Comparative study of quenching correction procedures for / determination by Cerenkov, liquid scintillation and plastic scintillation techniques

Improved non-destructive method for 90Sr activity determination in aqueous solutions using Monte Carlo simulation

The development of new methods and improvements of existing methods for the specific activity determination of ⁹⁰Sr and other distinct beta emitters has been of considerable interest. The reason for this interest is that the notably small number of methods that are able to meet all the set criteria, such as reliability of the results, measurement uncertainty and time, and minimum production of radioactive waste, as well as applicability to various samples with reference to their nature, geometry and composition. In this paper, two methods for rapid ⁹⁰Sr activity determination based on Monte Carlo simulations are used, one for a Si semiconductor detector for beta spectrometric measurements and the other for the Geiger-Muller (GM) ionization probe. To improve the reliability of the measurement results, samples with high and low strontium activity solutions were prepared in the form of dry residues. The results of the proposed methodology were verified with a standard method using a liquid scintillation counter, and notably good agreements are achieved.

First approach to radionuclide mixtures quantification by using plastic scintillators. Influence of the diameter of the plastic beads

Recent studies have evaluated the capability of plastic scintillation (PS) as an alternative to liquid scintillation (LS) in radionuclide activity determination without mixed waste production. In order to complete the comparison, we now assess the extent to which PS can be used to quantify mixtures of radionuclides and the influence of the diameter of the plastic scintillation beads in detection efficiency. The results show that the detection efficiency decreases and the spectrum shrink to lower energies when the size of the plastic scintillation beads increases, and that the lower the energy of the beta particle, the greater the variation takes place. Similar behaviour has been observed for beta-gamma and alpha emitters. Two scenarios for the quantification of mixtures are considered, one including two radionuclides (14C and 60Co) whose spectra do not overlap significantly, and the other including two radionuclides (137Cs and 90Sr/90Y), where the spectra of one the isotopes is totally overlapped by the other The calculation has been performed by using the conventional window selection procedure and a new approach in which the selected windows correspond to those with lower quantification errors. Relative errors obtained using the proposed approach (less than 10%) are lower than those of the conventional procedure, even when a radionuclide is completely overlapped, except for those samples with extreme activity ratios that were not included in the window optimization process.

Reusability of plastic scintillators used in beta emitter activity determination

The use of plastic scintillation in the measurement of beta emitter activity is a suitable alternative to classical detection techniques in spite of the high cost and potential memory effects. Reuse of the plastic scintillator beads after a cleanup procedure would overcome both drawbacks. In the present paper, we tested several cleaning solutions (water, HCl 0.1M, commercial soap, EDTA 0.01 M pH=3, citric acid 0.1 M pH=3). The recommended procedure consists of the immersion of the beads in three consecutive citric acid baths for 24 h. If this protocol is followed, plastic beads contaminated with 90Sr/90Y, 14C, and 3H recover their initial condition, and can be used in successive determinations.