VHF band-pass filter based on a single CMOS-MEMS doubleended tuning fork resonator

Dual-Resonator-Based (DRB) and Multiple-Resonator-Based (MRB) MEMS Sensors: A Review

Single-resonator-based (SRB) sensors have thrived in many sensing applications. However, they cannot meet the high-sensitivity requirement of future high-end markets such as ultra-small mass sensors and ultra-low accelerometers, and are vulnerable to environmental influences. It is fortunate that the integration of dual or multiple resonators into a sensor has become an effective way to solve such issues. Studies have shown that dual-resonator-based (DRB) and multiple-resonator-based (MRB) MEMS sensors have the ability to reject environmental influences, and their sensitivity is tens or hundreds of times that of SRB sensors. Hence, it is worth understanding the state-of-the-art technology behind DRB and MRB MEMS sensors to promote their application in future high-end markets.

Optimization of a Piezoelectric Energy Harvester and Design of a Charge Pump Converter for CMOS-MEMS Monolithic Integration

The increasing interest in the Internet of Things (IoT) has led to the rapid development of low-power sensors and wireless networks. However, there are still several barriers that make a global deployment of the IoT difficult. One of these issues is the energy dependence, normally limited by the capacitance of the batteries. A promising solution to provide energy autonomy to the IoT nodes is to harvest residual energy from ambient sources, such as motion, vibrations, light, or heat. Mechanical energy can be converted into electrical energy by using piezoelectric transducers. The piezoelectric generators provide an alternating electrical signal that must be rectified and, therefore, needs a power management circuit to adapt the output to the operating voltage of the IoT devices. The bonding and packaging of the different components constitute a large part of the cost of the manufacturing process of microelectromechanical systems (MEMS) and integrated circuits. This could be reduced by using a monolithic integration of the generator together with the circuitry in a single chip. In this work, we report the optimization, fabrication, and characterization of a vibration-driven piezoelectric MEMS energy harvester, and the design and simulation of a charge-pump converter based on a standard complementary metal–oxide–semiconductor (CMOS) technology. Finally, we propose combining MEMS and CMOS technologies to obtain a fully integrated system that includes the piezoelectric generator device and the charge-pump converter circuit without the need of external components. This solution opens new doors to the development of low-cost autonomous smart dust devices.

Nonlinear couplings and energy transfers in micro- and nano-mechanical resonators: intermodal coupling, internal resonance and synchronization

Extensive development of micro/nano-electromechanical systems (MEMS/NEMS) has resulted in technologies that exhibit excellent performance over a wide range of applications in both applied (e.g. sensing, imaging, timing and signal processing) and fundamental sciences (e.g. quantum-level problems). Many of these outstanding applications benefit from resonance phenomena by employing micro/nanoscale mechanical resonators often fabricated into a beam-, membrane- or plate-type structure. During the early development stage, one of the vibrational modes (typically the fundamental mode) of a resonator is considered in the design and application. In the past decade, however, there has been a growing interest in using more than one vibrational mode for the enhanced functionality of MEMS/NEMS. In this paper, we review recent research efforts to investigate the nonlinear coupling and energy transfers between multiple modes in micro/nano-mechanical resonators, focusing especially on intermodal coupling, internal resonance and synchronization.This article is part of the theme issue 'Nonlinear energy transfer in dynamical and acoustical systems'.