Assessment of arterial stenosis in a flow model with power Doppler angiography: accuracy and observations on blood echogenicity

Morphological Analysis of in Vivo Velocity Field in the Alteration of the Vasomotor Tone

Vessel wall remodeling is involved in atherogenesis and in several important vascular diseases affecting mainly aged and prosthetic implanted patients. This adaptive response to pathological states in arterial hemodynamics strongly suggests that flow-derived stresses act as mechanical stimuli to the release of endothelium-derived vasoactive factors, leading to vascular alterations. As the correlation of intimal hyperplasia (IH) with blood flow alterations in arteries has been shown to be significant, and as it is well-known that clinical procedures carry a substantial risk of development of vascular disease, the relevance of local hemodynamics must be investigated to describe changes in compliance matching in prosthetic applications. The aim of our research is to investigate the use of principal components analysis, together with varimax rotation, in the individuation process of morphological characteristics of real time ultrasound in in vivo recordings of blood flow velocities, as provided by two different carotid perivascular manipulations. This would be of use in the clinical assessment of atherogenesis, hypertension, prosthetic replacement or more in general in all applications in which vascular tone may be impaired. Data recordings refer to previous animal experiments where the Moncada model was investigated by means of an ultrasound profilometer. The present study confirms the feasibility of the proposed analysis to follow vascular pathology evolution, distiguishing between an in progress and a static situation.

Three-dimensional reconstruction of the "bright ring" echogenicity from porcine blood upstream in a stenosed tube

To investigate the echogenicity variation due to blood flow disturbance near a stenosis under pulsatile flow, a series of in vitro experiments were performed in a rigid tube with an eccentric stenosis of 70% area reduction in a mock flow loop. An ultrasonic B-mode with a Doppler spectrogram was used to correlate echogenicity with flow speed and stroke rate. This paper reports echogenicity variation upstream of a stenosis under pulsatile flow. The experimental results showed that blood flow disturbed by the stenosis affects echogenicity and red blood cell rouleaux upstream. A hypoechoic "black hole" was shown at the center of the stream at systole. During diastole, the "bright ring" in cross-sectional images was observed as eddy-like or parabolic profiles in longitudinal images. These images could be reconstructed into a 3-dimensional animation, providing a better understanding of dynamic changes of the rouleaux distribution upstream of a stenosis under pulsatile flow.

Determining the relationship between three-dimensional power Doppler data and true blood flow characteristics: an in-vitro flow phantom experiment

OBJECTIVES

Three-dimensional (3D) ultrasound can be used to acquire power Doppler data which can be quantified to give an objective impression about blood flow within a tissue or organ. Proprietary software can be used to calculate three indices of vascularity: vascularization index (VI), flow index (FI) and vascularization flow index (VFI). Although these indices appear to have a predictive value in the clinical setting and can be shown to vary between different patient populations and over time within the same population, their relationship with true in-vivo blood flow characteristics has not been established. The objective was to examine the effect of flow rate, vessel number, attenuation and erythrocyte density on these indices.

METHODS

A computer-driven flow phantom was used to continuously pump a nylon particle-based blood mimic (Orgasol(trade mark)) around a closed system through three different ultrasound test tanks. These tanks were designed specifically for these experiments and contained C-Flex(trade mark) tubing, in a variety of arrangements, encased in an agar-based tissue mimic. The test tanks were insonated with a modified 3D transvaginal 4-8-MHz ultrasound transducer and 3D power Doppler data were then acquired over a graduated series of flow rates, depths and blood mimic concentrations. Regression analysis was used to determine the resulting relationships.

RESULTS

The VI increased linearly with an increase in flow rate (P < 0.05), whereas the FI increased in a cubic manner with a more rapid initial increase (P < 0.05). The VI demonstrated a similar linear increase with an increase in the erythrocyte mimic density (P < 0.05), whereas the FI increased markedly with a small change in erythrocyte mimic density and then plateaued (P < 0.01). There was a significant reduction in each index as the distance between the transducer and vessel increased (P < 0.05). Patterns similar to those seen in relation to the change in flow rate were evident, with a more linear relationship between depth and the VI and VFI than between depth and the FI, although the FI remained relatively constant and was not significantly affected by distance from the transducer until a depth of 55 mm was reached. Although a positive linear relationship was seen between vessel number and VI and VFI (P < 0.05) the FI demonstrated a very different and complex, cubic relationship (P < 0.001), increasing linearly until a maximum of three vessels were present when it decreased, and no overall correlation was seen (P > 0.05).

CONCLUSIONS

The VI, FI and VFI are all significantly affected by volume flow, attenuation, vessel number and erythrocyte density, but in different ways. The VI and VFI seem to have a more predictable relationship, whereas the FI often demonstrates a more complex cubic relationship that is not always logical. Further work is required to establish the effect of other confounding parameters before valid conclusions may be made and a better understanding of 3D power Doppler ultrasound imaging achieved.

Evaluation of the effect of machine settings on quantitative three-dimensional power Doppler angiography: an in-vitro flow phantom experiment

OBJECTIVES

Three-dimensional (3D) ultrasound is being used increasingly to acquire and subsequently quantify power Doppler data within the clinical setting. One proprietary software package calculates three 3D vascular indices: the vascularization index (VI), the flow index (FI), and the vascularization flow index (VFI). Our aim was to evaluate how different settings affect the Doppler signal in terms of its quantification by these three indices within a 3D dataset.

