Report of the "Bioterrorism Workshop." Duke University Thomas Center on April 2-4, 2002, organized by US Army Research Office

Mass spectrometry in biodefense

Potential agents for biological attacks include both microorganisms and toxins. In mass spectrometry (MS), rapid identification of potential bioagents is achieved by detecting the masses of unique biomarkers, correlated to each agent. Currently, proteins are the most reliable biomarkers for detection and characterization of both microorganisms and toxins, and MS-based proteomics is particularly well suited for biodefense applications. Confident identification of an organism can be achieved by top-down proteomics following identification of individual protein biomarkers from their tandem mass spectra. In bottom-up proteomics, rapid digestion of intact protein biomarkers is again followed by MS/MS to provide unambiguous bioagent identification and characterization. Bioinformatics obviates the need for culturing and rigorous control of experimental variables to create and use MS fingerprint libraries for various classes of bioweapons. For specific applications, MS methods, instruments and algorithms have also been developed for identification based on biomarkers other than proteins and peptides.

Piezoelectric-excited millimeter-sized cantilever (PEMC) sensors detect Bacillus anthracis at 300spores/mL

Piezoelectric-excited millimeter-sized cantilever (PEMC) sensors consisting of a piezoelectric and a borosilicate glass layer with a sensing area of 2.48 mm2 were fabricated. Antibody specific to Bacillus anthracis (BA, Sterne strain 7702) spores was immobilized on PEMC sensors, and exposed to spores (300 to 3x10(6) spores/mL). The resonant frequency decreased at a rate proportional to the spore concentration and reached a steady state frequency change of 5+/-5 Hz (n=3), 92+/-7 Hz (n=3), 500+/-10 Hz (n=3), 1030+/-10 Hz (n=2), and 2696+/-6 Hz (n=2) corresponding to 0, 3x10(2), 3x10(3), 3x10(4), and 3x10(6) spores/mL, respectively. The reduction in resonant frequency is proportional to the change in cantilever mass, and thus the observed changes are due to the attachment of spores on the sensor surface. Selectivity of the antibody-functionalized sensor was determined with samples of BA (3x10(6)/mL) mixed with Bacillus thuringiensis (BT; 1.5x10(9)/mL) in various volume ratios that yielded BA:BT ratios of 1:0, 1:125, 1:250, 1:500 and 0:1. The corresponding resonance frequency decreases were, respectively, 2345, 1980, 1310, 704 and 10 Hz. Sample containing 100% BT spores (1.5x10(9)/mL and no BA) gave a steady state frequency decrease of 10 Hz, which is within noise level of the sensor, indicating excellent selectivity. The observed binding rate constant for the pure BA and BT-containing samples ranged from 0.105 to 0.043 min-1 in the spore concentration range 300 to 3x10(6)/mL. These results show that detection of B. anthracis spore at a very low concentration (300 spores/mL) and with high selectivity in presence of another Bacillus spore (BT) can be accomplished using piezoelectric-excited millimeter-sized cantilever sensors.

Membrane-based on-line optical analysis system for rapid detection of bacteria and spores

We report here the adaptation of our electronic microchip technology towards the development of a new method for detecting and enumerating bacterial cells and spores. This new approach is based on the immuno-localization of bacterial spores captured on a membrane filter microchip placed within a flow cell. A combination of microfluidic, optical, and software components enables the integration of staining of the bacterial species with fully automated assays. The quantitation of the analyte signal is achieved through the measurement of a collective response or alternatively through the identification and counting of individual spores and particles. This new instrument displays outstanding analytical characteristics, and presents a limit of detection of approximately 500 spores when tested with Bacillus globigii (Bg), a commonly used simulant for Bacillus anthracis (Ba), with a total analysis time of only 5 min. Additionally, the system performed well when tested with real postal dust samples spiked with Bg in the presence of other common contaminants. This new approach is highly customizable towards a large number of relevant toxic chemicals, environmental factors, and analytes of relevance to clinical chemistry applications.

Development of a novel compact sonicator for cell disruption

Ultrasound microbial cell disrupters operating at around 20 kHz are often physically large and, due to significant heating, can be unsuitable for small sample volumes where biochemical integrity of the extracted product is required. Development of a compact device based on a 63.5-mm diameter, 6.5-mm thick tubular transducer for rapid cell disruption in small-volume samples in a high-intensity acoustic cavitation field with minimal temperature rises is described here. Suspensions of Saccharomyces cerevisiae were exposed to cavitation for various times in the compact device and a 20-kHz probe sonicator. Cell disruption was assessed by protein release and by staining. Yeast cell disruption was greater in the novel 267-kHz sonicator than in the 20-kHz probe sonicator for the same exposure time. A 1-dimensional (1-D) transfer matrix model analysis for piezoelectric resonators was applied to an axial cross-section of the tubular sonicator to predict frequencies of mechanical resonance in the sample volume associated with maximum acoustic pressure. Admittance measurements identified frequencies of electrical resonance. Ultrasonic cavitation noise peaks were detected by a hydrophone at both the mechanical and electrical resonances. Cell breakage efficiency was twice as great in terms of protein released per dissipated watt at the mechanical resonance predicted by the model, compared to those at the electrical resonance frequencies. The results form a basis for rational design of an ultrasound cell disruption technique for small-volume samples.

Carbohydrates and glycoproteins of Bacillus anthracis and related bacilli: targets for biodetection

The spore is the form released in a bioterrorism attack. There is a real need for definition of new targets for Bacillus anthracis that might be incorporated into emerging biodetection technologies. Particularly of interest are macromolecules found in B. anthracis that are (1) spore-specific, (2) readily accessible on the spore surface and (3) distinct from those present in related organisms. One of the few biochemical methods to identify the spores of B. anthracis is based on the presence of rhamnose and 3-O-methyl rhamnose as determined by gas chromatography-mass spectrometry. Related organisms additionally contain 2-O-methyl rhamnose and fucose. Carbohydrates and glycoproteins of the B. cereus group of organisms and the related B. subilis group are reviewed here. It is hypothesized that the spore-specific carbohydrate is a component of the newly described glycoprotein of the exosporium of B. anthracis. Further work to define the protein and carbohydrate components of the glycoprotein of B. anthracis could be highly useful in developing new technologies for rapid biodetection.