liver cancer patients and ten left-sided breast cancer patients were used. A quantitative comparison with true non-contrast planning CT (TNC-pCT) images validated the accuracy of the generated VNC-pCT images. Furthermore, dose calculations on CE-pCT and VNC-pCT images from patients undergoing volumetric modulated arc therapy for liver and breast cancer treatment showed the clinical relevance of our approach. Despite the model's overall good performance, limitations remained, particularly in maintaining CT numbers of bone and soft tissue less influenced by contrast agent. Future research should address these challenges to further improve the model's accuracy and applicability in radiotherapy planning. Overall, our study highlights the potential of deep learning models to improve imaging protocols and accuracy in radiotherapy planning.