Steric factors affecting the discrimination of isomeric and structurally related olefin gases and vapors with a reagent-coated surface acoustic wave sensor

Exploiting Charge-Transfer Complexation for Selective Measurement of Gas-Phase Olefins with Nanoparticle-Coated Chemiresistors

Charge-transfer-mediated olefin-selective sensing by use of chemiresistors (CR) coated with composite films of n-octanethiolate-monolayer-protected gold nanoparticles (C8-MPN) and each of several square-planar PtCl2(olefin)(pyridine) coordination complexes is described. Where the gas-phase olefin analyte differs from that initially coordinated to Pt, olefin substitution occurs and is accompanied by a persistent shift in the composite film resistance. Commensurate changes in film mass are also observed with a similarly coated thickness shear mode resonator. Regeneration is possible by exposure to the initially complexed olefin gas or vapor. If the olefin analyte is the same as that initially coordinated to Pt, then a reversible charge-transfer interaction occurs that is accompanied by a decrease in film resistance (increase in film mass), which recovers spontaneously after removal of the olefin from the atmosphere above the sensor. This behavior differs from that of MPN-coated CRs lacking such Pt complexes, which invariably yield resistance increases upon exposure to nonpolar vapors. Red shifts in the UV-vis absorbance spectra of the PtCl2(olefin)(pyridine) complexes in solution upon addition of free olefin support the hypothesis that Pt-olefin coordination in the composite films creates temporary low-resistance pathways that compete effectively with the concurrent increase in tunneling resistance associated with swelling-induced separation of C8-MPN cores. Structurally analogous non-olefins produce only increases in film resistance. Selective measurement of styrene, ethylene, 1-octene, and 1,3-butadiene is illustrated. Olefin detection limits are reduced as much as 23 000-fold by inclusion of the corresponding Pt complex in the CR interface film. Composite films suffer a gradual loss of selectivity from decomposition of the Pt-olefin complex, apparently facilitated by a Au-Pt charge transfer.

Determination of carbon monoxide using a coated quartz crystal sensor

Carbon monoxide was detected and determined by a piezoelectric quartz crystal sensor coated with nickel(II)-phthalocyanine 50 % (v/v) solution in glycerine. Studies on the effect of temperature, flow rate, and some possible interferents were carried out. Calibration curves, sensor stability (lifetime) and the precision of measurements were also verified. The resulting selectivity is probably due to the coordinative binding between the electronically unsatured metal complexes and the analyte. The analytical curve is linear in the concentration range 0.10 to 1.0 % (v/v).

Effects of temperature and humidity on the performance of polymer-coated surface acoustic wave vapor sensor arrays

The influences of temperature and atmospheric humidity on the performance of an array of eight polymer-coated 158-MHz surface acoustic wave vapor sensors were investigated. Sensitivities to the seven organic vapors examined all exhibited negative Arrhenius temperature dependencies, with responses increasing by factors of 1.5-4.4 on going from 38 to 18 degrees C. The magnitudes of the temperature effects, while generally similar, differed sufficiently among certain sensor-vapor combinations to cause marked changes in vapor response patterns. In addition, it was found that operating identically coated sensors at different temperatures could provide a means for discriminating certain vapors. The changes in sensor responses with temperature agreed reasonably well with those expected assuming ideal vapor sorption behavior and indicated that changes in the moduli of the sensor coatings were not important mediating factors. Responses to relative humidity (RH) from 0 to 85% RH were important even for the nonpolar sensor coatings. Significant changes in the sensitivities to the organic vapors were observed as a function of atmospheric humidity for several sensor-vapor combinations, which, in turn, affected the patterns of responses obtained from the sensor array. Results indicate that small changes in temperature or humidity have a larger effect on baseline stabilities than on the responses to the vapors. Monte Carlo simulations of sensor responses show that the ability to discriminate vapors in binary and ternary mixtures using a four-sensor array remains high regardless of the operating temperature and ambient humidity, provided that temperature-or humidity-induced changes in the response patterns are taken into account.