Alveolar bone remodelling pattern of the rat incisor under different functional conditions as shown by minocycline administration

Characterization of eight different tetracyclines: advances in fluorescence bone labeling

Polychrome sequential labeling with fluorochromes is a standard technique for the investigation of bone formation and regeneration processes in vivo. However, for human application, only tetracycline and its derivates are approved as fluorochromes. Therefore, the aim of this study was to determine the fluorescence characteristics of the different tetracycline derivates to assess the feasibility of sequential in vivo bone labeling using distinguishable fluorochromes. Eight different tetracycline derivates were injected subcutaneously into growing rats as a single dose or sequentially in different combinations. After preparation of resin-embedded undecalcified bone sections, the fluorescence properties of the tetracycline derivates in bone were analyzed using conventional fluorescence microscopy, spectral image analysis and confocal laser scanning microscopy. Each tetracycline derivate exhibited a characteristic fluorescence spectrum, but the differences between them were small. Chlortetracycline could be discriminated reliably from all other derivates and could therefore be combined with any other tetracycline derivate for reliably distinguishable double labeling. Tetracycline itself exhibited the brightest fluorescence of all the investigated derivates. Interestingly, in conventional microscopy the same tetracycline derivative can appear in different colours to the human eye, even if spectral analysis confirmed identical emission peaks. In conclusion, the data suggest that fluorescence double labeling of bone is feasible using appropriate tetracycline derivates in combination with spectral imaging modalities.

Osteocytes and WNT: the Mechanical Control of Bone Formation

Mechanical loading is of pivotal importance in the maintenance of skeletal homeostasis, but the players involved in the transduction of mechanical stimuli to promote bone maintenance have long remained elusive. Osteocytes, the most abundant cells in bone, possess mechanosensing appendices stretching through a system of bone canaliculi. Mechanical stimulation plays an important role in osteocyte survival and hence in the preservation of bone mechanical properties, through the maintenance of bone hydratation. Osteocytes can also control the osteoblastic differentiation of mesenchymal precursors in response to mechanical loading by modulating WNT signaling pathways, essential regulators of cell fate and commitment, through the protein sclerostin. Mutations of Sost, the sclerostin-encoding gene, have dramatic effects on the skeleton, indicating that osteocytes may act as master regulators of bone formation and localized bone remodeling. Moreover, the development of sclerostin inhibitors is opening new possibilities for bone regeneration in orthopedics and the dental field.

Development of functional dentin incisors after a partial resection of the odontogenic organ of rat incisors

The resection of the labial half of the odontogenic organ of rat incisors resulted in the development of teeth without enamel. Ten out of 26 operated rats developed a functional dentin incisor, i.e. a continuously growing and erupting tooth. These teeth were a little shorter and much thinner than normal incisors. The dentin and pulp presented a normal structure. Periodontal ligament and cement started to develop at the lingual face and gradually all tooth faces were invested by these tissues. The original socket space, to accommodate a thinner tooth, was narrowed by newly formed bone around the inner face of the socket. Eleven rats developed defective dentin incisors; these teeth showed signs of growth, however, their eruption was impaired. The operation failed in five rats. The odontogenic organ of the dentin incisor presented islands of epithelial cells at the labial aspect of a dense mass of mesenchyme cells. These islands, formed by densely packed, dark-staining cells encircling a few pale-staining cells, merged gradually, forming a root sheath and a cervical loop limiting a long apical foramen. The bulk of the bulbous part (apical bud) was absent; thus, there was no differentiation of ameloblasts and of the crown-analogue part of the incisor. The growth and eruptive behaviour of the dentin incisor, similar to that of a normal incisor, indicates that it has to bear a stem cell niche to retain its regenerative capacity. As in the apical bud, this niche is apparently located at the stellate reticulum of the cervical loop. The putative molecular mechanisms related to either the maintenance of the stem cell niche or the differentiation of the enamel organ and the root sheath are discussed. These data and our results, showing the development of a functional dentin incisor, suggest that the root-analogue part of the rodent incisor is an anatomic-physiological entity.

The effect of partial damage to the enamel-related periodontium combined with root resection on eruption of the rat incisor eruption

Previous work has indicated that the enamel-related periodontium (ERP) has a role in the eruptive process of the rat lower incisor. By combining partial damage of this tissue with resection of the odontogenic organ, we examined the effect of the damage on subsequent incisor eruption. The connective tissue of the enamel-related periodontium was regenerated in less than 2 weeks, showing morphology close to normal. The injured part of the enamel organ was neither regenerated nor repaired, and a cement-like tissue, continuous with the true acellular cement, was formed on the denuded enamel. Before tooth exfoliation, the operated teeth erupted at a slower rate compared with root-resected and sham-operated incisors, probably because of the absence of a substantial part of the enamel organ due to surgical damage. As with the coronal dental follicle and the enamel organ in rat molars, the enamel-related periodontium and the enamel organ of rat incisors may have some control on their eruptive process.

Alveolar bone Sharpey fibers of the rat incisor in normal and altered functional conditions examined by scanning electron microscopy

The morphology and the area density of Sharpey fibers in the socket of the rat incisor under normo-, hyper-, and hypofunctional conditions were evaluated using scanning electron microscopy. Sharpey fibers appeared either as dome-shaped projections, when highly mineralized, or as depressions when less mineralized. Near the alveolar crest, most of the fibers were fully mineralized and arranged in compact longitudinal rows. Toward the basal end of the socket, the rows became interrupted, forming islets of gradually smaller size and number. The density of the Sharpey fibers was higher (P < 0.01) in the mesial and distal faces than in the lingual face in most of the socket length. In normofunctional conditions, in all faces the density decreased 70 to 90 times from the crestal toward the basal region of the socket (P < 0.01). The degree of mineralization of the Sharpey fibers also decreased steadily in the same direction, indicating that, for support, the periodontal ligament matures from basal to incisal and is fully developed only in the crestal region. In hyper- and hypofunctional conditions, the same distribution was observed. The area density of the Sharpey fibers in the hyperfunctional condition showed a slight increase at the basal levels of the socket mesial and distal faces (P < 0.01 or P < 0.05). In hypofunctional incisors, the density decreased significantly (P < 0.01) at the mesial and distal faces in all regions of the socket, and at the lingual face, the decrease (P < 0.05) was restricted to the incisal regions. This may be one of the factors for the weakening of the periodontal ligament in hypofunctional incisors.