Resonant Exciton Scattering Reveals Raman Forbidden Phonon Modes in Layered GeS

Tailoring Ultrafast Near-Band Gap Photoconductive Response in GeS by Zero-Valent Cu Intercalation

Zero-valent intercalation of atomic metals into the van der Waals gap of layered materials can be used to tune their electronic, optical, thermal, and mechanical properties. Here, we report the impact of intercalating ∼3 atm percent of zero-valent copper into germanium sulfide (GeS). Advanced many-body calculations predict that copper introduces quasi-localized intermediate band states, and time-resolved THz spectroscopy studies demonstrate that those states have prominent effects on the photoconductivity of GeS. Cu-intercalated GeS exhibits a faster rise of transient photoconductivity and a shorter lifetime of optically injected carriers following near-gap excitation with 800 nm pulses. At the same time, Cu intercalation improves free carrier mobility from 1100 to 1300 cm2 V-1 s-1, which we attribute to the damping of acoustic phonons observed in Brillouin scattering and consequent reduction of phonon scattering.

Stability of mechanically exfoliated layered monochalcogenides under ambient conditions

Monochalcogenides of groups III (GaS, GaSe) and VI (GeS, GeSe, SnS, and SnSe) are materials with interesting thickness-dependent characteristics, which have been applied in many areas. However, the stability of layered monochalcogenides (LMs) is a real problem in semiconductor devices that contain these materials. Therefore, it is an important issue that needs to be explored. This article presents a comprehensive study of the degradation mechanism in mechanically exfoliated monochalcogenides in ambient conditions using Raman and photoluminescence spectroscopy supported by structural methods. A higher stability (up to three weeks) was observed for GaS. The most reactive were Se-containing monochalcogenides. Surface protrusions appeared after the ambient exposure of GeSe was detected by scanning electron microscopy. In addition, the degradation of GeS and GeSe flakes was observed in the operando experiment in transmission electron microscopy. Additionally, the amorphization of the material progressed from the flake edges. The reported results and conclusions on the degradation of LMs are useful to understand surface oxidation, air stability, and to fabricate stable devices with monochalcogenides. The results indicate that LMs are more challenging for exfoliation and optical studies than transition metal dichalcogenides such as MoS2, MoSe2, WS2, or WSe2.