Raman spectroscopy for detection of ammonium nitrate as an explosive precursor used in improvised explosive devices

Raman Spectroscopy of Disperse Systems with Varying Particle Sizes and Correction of Signal Losses

In this paper, a dispersion of glass beads of different sizes in an ammonium nitrate solution is investigated with the aid of Raman spectroscopy. The signal losses caused by the dispersion are quantified by an additional scattered light measurement and used to correct the measured ammonium nitrate concentration. Each individual glass bead represents an interface at which the excitation laser is deflected from its direction causing distortion in the received Raman signal. It is shown that the scattering losses measured with the scattered light probe correlate with the loss of the Raman signal, which means that the data obtained can be used to correct the measured values. The resulting correction function considers different particle sizes in the range of 2-99 µm as well as ammonium nitrate concentrations of 0-20 wt% and delivers an RMSEP of 1.952 wt%. This correction provides easier process access to dispersions that were previously difficult or impossible to measure.

Surface-Enhanced Raman Spectroscopy of Ammonium Nitrate Using Al Structures, Fabricated by Laser Processing of AlN Ceramic

This work presents results on laser-induced surface structuring of AlN ceramic and its application in Surface-Enhanced Raman Spectroscopy (SERS). The laser processing is performed by nanosecond pulses in air and vacuum. Depending on the processing conditions, different surface morphology can be obtained. The ablation process is realized by ceramic decomposition as the formation of an aluminium layer is detected. The efficiency of the fabricated structures as active substrates in SERS is estimated by the ability of the detection of ammonium nitrate (NH4NO3). It is conducted for Raman spectrometer systems that operate at wavelengths of 514 and 785 nm where the most common commercial systems work. The obtained structures contribute to enhancement of the Raman signal at both wavelengths, as the efficiency is higher for excitation at 514 nm. The limit of detection (LOD) of ammonium nitrate is estimated to be below the maximum allowed value in drinking water. The analysis of the obtained results was based on the calculations of the near field enhancement at different conditions based on Finite Difference Time Domain simulation and the extinction spectra calculations based on Generalized Mie scattering theory. The structures considered in these simulations were taken from the SEM images of the real samples. The oxidation issue of the ablated surface was studied by X-ray photoelectron spectroscopy. The presented results indicated that laser structuring of AlN ceramics is a way for fabrication of Al structures with specific near-field properties that can be used for the detection of substances with high social impact.

Infrared to terahertz identification of chemical substances used for the production of IEDs

In our modern times, improvised explosive devices (IEDs) have become more sophisticated than ever, capable of causing destruction and loss of life. The creative use of homemade substances for IEDs manufactures has led to efforts in developing sensitive detection methods that can anticipate, identify and protect against improvised attacks. Laser-based spectroscopic techniques provide rapid and accurate detection of chemicals in improvised explosives, but no single method can detect all components of all explosives. In this study, two spectroscopic methods are used for the sensitive identification of 8 explosive chemical substances in the form of powders and vapors. Absorption spectra of benzene, toluene, acetone and ethylene glycol were examined with CO2 laser photoacoustic spectroscopy. The photoacoustic signals of the samples were recorded in the CO2 laser emission range from 9.2 to 10.8 µm and a different spectral behavior was observed for each analyzed substance. Time-domain spectroscopy with THz radiation was used to analyze ammonium nitrate, potassium chlorate, dinitrobenzene, hexamethylenetetramine transmission spectra in the 0.1-3 THz range, and it was observed that they have characteristic THz fingerprint spectra. CO2 laser photoacoustic spectroscopy and THz time domain spectroscopy have met the criterion of proven effectiveness in identifying explosive components. The combination of these spectroscopic methods is innovative, giving a promising new approach for detection of a large number of IED components.

