Radiographic evaluation of cementation technique using polished, conical, triple-tapered femoral stem in hip arthroplasty

Comparative analysis of the quality of the cement mantle in hip hemiarthroplasty after femoral neck fracture between three different surgical approaches: a single-center retrospective observational study

PURPOSE

Achieving the initial stability of implants is necessary for hip hemiarthroplasty (HHA), especially in elderly patients, and this can be achieved with a cement mantle of quality. The direct anterior approach (DAA) for HHA lately has shown positive results. However, evidence is lacking of HHA in elderly patients with osteoporosis after femoral neck fracture (FNF). This study compares differences in cement mantle quality after HHA, its complications, radiological outcomes and functional status in elderly patients with FNF intervened through different approaches.

METHODS

A non-interventional, retrospective case-control study was conducted. 150 cases were selected based on the surgical approach (DAA, DLA and PLA) in a 1:1:1 proportion between 2018 and 2019. Under 75 years old suspicion or confirmation of a pathological fracture were excluded. Antibiotic-loaded cement was utilized. Cement preparation involved vacuum centrifugation and standard instructions for preparation canal and filling, and prosthesis placement were followed.

RESULTS

No statistically significant differences in cement mantle quality, radiological outcomes, and the majority of the postoperative complications and functional status considering the surgical approach (p > 0.05). However, the DAA was associated significantly with shorter hospital stays (8.3 days vs 11.3 and 13 days for DLA and PLA) a decrease in postoperative blood transfusion (22% vs 34% and 53%), and lower rate of loss of walking (8% vs 20% and 28.6%).

CONCLUSION

The DAA for HHA in patients with FNF provides a high-quality cement mantle, similar to other approaches. Also, the DAA shows advantages like shorter hospital stays and lower transfusion rates in elderly patients.

Minimum ten-year outcome of a triple-tapered femoral stem implanted with line-to-line cementing technique

Background

A triple-tapered polished femoral stem was implanted with line-to-line cementing technique. The purpose of this study was to determine the survivorship, loosening rate, stem subsidence, radiologic changes and clinical outcomes in the minimum 10-year follow-up.

Methods

This was a retrospective study done in three institutes. Finally, 118 hips in 97 patients could be followed-up at the mean follow-up period of 126.3 months. The survivorship, radiological and clinical outcomes were investigated.

Results

Radiologically, 107 hips (90.7%) were categorized to Barrack cementing grade A, and 108 stems (91.5%) were inserted in neutral position. All hips were not loose and were not revised due to any reason. Survival with revision for any reason as the endpoint was 100% after 10 years. At the last follow-up, the mean subsidence was 0.43 mm, and the subsidence was less than 1 mm in 110 hips (93.2%).

JOA hip score improved from 42.7 ± 8.9 points preoperatively to 92.8 ± 6.8 points at the last follow-up. No patient complained thigh pain.

Conclusions

Line-to-line cementing technique with use of a triple-tapered polished stem was effective to achieve good cementation quality and centralization of the stem. The subsidence was small, and the minimum 10-year results were excellent without any failures related to the stem.

Trial registration

Retrospectively registered.

Biomechanical evaluation of a new femoral stem design for total hip replacement in a canine model

PURPOSE

To evaluate the biomechanical properties of a novel total hip replacement femoral stem.

METHODS

Eight pairs of femurs from dog cadavers were used. The femurs were separated into different groups. A novel femoral stem with a convex proximal portion (Stem B) was biomechanically evaluated and compared to awell-known veterinary collared stem (Stem A). Femoral stems were inserted into the contralateral femurs from the same dog, forming 16 constructs. A flexo-compression load was applied on the axial axis of each sample. Maximum strength, deflection, stiffness, and energy absorption were analysed.

RESULTS

Group B constructs showed significantly higher values (p ? 0.05) for the variables, except stiffness. The mean maximum strength was 1,347 ± 357 N for Group A and 1,805 ± 123 N for Group B (p ? 0.0069). The mean deflection was5.54 ± 2.63 mm for Group A and 10.03 ± 3.99 mm for Group B (p ? 0.0056). For the energy variable, the force was 6,203 ± 3,488 N/mm for Group A and 12,885 ± 5,056 N/mm for Group B (p ? 0.0054). Stem B had greater maximum strength, deflection, and energy.

