Quantitation of pharmaceutically important phenothiazines by oxidimetry

Spectroscopic and electrochemical analysis of psychotropic drugs

Psychotropic drugs are an important family of compounds from a medical point of view. Their application in therapy requires methods for the determination in pharmaceutical dosage forms and body fluids. Several methods for their analysis have been reported in the literature. Among the methods, spectrophotometric and electrochemical are very useful for the determination of the drugs. Some of the spectrophotometric methods are based on the formation of the binary and ternary compounds with complexes of metals. The formed compounds are sparingly soluble in water, but quantitatively extracted from aqueous phase into organic solvents and the extracts are intensely colored and stable for a few days. These complexes have been employed in pharmaceutical analysis. The electrochemical procedures are very useful in determination of the psychotropic substances in pharmaceutical preparations.

Efficient Oxidizing Agents for Determination of 2,10-Disubstituted Phenothiazines

2,10-Disubstituted phenothiazines are the best drugs in psychiatry. Several methods for their analysis have been reported in the literature. The official methods are based on non-aqueous titration or spectrophotometry. Various oxidizing agents have been used for the spectrophotometric determination of 2,10-disubstituted phenothiazines, e.g. Ce(SO4)2, NH4VO3, K2S208, KIO4, KIO3, KBrO3, FeCl3, NaNO2, H2O2, chloramine T, p-benzoquinone, N-bromosuccinimide. Oxidation reactions of phenothiazines were also used for their determination by flow-injection methods.

Determination of some psychotropic phenothiazine drugs by charge-transfer complexation reaction with chloranilic acid

A spectrophotometric method is described for the determination of four commonly used psychotropic phenothiazine drugs. The method is based on the measurement of the intensely coloured charge-transfer complex formed by the interaction of these drugs as n-electron donors with chloranilic acid as the pi-acceptor. The coloured species measured exhibits maximum absorption at 535 nm. The molar-combining ratio and optimum assay conditions are reported. Beer's law is obeyed over the range, 25-250 microg ml(-1) with apparent molar absorptivity in the range, 0.93 x 10(3)-1.45 x 10(3) l mol(-1) cm(-1). The limits of detection and quantification are reported. The proposed method was applied to the determination of these psychotropics in pharmaceutical formulations and the results demonstrated that the method is equally accurate, precise and reproducible as the official methods. The validity of method was established by recovery studies via standard-addition technique with satisfactory results.

Two simple methods for the estimation of albendazole and its dosage forms using chloramine-T

Two simple, rapid and reliable methods for the determination of albendazole are described. Both methods involve the use of chloramine-T as the oxidimetric reagent. In the titrimetric method, a known excess of chloramine-T is added to an acidified solution of sample, and after a specified time, the residual oxidant is determined iodometrically. Spectrophotometric procedure also involves the addition of a measured excess of chloramine-T in buffer medium of pH 2.70+/-0.1 and after the reaction is ensured to be complete, the surplus oxidant is determined by a well established colour reaction involving metol and primary arylamine that results in charge-transfer complex measurable at 520 nm. In both methods, the amount of chloramine-T corresponds to the drug content. Reaction conditions were examined and optimised. Titrimetry is based on a 1:3 stoichiometric reaction between albendazole and chloramine-T and is applicable in the range of 1-15 mg. In spectrophotometry, the absorbance was found to decrease linearly with increasing concentration of albendazole, which is corroborated by the calculated correlation coefficient value of -0.9998. The system obeys Beer's law for 2.5-25 microg x ml(-1) of albendazole. The molar absorptivity and Sandell sensitivity were calculated to be 6.24 x 10(3) l mol(-1) cm(-1) and 42.54 ng cm(-2), respectively. The limits of detection and quantification were calculated to be 1.15 and 3.83 microg x ml(-1), respectively. The proposed methods were successfully applied to the determination of albendazole in commercially available dosage forms. The reliability of the assays was established by parallel determination by the official method and recovery studies.

Application of potassium dichromate and iron-thiocyanate in the spectrophotometric investigations of phenothiazines

A spectrophotometric procedure for the determination of phenothiazines in pure form and in a number of their pharmaceutical preparations has been developed that offers the advantages of simplicity, accuracy, precision and sensitivity over many other methods. The method is based on the oxidation of phenothiazines by a known excess amount of potassium dichromate followed by the estimation of unreacted amount of dichromate by reacting with excess of iron(II) and measuring the iron(III) formed by complexing with thiocyanate. The reacted oxidant corresponds to the drug content. Different variables affecting the reaction between drugs and dichromate were studied and optimized. At the maximum absorption of 480 nm, Beer's law is obeyed in the range 2.5-29.75 microg/ml. The molar absorptivity and Sandell sensitivity of the procedure were calculated in addition to detection limit. Statistical treatment of the experimental results indicates that the procedure is precise and accurate. Excipients used as additives in pharmaceutical formulations did not interfere in the proposed procedure. The reliability of the method was established by parallel determination against the official BP methods. The procedure described was successfully applied to the determination of the bulk drugs and in pharmaceutical formulations.