Multi-channel magnetic resonance spectroscopy through time domain multiplexing

A 16-Channel 13C Array Coil for Magnetic Resonance Spectroscopy of the Breast at 7T

OBJECTIVE

Considering the reported elevation of ω-6/ω-3 fatty acid ratios in breast neoplasms, one particularly important application of ¹³C MRS could be in more fully understanding the breast lipidome's relationship to breast cancer incidence. However, the low natural abundance and gyromagnetic ratio of the ¹³C isotope lead to detection sensitivity challenges. Previous ¹³C MRS studies have relied on the use of small surface coils with limited field-of-view and shallow penetration depths to achieve adequate signal-to-noise ratio (SNR), and the use of receive array coils is still mostly unexplored.

METHODS

This work presents a unilateral breast 16-channel ¹³C array coil and interfacing hardware designed to retain the surface sensitivity of a single small loop coil while improving penetration depth and extending the field-of-view over the entire breast at 7T. The coil was characterized through bench measurements and phantom ¹³C spectroscopy experiments.

RESULTS

Bench measurements showed receive coil matching better than -17 dB and average preamplifier decoupling of 16.2 dB with no evident peak splitting. Phantom MRS studies show better than a three-fold increase in average SNR over the entirety of the breast region compared to volume coil reception alone as well as an ability for individual array elements to be used for coarse metabolite localization without the use of single-voxel or spectroscopic imaging methods.

CONCLUSION

Our current study has shown the benefits of the array. Future in vivo lipidomics studies can be pursued.

SIGNIFICANCE

Development of the 16-channel breast array coil opens possibilities of in vivo lipidomics studies to elucidate the link between breast cancer incidence and lipid metabolics.

A Review of Non-1H RF Receive Arrays in Magnetic Resonance Imaging and Spectroscopy

It is now common practice to use radiofrequency (RF) coils to increase the signal-to-noise ratio (SNR) in 1H magnetic resonance imaging and spectroscopy experiments. Use of array coils for non-1H experiments, however, has been historically more limited despite the fact that these nuclei suffer inherently lower sensitivity and could benefit greatly from an increased SNR. Recent advancements in receiver technology and increased support from scanner manufacturers have now opened greater options for the use of array coils for non-1H magnetic resonance experiments. This paper reviews the research in adopting array coil technology with an emphasis on studies of the most commonly studied non-1H nuclei including 31P, 13C, 23Na, and 19F. These nuclei offer complementary information to 1H imaging and spectroscopy and have proven themselves important in the study of numerous disease processes. While recent work with non-1H array coils has shown promising results, the technology is not yet widely utilized and should see substantial developments in the coming years.

Flexible RF Filtering Front-End For Simultaneous Multinuclear MR Spectroscopy

Simultaneously interrogation of multiple nuclei has been of interest since the very earliest days of MRI [1]-[3]. Our group and several others are revisiting this topic [4]-[6]. Very fast broadband electronics make it possible to digitize a wide spectrum, including multiple nuclei, but this places great demands on data throughput. Another issue is that there can be great variance between RF preamplifier gain required for the different nuclei. To overcome the data problem, it is desirable to use undersampling, but this requires passband filtering around the resonant frequency of each nuclei. Here we present a frequency agile front end that provides separate data paths for each nucleus, either from a single coil or from multiple ports, allows independent gain, filters each using very flexible transmission line filtering, and then combines them back for undersampling.

The rapid and automatic combination of proton MRSI data using multi-channel coils without water suppression

The use of multi-channel coils can efficiently increase the signal-to-noise ratio (SNR) of magnetic resonance spectroscopy data if the signals from multiple channels are optimally combined. Combining multi-channel signals requires proper alignment of the phases of the signals from each of the elements of the coil and then accurately weighting the summation of those signals. We present a procedure for acquiring proton magnetic resonance spectroscopic imaging (MRSI) data using an eight-channel coil without water suppression and a rapid and robust method that uses unsuppressed water signal as a reference both for aligning the phases and for weighting the summation of signals that originate in the multiple coil elements. We use both computer simulation and in vivo proton MRSI data to demonstrate the advantages of our method for optimizing the SNR of the combined signal compared with the SNRs of signals that were acquired either using a standard volume head coil or using an eight-channel coil with a metabolite signal as the reference for combination.

Four-channel magnetic resonance imaging receiver using frequency domain multiplexing

An alternative technique that uses frequency domain multiplexing to acquire phased array magnetic resonance images is discussed in detail. The proposed method has advantages over traditional independent receiver chains in that it utilizes an analog-to-digital converter and a single-chip multicarrier receiver with high performance to reduce the size and cost of the phased array receiver system. A practical four-channel digital receiver using frequency domain multiplexing was implemented and verified on a home-built 0.3 T magnetic resonance imaging system. The experimental results confirmed that the cross talk between each channel was below -60 dB, the phase fluctuations were about 1 degrees , and there was no obvious signal-to-noise ratio degradation. It is demonstrated that the frequency domain multiplexing is a valuable and economical technique, particularly for array coil systems where the multichannel receiver is indispensable and dynamic range is not a critical problem.

Relative RF coil performance in carotid imaging

PURPOSE

Computer simulations and measurements on human volunteers were used to test the extent to which the quality of carotid imaging might be improved by coil arrays that are not limited by a constraint on the number of RF coil receiver ports.

METHODS

Analytic near-field equations for the magnetic and electric fields of a rectangular loop resonator were used to estimate the relative signal-to-noise ratio (rSNR) along the length of a simulated carotid artery as a function of loop size, loop position and vessel depth. The sizes, positions and number of elements in a linear coil array that resulted in the maximum composite SNR along the length of a simulated carotid artery were then estimated. The linear array results were used to predict the total number of elements needed for optimal imaging of the carotid arteries. Also, three normal volunteers were imaged with a variety of RF coils, and the rSNR measurements along the lengths of the carotid artery were evaluated for each coil combination.

RESULTS

The analytic simulation and the human volunteer measurements both show that improved SNR (e.g., >300% at the bifurcation) can be obtained with coils tailored to each specific region of the carotid artery in comparison to that obtained with four-element arrays designed and used to image the entire carotid artery.

CONCLUSIONS

The resulting number of coil ports, 16 to 24, required for full coverage of the carotid arteries is consistent with the number of channels just becoming available on recently developed clinical scanners.