Photophysical properties of push-pull monocationic D-π-A+ thiophene based derivatives: Fluorosolvatochromism and pH studies

Unique structural effect on the fluorosolvatochromism and dual fluorescence emission of D-π-A+ cationic chromophores with furyl bridge. An approach to white light emitters

Photophysical behavior of two D - π - A+ cationic compounds with the same furyl bridge and nicotinamidine group as an electron acceptor moiety and two electron donating groups, namely methoxy (I) and N,N-dimethylamino (II) groups was examined using steady-state and time-resolved techniques in variety of solvents. Time-dependent density functional theory (TDDFT) calculations were performed in some representative solvents and compared with the experimental results. Steady state and time-resolved studies in different solvents reveal that fluorescence emission of (I) is ascribed to an emission from an excited state (ICT) with higher dipole moment than the ground state while the emission of (II) is a dual emission from a state with high charge transfer nature (ICT) in addition to the locally excited state (LE). The fluorescence emission spectra of (II) were found to depend on the excitation wavelength and an increase in the excitation wavelength led to the formation of a longer wavelength emission band with lower quantum yield. It has also been found that the fluorescence excitation spectra were dependent on the emission wavelength. The effect of solvent on the nature of dual emission was examined. Correlation of the photophysical properties of the excited states of (I) and (II) with the solvent polarity, ε, reveals the charge transfer nature of (I) and the long wavelength emission band of (II), while their correlation with the solvent polarity parameter (ETN) shows two different trends when the solvents are divided to aprotic and protic solvents. For precise investigation of the impact of each solvent parameter on each photophysical property, Catalán's and Laurence's four parametric linear solvation energy relationships were studied. We have found that the non-specific interactions of the solvent are primarily responsible for controlling the photophysical properties, as demonstrated by Catalán's and Laurence's treatments. DFT and TDDFT calculations were used to anticipate the dipole moments in the ground and excited states and geometry of both states.

Unraveling the photophysical characteristics and biological applications of vinyl sulfones as viscosity sensors

For the first time, a series of vinyl sulfone-NH2-based push-pull fluorophores (4a-4d) were introduced for their potential use in biological applications. The fluorophores 4a-4d were readily synthesized upon reduction of the corresponding vinyl sulfones-NO2 (3a-3d), which were prepared by sulfonylation of nitrostyrene. Both types of probes can be prepared in high yields through a few steps with minimal cost. In diverse solvents, probes 4a-4d exhibited fluorescence with strong emission peaking around 403-490 nm. Additionally, the fluorescence intensity of probe 4d rose approximately 85-fold with increasing viscosity. The probes 4a-4d demonstrated good stability and photostability in a broad pH range. Moreover, probes 4a-4d showed significantly improved biocompatibility compared to those derived from 3a-3d. For cell imaging applications, the developed probes 4a-4d exhibited much stronger blue fluorescence in cancer cells (HepG2) compared to 3a-3d. In addition, probes 4a-4d exhibited low cytotoxicity within 24 h toward both cancer and normal cells (HEK-293). Interestingly, probe 4d showed great sensitivity to viscosity in cancer cells. As a result, readily prepared vinyl sulfone-NH2-based push-pull fluorophores (4a-4d) offer a promising strategy for further development as cancer cell staining agents.