Effect of misalignment of air-coupled probes on Ao Lamb mode propagating in a metal plate

Analysis of damage localisation results in GFRP panel for different configurations of air-coupled transducers

In this paper results of the damage assessment of fiber-reinforced composite panels using guided wave propagation phenomenon are presented. For this purpose, non-contact elastic wave generation based on an air-coupled transducer (ACT) is utilised. Elastic wave sensing was based on a scanning laser Doppler vibrometer (SLDV). The problem of ACT slope angle for the effectiveness of elastic wave modes generation is analysed. It was shown that for an excitation frequency of 40 kHz it is possible to generate A₀ wave mode. The authors also investigated the damage sensitivity related to panel coverage area by elastic waves with large energy. An artificial damage in the form of Teflon inserts was utilised. Moreover, the influence of single and multiple acoustic wave sources on artificial damage localisation results was investigated. For this purpose RMS wave energy maps, statistical parameters, and damage indices are utilised. Different locations of ACTs and their influence on damage localisation results are investigated. A damage imaging algorithm based on wavefield irregularity mapping (WIM) has been proposed. In this research low-cost and popular, low-frequency ACT was utilised giving the possibility of realisation of the non-contact damage localisation method.

Air-Coupled Reception of a Slow Ultrasonic A0 Mode Wave Propagating in Thin Plastic Film

At low frequencies, in thin plates the phase velocity of the guided A₀ mode can become slower than that of the ultrasound velocity in air. Such waves do not excite leaky waves in the surrounding air, and therefore, it is impossible to excite and receive them by conventional air-coupled methods. The objective of this research was the development of an air-coupled technique for the reception of slow A₀ mode in thin plastic films. This study demonstrates the feasibility of picking up a subsonic A₀ mode in plastic films by air-coupled ultrasonic arrays. The air-coupled reception was based on an evanescent wave in air accompanying the propagating A₀ mode in a film. The efficiency of the reception was enhanced by using a virtual array which was arranged from the data collected by a single air-coupled receiver. The signals measured at the points corresponding to the positions of the phase-matched array were recorded and processed. The transmitting array excited not only the A₀ mode in the film, but also a direct wave in air. This wave propagated at ultrasound velocity in air and was faster than the evanescent wave. For efficient reception of the A₀ mode, the additional signal-processing procedure based on the application of the 2D Fourier transform in a spatial–temporal domain. The obtained results can be useful for the development of novel air-coupled ultrasonic non-destructive testing techniques.

Diffraction, attenuation, and source corrections for nonlinear Rayleigh wave ultrasonic measurements

This research considers the effects of diffraction, attenuation, and the nonlinearity of generating sources on measurements of nonlinear ultrasonic Rayleigh wave propagation. A new theoretical framework for correcting measurements made with air-coupled and contact piezoelectric receivers for the aforementioned effects is provided based on analytical models and experimental considerations. A method for extracting the nonlinearity parameter β11 is proposed based on a nonlinear least squares curve-fitting algorithm that is tailored for Rayleigh wave measurements. Quantitative experiments are conducted to confirm the predictions for the nonlinearity of the piezoelectric source and to demonstrate the effectiveness of the curve-fitting procedure. These experiments are conducted on aluminum 2024 and 7075 specimens and a β11(7075)/β11(2024) measure of 1.363 agrees well with previous literature and earlier work. The proposed work is also applied to a set of 2205 duplex stainless steel specimens that underwent various degrees of heat-treatment over 24h, and the results improve upon conclusions drawn from previous analysis.