Forensic analytical aspects of homemade explosives containing grocery powders and hydrogen peroxide

Homemade explosives become a significant challenge for forensic scientists and investigators. In addition to well-known materials such as acetone peroxide trimer, black powder, or lead azides, perpetrators often produce more exotic and less recognized Homemade Explosives (HMEs). Mixtures of hydrogen peroxide with liquid fuels are widely acknowledged as powerful explosives. Interestingly, similar explosive properties are found in mixtures of numerous solid materials with H2O2. Notably, powdered groceries, such as coffee, tea, grounded spices, and flour, are particularly interesting to pyrotechnics enthusiasts due to their easy production using accessible precursors, which do not attract the attention of security agencies. H2O2-based HMEs may become a dangerous component of improvised explosive devices for terrorists and ordinary offenders. For the four most powerful mixtures-HMEs based on coffee, tea, paprika, and turmeric-molecular markers useful for identification using the GC-MS technique have been proposed. Furthermore, the observed time-dependent changes in mixtures of H2O2 with these food products were studied and evaluated as a potential method for assessing the age of the evidence and reconstructing timelines of crimes. The paper also discusses the usefulness of FT-IR spectroscopy for identifying H2O2-based HMEs.

Evaluation of handheld Raman spectrometers for the detection of intact explosives

The detection of intact explosives in the field provides a unique challenge for investigators, considering the sensitive and dangerous nature of these samples. Handheld Raman instruments have grown in popularity for the analysis of unknown samples in the field, combining speed of data collection and reliability with a size that allows for the instruments to be field portable. Handheld Raman instruments are used commonly in the field, and yet there is very little research on the detection capabilities of these instruments, specifically for explosive compounds. The present study aimed to evaluate the detection capabilities of two handheld Raman spectrometers, the Rigaku ResQ-CQL and the Field Forensics HandyRam™, using explosives analytical standards, including 2,4,6-trinitrotoluene (TNT), nitromethane (NM), ammonium nitrate (AN) and smokeless powder components such as diphenylamine (DPA), ethyl centralite (EC), and methyl centralite (MC). The spectrometers were evaluated on their sensitivity, the repeatability of the data, and the performance of the internal library when available. In addition, an interference study with glass and plastic containers was also performed. Finally, authentic intact explosive samples, including TNT flakes, a mixture of ammonium nitrate and fuel oil (ANFO), smokeless powder and nitromethane were analyzed to evaluate the developed method and test the detection capabilities of the spectrometers with authentic samples. Spectra were reproducible for all the analytes across both instruments, with regards to the peak location and the intensity. Spectra obtained with the Rigaku ResQ-CQL displayed better resolution for all analytes, including the authentic samples. In addition, its wider scan range allowed for the detection of more detailed peaks below 400 cm-1. Identifying the detection capabilities of these handheld instruments can therefore help guide investigators on how to best utilize them in the field.

Miniaturized cost-effective broadband spectrometer employing a deconvolution reconstruction algorithm for resolution enhancement

We demonstrate a miniaturized broadband spectrometer employing a reconstruction algorithm for resolution enhancement. We use an opto-digital co-design approach, by firstly designing an optical system with certain residual aberrations and then correcting these aberrations with a digital algorithm. The proposed optical design provides an optical resolution less than 1.7 nm in the VIS-channel (400-790 nm) and less than 3.4 nm in the NIR-channel (760-1520 nm). Tolerance analysis results show that the components are within a commercial class, ensuring a cost-efficient design. We build the prototype with a size of 37x30x26 mm³ and demonstrate that by applying a restoration algorithm, the optical resolution can be further improved to less than 1.3 nm (VIS-channel) and less than 2.3 nm (NIR-channel).

Influence of Ball Bearing Size on the Flight and Damage Characteristics of Blast-Driven Ball Bearings

This paper presents insights into the influence of ball size on the flight characteristics and damage of a ball bearing embedded in a rear detonated cylindrical charge. It includes results from a post-test damage analysis of ball bearings from previously reported experiments. Computational simulations using Ansys Autodyn were used to provide extra information about the velocity variation during flight and the damage sustained by the ball bearings during the blast event. The influence of bearing size (diameter and mass) was investigated using the validated simulation models to extend the dataset beyond the initial experimental work. The peak bearing velocity is influenced by the charge mass to ball bearing mass ratio and the aspect ratio of the charge. Larger ball bearings require extra momentum to accelerate them to higher velocities, but their higher surface area means a greater portion of the explosive charge is involved in transferring kinetic energy to the projectile. Tensile spalling was to be the major damage mechanism within the ball bearings. The charge aspect ratio also influenced the hydrostatic pressure propagation within the ball bearing itself, affecting the location and degree of internal cracking within the bearings. These findings will prove valuable to blast protection engineers considering the effects of embedded projectiles in improvised explosive devices.

