Streaming potential through and on ultrafiltration membranes

Surface Zeta Potential of ALD-Grown Metal-Oxide Films

Membranes are among the most promising technologies for energy-efficient and highly selective separations, and the surface-charge property of membranes plays a critical role in their broad applications. Atomic layer deposition (ALD) can deposit materials uniformly and with high precision and controllability on arbitrarily complex and large substrates, which renders it a promising method to tune the electrostatics of water/solid interfaces. However, a systematic study of surface-charge properties of ALD-grown films in aqueous environments is still lacking. In this work, 17 ALD-grown metal-oxide films are synthesized, and a comprehensive study of their water stability, wetting properties, and surface-charge properties is provided. This work represents a resource guide for researchers and ultimately for materials and process engineers, seeking to tailor interfacial charge properties of membranes and other porous water treatment components.

Study on transmembrane electrical potential of nanofiltration membranes in KCl and MgCl2 solutions

The transmembrane electrical potential (TMEP) across two commercial nanofiltration membranes (ESNA1-K and Filmtec NF) was investigated in KCl and MgCl(2) solutions. TMEP was measured in a wide range of salt concentrations (1-60 mol·m(-3)) and pH values (3-10) at the feed side, with pressure differences in the range of 0.1-0.6 MPa. A two-layer model based on the Nernst-Planck equation was proposed to describe the relation between TMEP and permeation flux. From the pattern of these curves, the information of membrane structure could be deduced. In the concentration range investigated, TMEP in KCl solutions was always positive and decreased as the salt concentration increased. The contribution of the membrane potential to the TMEP decreased. TMEP was greatly affected by the feed pH. When the feed pH increased, the mobility of cations increased, which indicated that the charges of NF membranes were more negative. The zero point of TMEP and the minimum of rejection in KCl solution were consistent and occurred at the isoelectric point of NF membranes, while in MgCl(2) solution the zero point of TMEP located at a higher pH value. The TMEP in MgCl(2) solutions changed its sign at a given concentration, and by calculating the transport number the location of the minimum rejection could be determined.

Comparison of the volume charge density of nanofiltration membranes obtained from retention and conductivity experiments

A version of the Donnan steric-partitioning pore model with dielectrical exclusion (DSPM-DE) has been used to get information on the pore size and charge density of a commercial membrane, NF45 from FilmTec, from its retention of KCl solutions. The conductivity inside the pores has been measured by impedance spectroscopy, and the electric potential drop during retention experiments has also been measured. These experimental data on conductivity and electric potential are analyzed, by using the thermodynamics of irreversible processes and the space charge model, to obtain the pore charge density of the membrane. These two methods give results in fair accordance which probes that the sometimes controversial method of DSPM-DE can give accurate results for the charge as well as for the mean pore size of a nanofiltration membrane. Some clues to improve the way this model can be used are given as well.

Transport properties and electrokinetic characterization of an amphoteric nanofilter

Transport properties of a tubular nanofilter with amphoteric properties have been investigated by means of the SEDE (steric, electric, and dielectric exclusion) homogeneous model. Within the scope of this 1D model, the separation of solutes results from transport effects (described by means of extended Nernst-Planck equations) and interfacial phenomena including steric hindrance, the Donnan effect, and dielectric exclusion (expressed in terms of (i) the Born dielectric effect, which is connected to the lowering of the dielectric constant of a solution inside nanodimensional pores, and (ii) the interaction between ions and the polarization charges induced at the dielectric boundary between the pore walls and the pore-filling solution). The effective volume charge density of the membrane has been determined from tangential streaming potential experiments coupled with conductance experiments in a potassium chloride solution at various pH values ranging from 2 to 11. The inferred values have been used in the SEDE model to compute the ion rejection rates with the dielectric constant of the solution inside the pores as a single adjustable parameter. The model provides a relatively good description of experimental data even at extreme pH values for which a ternary system has been considered (K+, Cl-, and H+ or OH- depending on the pH). The fit to experimental data at the membrane isoelectric point indicates that the confinement effect decreases the dielectric constant inside the pores only slightly (with respect to its bulk value). However, the (pH-dependent) ionization of surface sites has been found to lead to a substantial lowering of the dielectric constant inside the pores.

Analysis of the pressure-induced potential arising through composite membranes with selective surface layers

When a pressure gradient is applied through a charged selective membrane, the transmembrane electrical potential difference, called the filtration potential, results from both the applied pressure and induced concentration difference across the membrane. In this work we investigate the electrokinetic properties relative to both active and support layers of a composite ceramic membrane close to the nanofiltration range. First, the volume charge density of the active layer is obtained by fitting a transport model to experimental rejection rates (which are controlled by the active layer only). Next, the value of the volume charge density is used to compute the theoretical filtration potential through the active layer. For sufficiently high permeate volume fluxes, the concentration difference across the active layer becomes constant, which allows assessing the membrane potential of the active layer. Experimental measurements of the overall filtration potential arising through the whole membrane are performed. The contribution of the support layer to this overall filtration potential is put in evidence. That implies that the membrane potential of the active layer cannot be deduced directly from the overall filtration potential measurements. Finally, the contribution of the support layer is singled out by subtracting the theoretical filtration potential of the active layer from the experimental filtration potential measured across the whole membrane (i.e., support + active layers). The amphoteric behavior of both layers is put in evidence, which is confirmed by electrophoretic measurements carried out with the powdered support layer and by recently reported tangential streaming potential measurements.