METHODS

A computer-driven 'flow phantom' was used to continuously pump a nylon particle-based blood mimic (Orgasol(trade mark)) around a closed system through a C-flex(trade mark) tube embedded in an agar-based tissue mimic. The test tanks were insonated with a modified 3D transvaginal 4-8-MHz ultrasound transducer (V530D) and power Doppler data were acquired over a series of different settings. Each experiment involved the manipulation of just one Doppler setting in order to study it in isolation.

RESULTS

As expected, all of the power Doppler settings, when altered, were found to effect significant changes (P < 0.05) in the VI, FI and VFI. The gain and signal power had the greatest effect, producing no Doppler signals at the lowest settings and the highest recordable indices at the maximum settings. The pulse repetition frequency (PRF) was the next most influential setting but a Doppler signal was seen and measurable at all of the different settings. The other Doppler settings had a much less profound effect on the vascular indices, with subtle but significantly different measures across the full range of settings. The speed of data acquisition was also found to affect the vascular indices, all of which were reduced when the fast mode was used although the only significant effect was on the VFI.

CONCLUSIONS

The VI, FI and VFI are all affected significantly by variations in power Doppler settings and by the speed of acquisition. The gain and signal power have the greatest effect on the power Doppler signal, followed closely by the PRF. The other settings and speed of acquisition also influence the signal, but to a much lesser degree. It is essential to maintain Doppler settings if any meaningful comparisons are to be made within and between subjects.

Simulation and validation of arterial ultrasound imaging and blood flow

We reviewed the simulation and validation of arterial ultrasound imaging and blood flow assessment. The physical process of ultrasound imaging and measurement is complex, especially in disease. Simulation of physiological flow in a phantom with tissue equivalence of soft tissue, vessel wall and blood is now achievable. Outstanding issues are concerned with production of anatomical models, simulation of arterial disease, refinement of blood mimics to account for non-Newtonian behavior and validation of velocity measurements against an independent technique such as particle image velocimetry. String and belt phantoms offer simplicity of design, especially for evaluation of velocity estimators, and have a role as portable test objects. Electronic injection and vibrating test objects produce nonphysiologic Doppler signals, and their role is limited. Computational models of the ultrasound imaging and measurement process offer considerable flexibility in their ability to alter multiple parameters of both the propagation medium and ultrasound instrument. For these models, outstanding issues are concerned with the inclusion of different tissue types, multilayer arteries, inhomogeneous tissues and diseased tissues.

Ultrasonic observation of blood disturbance in a stenosed tube: effects of flow acceleration and turbulence downstream

Red blood cell (RBC) aggregation is known to be highly dependent on hemodynamic parameters such as shear rate, flow turbulence and flow acceleration under pulsatile flow. The effects of all three hemodynamic parameters on RBC aggregation and echogenicity of porcine whole blood were investigated downstream of an eccentric stenosis in a mock flow loop using B-mode images with Doppler spectrograms of a commercial ultrasonic system. A hyperechoic parabolic profile appeared downstream during flow acceleration, yielding another piece of evidence suggesting that the enhancement of rouleaux formation may be caused by flow acceleration. It was also found that echogenicity increased locally at a distance of three tube diameters downstream from the stenosis. The local increase of echogenicity is thought to be mainly due to flow turbulence. The hypoechoic "black hole" was also seen at the center of the tube downstream of the stenosis where blood flow was disturbed, and this may be caused by the compound effect of flow turbulence and shear rate.

Signal losses with real-time three-dimensional power Doppler imaging

Power Doppler imaging (PDI) has been shown to be influenced by the wall filter when assessing arterial stenoses. Real-time 3-D Doppler imaging may likely become a widespread practice in the near future, but how the wall filter could affect PDI during the cardiac cycle has not been investigated. The objective of the study was to demonstrate that the wall filter may produce unexpected major signal losses in real-time 3-D PDI. To test our hypothesis, we first validated binary images obtained from analytical simulations with in vitro PDI acquisitions performed in a tube under pulsatile flow conditions. We then simulated PDI images in the presence of a severe stenosis, considering physiological conditions by finite element modeling. Power Doppler imaging simulations revealed important signal losses within the lumen area at different instants of the flow cycle, and there was a very good concordance between measured and predicted PDI binary images in the tube. Our results show that the wall filter may induce severe PDI signal losses that could negatively influence the assessment of vascular stenosis. Clinicians should therefore be aware of this cause of signal loss to properly interpret power Doppler angiographic images.

Finite element modelling and simulations in cardiovascular mechanics and cardiology: A bibliography 1993–2004

The paper gives a bibliographical review of the finite element modelling and simulations in cardiovascular mechanics and cardiology from the theoretical as well as practical points of views. The bibliography lists references to papers, conference proceedings and theses/dissertations that were published between 1993 and 2004. At the end of this paper, more than 890 references are given dealing with subjects as: Cardiovascular soft tissue modelling; material properties; mechanisms of cardiovascular components; blood flow; artificial components; cardiac diseases examination; surgery; and other topics.

Numerical and experimental models of post-operative realistic flows in stenosed coronary bypasses

By means of both experimental and finite element methods, we simulated three-dimensional unsteady flows through coronary bypass anastomosis. The host artery includes a stenosis shape located at two different distances of grafting. The inflow rates are issued from in vivo measurements in patients who had undergone coronary bypass surgery a few days before. We provide a comparison between experimental and numerical velocity profiles coupled with the numerical analysis of spatial and temporal wall shear stress evolution. The interaction between the graft and coronary flows has been demonstrated. The phase inflow difference can partly be responsible for specific flow phenomena: jet deflection towards a preferential wall or feedback phenomenon that causes the flapping of the post-stenotic jet during the cardiac cycle. In conclusion, we showed the sensitivity of these typical flows to distance of grafting, inflows waveforms but also to their phase difference.