Large scale application of membrane bioreactor technology for the treatment and reuse of an anionic surfactant wastewater

Water recovery and on-site reuse of laundry wastewater by a facile and cost-effective system: Combined biological and advanced oxidation process

Combined biological and physicochemical process was selected for treatment of laundry wastewater. The results show that after microbial adaptation, almost 91% of COD was removed at food to microorganism (F/M) ratio of 0.12 gBOD/gMLSS·d. Dehydrogenase activity of the biomass showed an increasing trend and finally reached 3.8 μgTFgbiomass.d corresponding to the highest process performance. 16SrRNA fragment and phylogenetic analysis identified Pseudomonas pharmacofabricae and Bacillus spp. as the dominant bacteria. The effluent of the biological process was then injected into the UV/O3 process for complete removal of residual COD and detergent. Finally, microfiltration and ultrafiltration were used to remove any remaining suspended solids. The operating cost analysis showed that 0.65 €/m3 treated wastewater is required for treatment of the laundry wastewater. Accordingly, the suggested combination of the biological and physicochemical process could be a promising and highly efficient process for treatment and reuse of laundry wastewater.

A Rapid Experimental Procedure to Assess Environmental Compatibility of Conditioning Mixtures Used in TBM-EPB Technology

Earth Pressure Balance (EPB) Tunnel Boring Machines (TBM) are currently the most widely used machines to perform tunnel excavation, particularly in urban areas. This technology involves the injection of chemicals as conditioning mixtures, which commonly raises concerns limiting the reuse of soils after excavation. This study deals with the prospect of a simplified, rapid and replicable methodology for the evaluation of the biodegradability of these conditioning mixtures. For this purpose, the biodegradation of three commercial conditioning mixtures was investigated in closed bottle tests by investigating the effect of different mixtures dosages and two different inocula (soil humus and Bacillus Clausii). While using soil humus as inoculum, a comparative study of biodegradation of the three investigated mixtures was successfully carried out; in the case of Bacillus Clausii, it was not possible to make a comparison between the different formulations in a short time. The adoption of soil humus satisfied only the criteria of rapid test, while the Bacillus Clausii, as specific inoculum, can meet the criteria of replicable results. For this reason, in the second part of this experimental study, a rapid and replicable procedure was proposed and validated. A kinetic study of organic carbon removal was also carried out.

LCA of greywater management within a water circular economy restorative thinking framework

Greywater reuse is an attractive option for the sustainable management of water under water scarcity circumstances, within a water circular economy restorative thinking framework. Its successful deployment relies on the availability of low cost and environmentally friendly technologies. The life cycle assessment (LCA) approach provides the appropriate methodological tool for the evaluation of alternative treatments based on environmental decision criteria and, therefore, it is highly useful during the process conceptual design. This methodology should be employed in the early design phase to select those technologies with lower environmental impact. This work reports the comparative LCA of three scenarios for greywater reuse: photocatalysis, photovoltaic solar-driven photocatalysis and membrane biological reactor, in order to help the selection of the most environmentally friendly technology. The study has been focused on the removal of the surfactant sodium dodecylbenzenesulfonate, which is used in the formulation of detergents and personal care products and, thus, widely present in greywater. LCA was applied using the Environmental Sustainability Assessment methodology to obtain two main environmental indicators in order to simplify the decision making process: natural resources and environmental burdens. Energy consumption is the main contributor to both indicators owing to the high energy consumption of the light source for the photocatalytic greywater treatment. In order to reduce its environmental burdens, the most desirable scenario would be the use of solar light for the photocatalytic transformation. However, while the technological challenge of direct use of solar light is approached, the environmental suitability of the photovoltaic solar energy driven photocatalysis technology to greywater reuse has been demonstrated, as it involves the smallest environmental impact among the three studied alternatives.

Treatment of high strength aqueous wastes in a thermophilic aerobic membrane reactor (TAMR): performance and resilience

In the present work, the thermophilic aerobic membrane reactor technology was studied for the treatment of high strength aqueous wastes mainly containing dyes, surfactants and solvents. The thermophilic biomass resilience and the process stability under critical conditions (such as rapid rise of the mixed liquor pH, oxygen supply interruption, etc.) were also evaluated. The experimental work was carried out with the use of a pilot plant at semi-industrial scale, which was managed throughout for 14 months; the operation temperature was 49 °C and the organic loading rate was increased from 3 to 12 kg_COD m^-3 d^-1. Critical conditions, especially the interruption of oxygen supply, affected the pilot plant performance but did not cause a complete system break down. After the temporary reduction of process performance, also proven by the decrease in the oxygen consumption, the normal working conditions were restored. Moreover, the longer non-aerated phase involved a significant reduction (40%) of volatile suspended solids concentration in the biological reactor and the increase of 30% in foaming power; nevertheless, once the oxygen supply was reactivated, optimal conditions were rapidly restored. Therefore, the study showed the high resilience of the thermophilic biomass, which was able to recover full functionality after critical events.

Physicochemical treatments of anionic surfactants wastewater: Effect on aerobic biodegradability

The effect of different physicochemical treatments on the aerobic biodegradability of an industrial wastewater resulting from a cosmetic industry has been investigated. This industrial wastewater contains 11423 and 3148mgL(-1) of chemical oxygen demand (COD) and anionic surfactants, respectively. The concentration of COD and anionic surfactants were followed throughout the diverse physicochemical treatments and biodegradation experiments. Different pretreatments of this industrial wastewater using chemical flocculation process with lime and aluminium sulphate (alum), and also advanced oxidation process (electro-coagulation (Fe and Al) and electro-Fenton) led to important COD and anionic surfactants removals. The best results were obtained using electro-Fenton process, exceeding 98 and 80% of anionic surfactants and COD removals, respectively. The biological treatment by an isolated strain Citrobacter braakii of the surfactant wastewater, as well as the pretreated wastewater by the various physicochemical processes used in this study showed that the best results were obtained with electro-Fenton pretreated wastewater. The characterization of the treated surfactant wastewater by the integrated process (electro-coagulation or electro-Fenton)-biological showed that it respects Tunisian discharge standards.

Application of membrane bioreactors in the preliminary treatment of early planetary base wastewater for long-duration space missions

Membrane bioreactors (MBRs) are the preferred technology for the preliminary treatment of Early Planetary Base Wastewater (EPBW) because of their compact configuration and promising treatment performance. For long-duration space missions, irreversible membrane biofouling resulting from the strong attachment of biomass and the formation of biofilms are major concerns for the MBR process. In this study, a MBR was operated for 230 days treating synthetic EPBW. The reactor demonstrated excellent treatment performance, in terms of chemical oxygen demand removal and nitrification. Filtration resistance is mainly caused by concentration polarization, reversible fouling, and irreversible fouling. Analysis of the microbial communities in the planktonic and corresponding sessile biomass suggested that the microbial community of the planktonic biomass was significantly different from the one of the sessile biomass. This study provides valuable information for the development of the water reuse component in the National Aeronautics and Space Administration's (Washington, D.C.) Advanced Life Support system for long-term space missions.