Modification of surface and mechanical properties of polyethylene by photo-initiated reactions

Effect of UV-irradiation intensity on graft polymerization of 2-methacryloyloxyethyl phosphorylcholine on orthopedic bearing substrate

Photoinduced grafting of 2-methacryloyloxyethyl phosphorylcholine (MPC) onto cross-linked polyethylene (CLPE) was investigated for its ability to reduce the wear of orthopedic bearings. We investigated the effect of UV-irradiation intensity on the extent of poly(MPC) (PMPC) grafting, and found that it increased with increasing intensity up to 7.5 mW/cm(2), and the remained fairly constant. It was found to be extremely important to carefully control the UV intensity, as at higher values, a PMPC gel formed via homopolymerization of the MPC, resulting in the formation of cracks at the interface of the PMPC layer and the CLPE substrate. When the CLPE was exposed to UV-irradiation during the graft polymerization process, some of its physical and mechanical properties were slightly changed due to cross-linking and scission effects in the surface region; however, the results of all of the tests exceed the lower limits of the ASTM standards. Modification of the CLPE surface with the hydrophilic PMPC layer increased lubrication to levels that match articular cartilage. The highly hydrated thin PMPC films mimicked the native cartilage extracellular matrix that covers synovial joint surface, acting as an extremely efficient lubricant, and providing high-wear resistance.

Solid-phase photocatalytic degradation of polyethylene-goethite composite film under UV-light irradiation

A novel photodegradable polyethylene-goethite (PE-goethite) composite film was prepared by embedding the goethite into the commercial polyethylene. The degradation of PE-goethite composite films was investigated under ultraviolet light irradiation. The photodegradation activity of the PE plastic was determined by monitoring its weight loss, scanning electron microscopic (SEM) analysis and FT-IR spectroscopy. The weight of PE-goethite (1 wt%) sample steadily decreased and led to the total 16% reduction in 300 h under UV-light intensity for 1 mW/cm(2). Through SEM observation there were some cavities around the goethite powder in the composite films, but there were few changes except some surface chalking phenomenon in pure PE film. The degradation rate could be controlled by changing the concentration of goethite particles in PE plastic. The degradation of composite plastic initiated on PE-goethite interface and then extended into polymer matrix induced by the diffusion of the reactive oxygen species generated on goethite particle surface. The photocatalytic degradation mechanism of the composite films was briefly discussed.