Carbon fibers as green and sustainable sorbent for the extraction of isoflavones from environmental waters

Innovative, simple, and green: A sample preparation method based on 3D printed polymers

The present study evaluates the capability of fifteen 3D printed thermoplastic polymers as novel stationary phases for the extraction of forty-three physicochemically diverse analytes from fortified human oral fluid samples. Prototype extraction devices were prepared in 96-well plate-compatible format using fused deposition modeling 3D printer. The sample preparation was performed with 5-step protocol utilizing 96-well plates and semiautomated benchtop shaker. All resulting extracts were analyzed via high-performance liquid chromatography (operated in reversed-phase gradient elution mode) and tandem mass spectrometry (with electrospray ionization and triple quadrupole mass spectrometer). Exceptionally favorable results were observed for three polymer types: polyamide 6 (reinforced with 15% carbon fiber), LAYFOMM-60 (polyurethane with water-soluble polyvinyl alcohol), and S-FLEX 90A (thermoplastic polyurethane). Furthermore, this study also introduces an automated and repeatable 3D printing method for the fast fabrication of high-throughput, and highly selective sample preparation devices, most of which are ready-to-use without any additional processing or chemical functionalization. As such, the proposed printing method represents a significant step towards the introduction of novel polymeric stationary phases for analytical sample preparation, thus providing laboratory personnel with a method that is safer and more convenient, while minimizing negative environmental impacts.

Portable stirring device for the on-site extraction of environmental waters using magnetic hydrophilic-lipophilic balance tape

The spatial heterogeneity of environmental systems makes sampling at multiple locations crucial to provide complete and representative information. The on-site application of an extraction technique simplifies the sampling logistics, increasing sample integrity during transportation and storage. This article presents a portable, simple, and low-cost device capable of performing the simultaneous on-site extraction of several environmental water samples. The device consists of a small electric motor integrated into the plastic cap of a conventional glass bottle and operated with a portable battery. The electric motor provides stirring to a novel magnetic sorptive phase based on the deposition of hydrophilic-lipophilic balance (HLB) particles over a magnetic tape. The use of open technology makes the device globally affordable. In this first approach, the isolation and preconcentration of atrazine and simazine have been selected as proof of concept. Using an internal standard made unnecessary the adjustment of the ionic strength before the extraction, thus simplifying the analytical procedure. Under the optimum conditions and using direct infusion mass spectrometry as the instrumental technique, detection limits as low as 15 ng/L were obtained. The precision calculated at three different levels was better than 8.3%. The accuracy, calculated with spiked samples, indicates the applicability of the approach for environmental water analysis.

Wooden-based materials: Eco-friendly materials for direct mass spectrometric analysis and microextraction

Lignocellulosic materials have arisen as a sustainable alternative in microextraction techniques during the last 10 years. As they are natural materials, their use fits into some of the principles of Green Analytical Chemistry. Their inherent porosity, narrow shape, and rigidity permit their use in ambient ionization mass spectrometry techniques. In particular, the combination of wooden-based materials and direct analysis gives birth to the so-called wooden-tip electrospray ionization mass spectrometry technique. This approach has been used for the direct analysis of complex samples, and as a streamlined tool for fingerprint quality analysis. Also, wooden-based materials can be superficially modified to boost the interaction with target compounds, allowing their isolation from complex samples. This review describes the potential and applicability of direct analysis using lignocellulosic materials, as well as other alternatives related to their use in microextraction.