Investigation into the Development of an Additive Manufacturing Technique for the Production of Fibre Composite Products

Poly(Lactic) Acid Reinforced with Alkaline Lignin Biocomposites Prepared by Thermal Extrusion for Sustainable 3D Printing Process

The focus of this work is the mechanical characterization of biomaterials produced by 3D printing based on fused filament fabrication (FFF) process that has been mainly used for prototype rather than functional components due to the limited mechanical properties of pure thermoplastics parts. Addition of reinforcements from natural fiber has been adopted to improve the mechanical properties of the 3D printed parts. In this study, alkaline lignin powder that has been extracted from oil palm empty fruit bunches (OPEFB) via alkaline extraction process were used as filler in the production of biocomposites with poly(lactic) acid (PLA). Poly(lactic) acid filaments filled with 1% of alkaline lignin powder and has been compared with the presence of 5% of epoxidized palm oil (EPO) by means of thermal extrusion and further proceed with 3D printing. The samples were mechanically characterized using tensile tests and the fractography were observed. Tensile test that has been done on the filaments reveal that the filament with addition of lignin and EPO shows improved mechanical properties with higher tensile strength as well as lower stiffness. The 3D printed samples of the filament compositions also exhibit similar trend where the said filament has the best mechanical properties when the EPO is incorporated in the filament.

Selectively Enhanced 3D Printing Process and Performance Analysis of Continuous Carbon Fiber Composite Material

Aiming at the limited mechanical properties of general thermoplastic 3D printed models, a 3D printing process method for selective enhancement of continuous carbon fiber composite material is proposed. Firstly, the selective enhanced double nozzle working mechanism and crafts planning process are put forward. Then, based on the double nozzle carbon fiber 3D printing device, test samples are printed by polylactic acid (PLA) and carbon fiber material, and the test samples are enhanced by inserting layers of continuous carbon fiber material. The performance test of the samples is carried out. Experiment results show that when the volume fraction of continuous carbon fiber material increases gradually from 5% to 40%, the tensile strength increases from 51.22 MPa to 143.11 MPa. The performance improvement curve is fitted through experimental data. Finally, field scanning electron microscopy is used to observe the microscopic distribution of continuous fibers in the samples. The results of the research lay the foundation for the performance planning of 3D printed models.