Self-Catalyzed Sensitization of CuO Nanowires via a Solvent-free Click Reaction

On-Surface Azide-Alkyne Cycloaddition Reaction: Does It Click with Ruthenium Catalysts?

Owing to its simplicity, selectivity, high yield, and the absence of byproducts, the "click" azide-alkyne reaction is widely used in many areas. The reaction is usually catalyzed by copper(I), which selectively produces the 1,4-disubstituted 1,2,3-triazole regioisomer. Ruthenium-based catalysts were later developed to selectively produce the opposite regioselectivity─the 1,5-disubstituted 1,2,3-triazole isomer. Ruthenium-based catalysis, however, remains only tested for click reactions in solution, and the suitability of ruthenium catalysts for surface-based click reactions remains unknown. Also unknown are the electrical properties of the 1,4- and 1,5-regioisomers, and to measure them, both isomers need to be assembled on the electrode surface. Here, we test whether ruthenium catalysts can be used to catalyze surface azide-alkyne reactions to produce 1,5-disubstituted 1,2,3-triazole, and compare their electrochemical properties, in terms of surface coverages and electron transfer kinetics, to those of the compound formed by copper catalysis, 1,4-disubstituted 1,2,3-triazole isomer. Results show that ruthenium(II) complexes catalyze the click reaction on surfaces yielding the 1,5-disubstituted isomer, but the rate of the reaction is remarkably slower than that of the copper-catalyzed reaction, and this is related to the size of the catalyst involved as an intermediate in the reaction. The electron transfer rate constant (ket) for the ruthenium-catalyzed reaction is 30% of that measured for the copper-catalyzed 1,4-isomer. The lower conductivity of the 1,5-isomer is confirmed by performing nonequilibrium Green's function computations on relevant model systems. These findings demonstrate the feasibility of ruthenium-based catalysis of surface click reactions and point toward an electrical method for detecting the isomers of click reactions.

Click Chemistry-Mediated Particle Counting Sensing via Cu(II)-Polyglutamic Acid Coordination Chemistry and Enzymatic Reaction

An electrical resistance-based particle counter (ERPC) with simple operation and high resolution has proved to be a promising biosensing toolkit, whereas amplification-free ERPC biosensors are incapable of analyzing trace small molecules due to their relatively low sensitivity. In this work, click chemistry-mediated particle counting sensing of small-molecule hazards in food samples with high sensitivity was developed. In this strategy, unbound alkyne-functionalized polystyrene microspheres were collected by magnetic separation from the copper-ion-mediated click reaction between alkyne-functionalized polystyrene microspheres and azido-functionalized magnetic beads, which could be used as signal probes for the readout. This click chemistry-mediated ERPC biosensor converts the detection of targets to the quantification of copper ions or ascorbic acid by performing competitive immunoassay-based coordination chemistry and enzymatic reaction, respectively. The sensitivity of the ERPC biosensor has been improved by an order of magnitude due to the signal amplification effects of click chemistry, coordination adsorption, and enzyme catalysis. Furthermore, because of the efficient separation and enrichment of immunomagnetic beads and the robustness of click chemistry, the interference from food matrixes and immunoassay is effectively reduced, and thus, our strategy is exceedingly suitable for detecting trace targets in complex samples.

Uniform Wrapping of Copper(I) Oxide Nanocubes by Self-Controlled Copper-Catalyzed Azide–Alkyne Cycloaddition toward Selective Carbon Dioxide Electrocatalysis

We wrapped copper(I) oxide nanocubes with an extremely uniform organic layer grown by self-controlled, Cu-mediated catalysis. The layer held copper within the initial cubic structure during its use as a...