Impact of foot-and-mouth-disease on goat behaviour after experimental infection with serotype SAT1 virus

Relationships of infrared thermography temperature with core temperature in goat

Rectal temperature is widely used as an indicator of animal health. However, rectal temperature is conventionally measured by an invasive method, which may reduce animal welfare. So, this study aimed to determine the relationships between the deep-body (core) temperature and body surface temperatures in goats and develop a linear regression equation to establish the core temperature based on body surface temperatures. Body surface temperatures (head, eye, muzzle, horn, back, scrotum and groin) of goats were measured by infrared thermography (IRT). Ambient temperatures were measured by digital thermometer. Core temperatures were measured by a digital vet thermometer. Pearson correlation analysis was used to analyze the relationship between body surface temperatures, ambient temperature, and core temperature. Simple linear regression analysis was used to develop core temperature assessment equations. Correlation analysis showed that groin temperature was highly correlated with core temperature, and low correlated with ambient temperature. The body surface temperature of other region was low correlated with core temperature, and highly correlated with ambient temperature. Regression analysis showed that the determination coefficient of core temperature assessment equation based on groin temperature was the highest (P < 0.0001, R2 = 0.55), and those based on surface temperature of other regions were low (P < 0.01, R2 ≤ 0.16). We concluded that body surface temperatures obtained by IRT could be used for the assessment of goat core temperature. The core temperature assessment equations developed by the temperature of the body surface, which is less affected by ambient temperature, was found to have a higher determination coefficient than the equations developed using body surface temperature that is more affected by ambient temperature.

Effect of cyclic loading on the stability of screws placed in the locking plates used to bridge segmental bone defects

The objective of this study was to evaluate the ex vivo effect of cyclic loading on the stability of screws placed in locking plates used to bridge segmental bone defects. The primary interface stability was assessed using peak reverse torque. Eighteen, 8-hole stainless-steel 4.5 mm locking plates and 4.0-mm self-tapping locking-head screws were used to stabilize 40-mm segmental defects in goat tibiae. Treatment groups included control constructs without cyclic loading (n = 6) and constructs tested to 5000 (n = 6) and 10,000 cycles (n = 6) of 600 N compressive axial loading. The insertion of all screws was standardized to 400 N-cm insertion torque. Peak reverse torque was measured immediately after screw placement (control), or after the completion of the respective loading cycles. The difference between treatment groups was compared using univariate analysis of variance. The analysis revealed a significant difference in peak reverse torque of the screws among the treatment groups (p = .000). The mean reverse torque values equaled 343.5 ± 18.3 N-cm for non-cycled controls, 303.3 ± 25.9 and 296.0 ± 42.9 N-cm after 5000 and 10,000 cycles, respectively. Among all treatment groups, screws placed in the distal bone segment tended to have lesser peak reverse torque reduction than those placed in the proximal segment and the difference was proportional to the number of cycles (p = .562; p = .255; p = .013 in control, and after 5000 and 10,000 cycles, respectively). Cyclic loading may have a negative effect on the primary stability of screws placed in locking plate constructs used to bridge segmental bone defects and could contribute to the risk of screw loosening.