Determination of mercury by cold vapour atomic absorption spectrometry with derivative signal processing

A Ratiometric Fluorescence Amplification Using Copper Nanoclusters with o-Phenylenediamine Sensor for Determination of Mercury (II) in Natural Water

A simple and rapid method for determining mercury (II) has been developed using L-cysteine-capped copper nanocluster (CuNCs) with o-phenylenediamine (OPD) as the sensor. The characteristic fluorescence peak of the synthesized CuNCs was observed at 460 nm. The fluorescence properties of CuNCs were strongly influenced by the addition of mercury (II). Upon addition, CuNCs were oxidized to form Cu²⁺. Then, the OPD were rapidly oxidized by Cu²⁺ to form o-phenylenediamine oxide (oxOPD), as evidenced by the strong fluorescence peak at 547 nm, resulting in a decrease in the fluorescence intensity at 460 nm and an increase in the fluorescence intensity at 547 nm. Under optimal conditions, a calibration curve between the fluorescence ratio (I547/I460) and mercury (II) concentration was constructed with a linearity of 0-1000 µg L^-1. The limit of detection (LOD) and limit of quantification (LOQ) were found at 18.0 µg L^-1 and 62.0 µg L^-1, respectively. The recovery percentage was in the range of 96.8-106.4%. The developed method was also compared with the standard ICP-OES method. The results were found to be not significantly different at a 95% confidence level (t_stat = 0.365 < t_crit = 2.262). This demonstrated that the developed method could be applied for detecting mercury (II) in natural water samples.

Direct determination of mercury in cosmetic samples by isotope dilution inductively coupled plasma mass spectrometry after dissolution with formic acid

A new method was proposed for the accurate determination of mercury in cosmetic samples based on isotopic dilution (ID)-photochemical vapor generation (PVG)-inductively coupled plasma mass spectrometry (ICP MS) measurement. Cosmetic samples were directly dissolved in formic acid solution and subsequently subjected to PVG for the reduction of mercury into vapor species following by ICP MS detection. Therefore, the risks of analyte contamination and loss were avoided. Highly enriched (201)Hg isotopic spike is added to cosmetics and the isotope ratios of (201)Hg/(202)Hg were measured for the quantitation of mercury. With ID calibration, the influences originating from sample matrixes for the determination of mercury in cosmetic samples have been efficiently eliminated. The effects of several experimental parameters, such as the concentration of the formic acid, and the flow rates of carrier gas and sample were investigated. The method provided good reproducibility and the detection limits were found to be 0.6 pg mL(-1). Finally, the developed method was successfully applied for the determination of mercury in six cosmetic samples and a spike test was performed to verify the accuracy of the method.