CONCLUSIONS

The new stem was effective in neutralizing the impact of axial flexion-compression stresses during biomechanical tests in cadaveric models.

The bikini incision anterior cemented total hip arthroplasty: Assessment of radiological and clinical outcomes - A mid-term review

INTRODUCTION

There has been an increased interest in minimally invasive direct anterior approach total hip arthroplasty (THA) to provide greater patient satisfaction, improve pain relief, and reduce the duration of hospitalisation. A direct anterior approach hybrid cemented THA, utilising a bikini line incision, can be technically challenging. We aimed to undertake radiological analysis of femoral stem cementation, clinical outcomes, and component survivorship.

METHODS

Over a 5-year period, 215 primary elective bikini anterior THA conducted by a single surgeon were included. All procedures were performed using a cemented collarless polished stem. The operation was performed on a standard operating table. Patients undergoing posterior approach, revision procedures, and fractured neck of femurs were excluded. Post-operative radiographs were analysed for femoral cementation quality using the Barrack grading system. Harris hip scores (HHS) were determined at 6 weeks, 12 weeks, annually thereafter and the difference in HHS was noted.

RESULTS

In total, 215 anterior bikini THA (R = 101, L = 114) were performed in 199 patients (M = 89, F = 110) with a mean age of 77 and mean follow up of 2.9 years (range = 0.5-5). Radiographic analysis of femoral cementation showed 189 femoral stems (88%) were either Barrack A or B cementation grade, suggesting optimal cementation. Lucency in the cement-bone interface occurred mainly in Gruen Zone 1 (43%) and Zone 13(46.9%). At the most recent follow-up (mean 2.9 years), component survivorship was at 99.54% (stem). Significant improvement was noted in Harris hip scores at final follow-up (from 54 preoperatively to 92.7 at 2.9 years postoperatively).

CONCLUSION

Our results suggest that a bikini incision direct anterior approach for total hip arthroplasty can be safely employed to perform cemented femoral stems on a standard operating table.

Quality of the femoral cement mantle in total hip arthroplasty using the direct anterior hip approach

Background

Limited literature exists concerning the femoral cement mantle quality that can be achieved through an anterior approach in total hip arthroplasty (THA). We radiologically evaluated the quality and thickness of the femoral cement mantle in patients undergoing THA utilizing the direct anterior approach (DAA).

Methods

Immediate postoperative anteroposterior and lateral radiographs of 116 consecutive patients who underwent hybrid or fully cemented THA using the DAA and cemented Quadra-C stem (Medacta, International, SA, Switzerland) were assessed by 2 arthroplasty surgeons blinded to the study. Surgical indications were hip osteoarthritis or subcapital hip fracture. The cement mantle and stem alignment were evaluated using the Barrack classification and Khalily methods, respectively. After calibration of radiographs, the thinnest part of the cement mantle per Gruen zone was recorded. Parameters were compared between obese and nonobese patients.

Results

Agreement between raters was substantial for the cement quality in anteroposterior (k = 0.707, P ≤ .001) and moderate for lateral radiographs (k = 0.574, P ≤ 001). The cement mantle was graded A in 39.25%, B in 53.0%, and C in 7.75% of anteroposterior radiographs and similarly for lateral radiographs (40.1% A, 51.75% B, 9.5% C). 93% of stems had neutral alignment. The mean thinnest cement mantle (P = .237) and incidence of inadequate cement mantle (<2 mm) per zone (P = .431) were comparable between Gruen zones. The cement mantle quality (P = .174) and inadequacy (P > .05) and stem alignment (P = .652) were comparable between obese and nonobese patients.

Conclusions

DAA enables correct implantation and effective cementation of straight femoral stems. A high-quality cement mantle can be achieved using DAA even in obese patients.