Infrared (IR) stimulated luminescence from modern bricks in retrospective dosimetry applications

The use of portable OSL and IRSL measurements of NaCl in low dose assessments following a radiological or nuclear emergency

During recovery phases following a nuclear or radiological incident analyses of doses received by members of the public and responders are often required. Several methods have been investigated for use at different timescales after the incident, including assessments based on measurements of materials present at the time of the incident. Common salt has previously been shown to have potential for retrospective dosimetry in the mGy dose range using laboratory instrumentation. This preliminary study investigates the use of portable instruments, with unprepared commercially sourced salt, in dose ranges below 100 μGy. Responses from pulsed IRSL and portable OSL instruments were compared. For OSL measurements, detection limits of 7 μGy have been demonstrated, with detection limits of 30-340 μGy for the other instruments investigated. Dose responses in the 0-500 μGy range were determined for the most sensitive systems, which show a linear response over this dose range with a non-zero intercept representing doses received from environmental sources since manufacture of the salt. For use as a dosimeter, methods of removing or accounting for inherited signals will be required in this low dose range. The results demonstrate that salt has considerable potential for use in retrospective dosimetry below 100 μGy, and that measurements can be conducted with portable OSL instruments.

Ceramic based electronic component as retrospective radiation dosimeter

Surface mount electronic devices (like resistors, capacitors, and inductors) extracted from the portable electronic devices (mobile phones, USB drives, etc.) have been studied for dose reconstruction using luminescence techniques for radiological or nuclear emergencies. In this work, carbon coated ceramic resistors removed from the electronic instruments are analyzed using thermo luminescence (TL) technique for the retrospective dose reconstruction. TL measurements on beta irradiated ceramic resistors exhibited one major dosimetric peak at around 540 K in addition to three other low temperature peaks. A linear beta dose response has been observed from 1 Gy to 125 Gy with Minimum Detectable Dose (MDD) of 0.1 Gy. The dose response is found to be supralinear below 1 Gy. The fading studies have been carried out and investigated up to 30 days. The important kinetic parameters for the material like TL trap depth, frequency factor and order of kinetics are evaluated by deconvolution method.

Pulsed Photon-Stimulated Luminescence (PPSL) as a tool in retrospective dosimetry

The analysis of luminescence of minerals extracted from pottery and bricks is a well-known tool in retrospective dosimetry. In the past, the detection limit of this method has been reported to lie in general in the order of magnitude of about 10 mGy. For most applications in accidental dosimetry, this is more than sufficient. Still there are some applications, such as the determination of the natural dose if the samples are comparatively young and the doses involved are small (e.g. in epidemiological studies), where the possibility of determining much smaller doses is desirable. As the detection limit is often defined by the measurement background, in this study the application of the 'SURRC Pulsed Photostimulated Luminescence (PPSL) Irradiated Food Screening System (SURRC PPSL Irradiated Food Screening System)', where the measurement background is suppressed in a very innovative way, was tested for dosimetric purposes. Therefore, the luminescence parameters were determined for a set of nine samples of modern bricks. It was found that depending on individual samples, it was possible to determine values as small as a few 100 microGy. Herewith a new application for the 'SURRC PPSL Irradiated Food Screening System' presented itself and further applications in dose reconstruction became available. As to the dosimetric properties of the sample material, it was found that although all the samples were from different brickmakers and places throughout Germany, surprisingly the luminescence parameters were similar, so that it was possible to define a generalised measurement sequence. An interpretation is given.

Household salt as a retrospective dosemeter using optically stimulated luminescence

The aim of this work was to investigate the potential of a selection of household salts (NaCl) as a retrospective dosemeter for ionising radiation using optically stimulated luminescence (OSL). The OSL-response of five brands of salt to an absorbed dose in the range from 1 mGy to 9 Gy was investigated using a Risø TL/OSL-15 reader and a (60)Co beam, allowing low dose-rate irradiations. The salt was optically stimulated with blue light (lambda = 470 +/- 30 nm) at a constant stimulation power (CW-OSL) of 20 mW cm(-2). A linear dose response relationship was found in the dose range from 1 mGy to about 100 mGy and above that level, the relationship becomes moderately supra-linear, at least up to 9 Gy. Depending on the sensitivity and background signal, the minimum detectable absorbed dose (MDD) for the household salt when kept at sealed conditions varied from 0.2 to 1.0 mGy, for the household salts investigated. In addition to its widespread abundance and availability, the low MDD suggests that household salt should seriously be considered as an emergency dosemeter. However, the OSL-properties of NaCl under normal household usage need to be more properly investigated as well as the variation in sensitivity by the quality of the radiation. A further optimisation of the read-out sequence for various brands of commercially available salt may further improve the sensitivity, in terms of luminescence yield, and the signal reproducibility.