18α-Glycyrrhetinic acid aggregation-induced emission probes for visual fluorescence detection of explosive as well multi-functional applications

Two novel compounds with good AIE properties were synthesized. As fluorescent probes, these compounds could effectively and quickly detect the explosive FOX-7.

Potential Oscillated Electrochemical Metal Recovery System with Improved Conversion Kinetics and High Levelized Quality

Electrodeposition, which is an eco-friendly process with high efficiency, is one of the most promising technologies for metal recovery. However, the kinetics are often limited by the polarization and uncontrollable quality of deposits during the electrodeposition process, which restrict the efficiency and controllability of metal recovery. To ameliorate the limitations of the deposition rate and as-formed deposit quality, transient electrodeposition was introduced to control the microinterfacial reaction by regulating the relationship between charge and mass transfer. The Cu²⁺ removal efficiency and kinetic coefficient during 1 kHz transient electrodeposition were 17.4 and 17.7% higher than those under the conventional steady electric stimulus, respectively. Based on the combined results of X-ray photoelectron spectroscopy (XPS) and energy-dispersive X-ray spectroscopy (EDS), it was found that the chemical composition of the deposits from transient electrodeposition was more homogenous, as indicated by the low content of metal oxides. The in situ Raman spectra explained the homogenous composition based on the weak interaction of the electrode with the anions during the transient electrodeposition, which was mainly due to the enhanced dehydration under the oscillating or alternating electric field. The potential oscillation induced by the transient electric field also facilitated dehydration, charge transport, and mass transfer, which led to rapid and high-quality metal recovery. Transient electrodeposition will have a great guidance value in the field of metal electroplating and heavy metal recovery from wastewater by electrodeposition.

Identification of Typical Solid Hazardous Chemicals Based on Hyperspectral Imaging

The identification of hazardous chemicals based on hyperspectral imaging is an important emergent means for the prevention of explosion accidents and the early warning of secondary hazards. In this study, we used a combination of spectral curve matching based on full-waveform characteristics and spectral matching based on spectral characteristics to identify the hazardous chemicals, and proposed a method to quantitatively characterize the matching degree of the spectral curves of hazardous chemicals. The results showed that the four hazardous chemicals, sulfur, red phosphorus, potassium permanganate, and corn starch had bright colors, distinct spectral curve characteristics, and obvious changes in reflectivity, which were easy to identify. Moreover, the matching degree of their spectral curves was positively correlated with their reflectivity. However, the spectral characteristics of carbon powder, strontium nitrate, wheat starch, and magnesium–aluminum alloy powder were not obvious, with no obvious characteristic peaks or trends of change in reflectivity. Except for the reflectivity and the matching degree of the carbon powder being maintained at a low level, the reflectivity of the remaining three samples was relatively close, so that it was difficult to identify with the spectral curves alone, and color information should be considered for further identification.

Understanding phase transition and vibrational mode coupling in ammonium nitrate using 2D correlation Raman spectroscopy

Ammonium nitrate (AN) is an important component of the chemical industry such as an active ingredient in fertilizers, as an oxidizer in explosive compositions and propellants, and as a blasting agent in civil explosives. Numerous accidents have been reported in the past which concerns its thermal instability and poses a big threat to its processing, transportation, and storage. Despite much literature being reported to understand its thermal instability, a mechanistic view remains unclear. In the present work, we have studied the behavior of AN to temperature change using a mathematical approach called 2D correlation (2D Cos) Raman spectroscopy to provide complete insight into the detailed dynamical nature of the interactions between the species (ionic or molecular) occurring with an increase in temperature. We have analyzed various libration and translational modes of nitrate in the low-frequency region using this mathematical tool. It is observed from 2D maps that the phase transition of AN starts with changes in libration modes followed by various nitrate modes and ammonium modes which further precedes low-frequency translational modes. Further, the 2D correlation could differentiate between modes splitting and shifting based on specific 2D Cos pattern. The changes occurring in the N-O deformation modes, symmetric stretching modes as well as anti-symmetric stretching modes which have been attributed to the weakening of the hetero-ionic coupling between the NH₄⁺ and the NO₃^- ions could be clearly distinguished in the 2D synchronous and asynchronous plots. Besides, moving window analysis was performed to visualize the transition temperature at which phase change of AN takes place.