Three-dimensional finite element analysis of skin suture. Part 1: spindle model and S-shaped modified model

The "Sea" should not be operated on in scar revision for "Island-Like" scars

Scars developing on body surfaces not only restrict body movement, but are also problematic from a cosmetic standpoint. Hence, revision is conducted by removing the scar and re-suturing the resultant defects. In performing scar revision, care should be taken to prevent the re-sutured wounds from developing hypertrophy again. Scars often present a pattern where hard, red parts are separated by soft parts in between. As the hard and soft parts may be analogized as islands and seas respectively, we call this the "Island-Like" scar. Two strategies can be taken to treat scars of this type. The first is to remove the entire scar-including both hard and soft parts; the second is to remove only the hard parts and leave the soft parts untouched. The authors conducted a biomechanical study using finite element analyses and found that as a body moves, greater stresses occur in the peri-wound regions with the first strategy than with the second strategy. A wound's likelihood to develop hypertrophy increases as the stresses working on it increase. Hence, it is hypothesized that the second strategy carries less risk of the operated wounds developing re-hypertrophy than the first strategy. Based on this logic, in performing scar revision for scars consisting of hard and soft parts, it is recommended only to remove only hard parts and not to operate on soft parts in between.

Computational and experimental characterization of skin mechanics: identifying current challenges and future directions

The characterization of skin mechanics has many clinical implications and has been an active area of research for the past few decades. Biomechanical models have evolved from earlier empirical models to state-of-the-art structural models that provide linkage between tissue microstructure and macroscopic stress-strain response. To maximize the accuracy and predictive capabilities of such computational models, there is a need to reliably identify often a large number of unknown model parameters. This is critically dependent on the availability of experimental data that cover an extensive range of different deformation modes, and quantification of internal structural features, such as collagen orientation. To this end, future challenges should include the ongoing development of noninvasive instrumentation and imaging modalities for in vivo skin measurements. We highlight the important concept of tightly integrating computational models, instrumentation, and imaging modalities into a single platform to investigate skin biomechanics.

The analysis of forces needed for the suturing of elliptical skin wounds

There is a lack of information regarding the forces required for suturing human wounds. The knowledge of suturing forces serves as complementary information for setting up the limiting geometry when using tissue adhesives and it might also be used in robot-assisted surgery. The main purpose of this paper was to evaluate the forces required for suturing selected skin wounds. An elliptical wound was chosen for our study. In this study a numerical analysis and in vivo experiments were performed. Regarding the numerical models, the maximum forces occurred in the middle of the elliptical wound in all cases. In the case of highest pre-stress used in these analyses the maximal force varied from 0.5 N for the smallest wound (30 × 5 mm) to 1.5 N for the largest wound (30 × 15 mm). The maximum peak force for the wound with a size of 46 × 13 mm was 3.2 N. The minimum peak force for the wound with a size of 36 × 5 mm was 1.1 N.

An investigation of leakage tracts along stressed suture lines in phantom tissue

Suturing is still one of the most important procedures used in trauma and surgery environments. It does however rely on piercing other wise healthy tissue. In doing so channels are opened which may act as conduits for bacteria to enter the body or to allow material such as blood or intestinal bacteria to leak from vessels. This work shows by means of finite element analysis and physical modelling through the use of a phantom that the tension in the suture has a direct bearing on the opening of these channels. It was found that for the phantom the channel cross-sectional area was approximately proportional to the applied tension and suture thread deflection. Leakage channels of up to 0.1mm(2) cross-section were achieved with suture tensions of 120 grammes force. Channels of this size are significantly larger than the bacteria suggesting transmission is theoretically possible.

In vivo experimental testing and model identification of human scalp skin

A comprehensive experimental/numerical procedure is formulated and validated for the in vivo characterization of the mechanical properties of human skin and the simulation of reconstructive surgery. The procedure uses in vivo experimental tests on undermined skin flaps, which can be performed during surgery, a numerical model formulated within the framework of nonlinear finite strain elasticity and a nonlinear parameter identification technique for the calibration of the model from indirect measurements. The procedure is applied to characterize the scalp skin tested in Raposio and Nordström (Skin Res. Technol. 4 (1998) 94). The skin is treated as a time independent, isotropic and hyperelastic membrane and the problem is solved through a finite element discretization. The study highlights that the model parameters can be determined with good accuracy using displacement measurements of a few points in the domain.