Direct pressure measurements in a hyaluronan ultrafiltration concentration polarization layer

Concentration polarization of hyaluronan on the surface of the synovial lining of infused joints

Hyaluronan (HA) in joints conserves the lubricating synovial fluid by making trans-synovial fluid escape almost insensitive to pressure elevation (e.g. effusions, joint flexion). This phenomenon, 'outflow buffering', was discovered during HA infusion into the rabbit knee joint cavity. It was also found that HA is partially reflected by the joint lining (molecular sieving), and that the reflected fraction R decreases as trans-synovial filtration rate Q is increased. It was postulated therefore that outflow buffering is mediated by HA reflection. Reflection creates a HA concentration polarization layer, the osmotic pressure of which opposes fluid loss. A steady-state, cross-flow ultrafiltration model was previously used to explain the outflow buffering and negative R-vs.-Q relation. However, the steady-state, cross-perfusion assumptions restricted the model's applicability for an infused, dead-end cavity or a non-infused joint during cyclical motion. We therefore developed a new, non-steady-state model which describes the time course of dead-end, partial HA ultrafiltration. The model describes the progressive build-up of a HA concentration polarization layer at the synovial surface over time. Using experimental parameter values, the model successfully accounts for the observed negative R-vs.-Q relation and shows that the HA reflected fraction (R) also depends on HA diffusivity, membrane area expansion and the synovial HA reflection coefficient. The non-steady-state model thus explains existing experimental work, and it is a key stage in understanding synovial fluid turnover in intact, moving, human joints or osteoarthritic joints treated by HA injections.

Filtration rate dependence of hyaluronan reflection by joint-to-lymph barrier: evidence for concentration polarisation

Hyaluronan (HA), a component of synovial fluid, buffers fluid loss from joints. To explain this, a quantitative theory for HA concentration polarisation at a partially sieving synovial lining was developed. The theory predicts a fall in HA reflected fraction R with increased filtration rate. To test this, knees of anaesthetised rabbits were infused with HA and fluorescein-dextran (FD) at constant trans-synovial filtration rates of 6-89 microl min(-1). Samples of femoral lymph, mixed intra-articular fluid and subsynovial fluid after >/= 3 h were analysed by high-performance liquid chromatography. R was calculated as (1 - downstream/upstream concentration), using [FD] to adjust for joint lymph dilution in femoral lymph. Intra-articular HA concentration after >/= 3 h, 0.47 +/- 0.02 mg ml(-1) (mean +/-s.e.m., n= 31), exceeded the infusate concentration, 0.20 mg ml(-1), while subsynovial and lymph [HA] were reduced relative to [FD]. The changes in [HA] demonstrated synovial molecular sieving of HA. R from cavity to lymph (R(lymph)) fell monotonically from 0.93 at 6 microl min(-1) to 0.14 at 89 microl min(-1) (P < 0.0001, regression analysis, n= 33). R values calculated from the intra-articular HA accumulation (R(asp)) or the low subsynovial concentrations (R(syn)) were similar negative functions of filtration rate. R for lymphatic capillary endothelium (R(endo)), calculated from lymph/subsynovial concentration ratios, was effectively zero (-0.03 +/- 0.18, n= 21), confirming that synovium, not initial lymphatic endothelium, is the reflection site. Logarithmic linearisation of the results evaluated the synovial HA reflection coefficient as 0.91. In conclusion, the existence of concentration polarisation during joint fluid drainage was supported by the demonstration of a negative relation between filtration rate and R(lymph), R(asp) and R(syn).

In situ monitoring techniques for concentration polarization and fouling phenomena in membrane filtration

Membrane fouling and subsequent permeate flux decline are inevitably associated with pressure-driven membrane processes. Despite the myriad of studies on membrane fouling and related phenomena--concentration polarization, cake formation and pore plugging--the fundamental mechanisms and processes involved are still not fully understood. A key to breakthroughs in understanding of fouling phenomena is the development of novel, non-invasive, in situ quantification of physico-chemical processes occurring during membrane filtration. State-of-the-art in situ monitoring techniques for concentration polarization, cake formation and fouling phenomena in pressure-driven membrane filtration are critically reviewed in this paper. The review addresses the physical principles and applications of the techniques as well as their strengths and deficiencies. Emphasis is given to techniques relevant to fouling phenomena where particles and solutes accumulate on the membrane surface such that pore plugging is negligible. The relevance of the techniques to specific processes and mechanisms involved in membrane fouling is also elaborated and discussed.