Dosimetry studies in Zaborie village

EPR dosimetry with tooth enamel: A review

When tooth enamel is exposed to ionizing radiation, radicals are formed, which can be detected using electron paramagnetic resonance (EPR) techniques. EPR dosimetry using tooth enamel is based on the (presumed) correlation between the intensity or amplitude of some of the radiation-induced signals with the dose absorbed in the enamel. In the present paper a critical review is given of this widely applied dosimetric method. The first part of the paper is fairly fundamental and deals with the main properties of tooth enamel and some of its model systems (e.g., synthetic apatites). Considerable attention is also paid to the numerous radiation-induced and native EPR signals and the radicals responsible for them. The relevant methods for EPR detection, identification and spectrum analyzing are reviewed from a general point of view. Finally, the needs for solid-state modelling and studies of the linearity of the dose response are investigated. The second part is devoted to the practical implementation of EPR dosimetry using enamel. It concerns specific problems of preparation of samples, their irradiation and spectrum acquisition. It also describes how the dosimetric signal intensity and dose can be retrieved from the EPR spectra. Special attention is paid to the energy dependence of the EPR response and to sources of uncertainties. Results of and problems encountered in international intercomparisons and epidemiological studies are also dealt with. In the final section the future of EPR dosimetry with tooth enamel is analyzed.

Dose reconstruction by EPR spectroscopy of tooth enamel: application to the population of Zaborie village exposed to high radioactive contamination after the Chernobyl accident

Individual irradiation doses were determined by electron paramagnetic resonance spectroscopy of the tooth enamel of the inhabitants of Zaborie, the most contaminated inhabited settlement not evacuated after the Chernobyl accident. Dose determination was performed using a specially developed automatic spectrum processing procedure. Spectrum processing was carried out in different operating modes, and average results were taken in order to reduce the contribution of uncertainty in dose determination caused by spectrum processing. The absorbed doses determined in enamel were corrected to take into account the contribution of natural background radiation and to determine the individual excess dose due to radioactive contamination of the territory. Individual excess doses are compared to calculated individualized doses to teeth, estimated using the local radioactive contamination levels, dose rates, and information concerning individual behavior. The individual excess doses measured by electron paramagnetic resonance spectroscopy and the calculated individualized doses are fully independent. Mean square variation between results of two methods was found to be 34 mGy, which is consistent with error estimation for both methods. This result can validate both the methodology of signal processing presented here when using electron paramagnetic resonance dosimetry of tooth enamel for low doses and the methodology of individualized dose calculation.