MOF-Derived Cobalt@Mesoporous Carbon as Electrocatalysts for Oxygen Evolution Reaction: Impact of Organic Linker

Multiprocessing Substrates Enhanced Ta2O5/NiCo2O4 Spinel Nanocomposites for Effective Electro-/Photocatalytic and Toxicological Effects via the Caenorhabditis elegans Model

NiCo2O4 spinel composites decorated with metal oxides (Ta2O5), reduced graphene oxide (rGO), polyaminoanthraquinone (PAAQ), and layered double hydroxide hydrotalcite (HTs) were synthesized by the hydrothermal route. The synthesized composites were characterized using X-ray powder diffraction (XRD), Brunauer-Emmett-Teller (BET), high-resolution transmission electron microscopy (HR-TEM), and X-ray photoelectron spectroscopy (XPS) analyses for structural parameters such as surface area, morphology, chemical composition, etc. The production of oxygen by the water oxidation technique is the most suitable eco-friendly method, where rGO@Ta2O5/NiCo2O4 (RTNCO) showed an efficient oxygen evolution reaction (OER) performance under 1 M KOH electrolyte. Lower Tafel slope and overpotential values of 76 mV dec-1 and 315 mV, respectively, were calculated for RTNCO. The photocatalytic degradation efficiencies calculated were MB = 97.86%, RhB = 94.75%, and AP = 96% under UV light illumination within 120 min. The degraded dye solution was tested on mung bean (Vigna radiata) plants to determine the toxicity of the dye solution after 15 days, and the results showed good seed germination similar to that in water as the control. The synthesized materials exhibited better antibacterial activity against Bacillus cereus, Staphylococcus aureus, Pseudomonas aeruginosa, and Escherichia coli. Interestingly, the toxicological effects of the degraded dyes and drug solutions were effectively studied in the Caenorhabditis elegans model. The overall results revealed that the synthesized composites are promising for electro-/photocatalytic and biological applications.

Electrocatalytic activity and surface oxide reconstruction of bimetallic iron-cobalt nanocarbide electrocatalysts for the oxygen evolution reaction

For renewable energy technology to become ubiquitous, it is imperative to develop efficient oxygen evolution reaction (OER) electrocatalysts, which is challenging due to the kinetically and thermodynamically unfavorable OER mechanism. Transition metal carbides (TMCs) have recently been investigated as desirable OER pre-catalysts, but the ability to tune electrocatalytic performance of bimetallic catalysts and understand their transformation under electrochemical oxidation requires further study. In an effort to understand the tunable TMC material properties for enhancing electrocatalytic activity, we synthesized bimetallic FeCo nanocarbides with a complex mixture of FeCo carbide crystal phases. The synthesized FeCo nanocarbides were tuned by percent proportion Fe (i.e. % Fe), and analysis revealed a non-linear dependence of OER electrocatalytic activity on % Fe, with a minimum overpotential of 0.42 V (15-20% Fe) in alkaline conditions. In an effort to understand the effects of Fe composition on electrocatalytic performance of FeCo nanocarbides, we assessed the structural phase and electronic state of the carbides. Although we did not identify a single activity descriptor for tuning activity for FeCo nanocarbides, we found that surface reconstruction of the carbide surface to oxide during water oxidation plays a pivotal role in defining electrocatalytic activity over time. We observed that a rapid increase of the (FexCo1-x)2O4 phase on the carbide surface correlated with lower electrocatalytic activity (i.e. higher overpotential). We have demonstrated that the electrochemical performance of carbides under harsh alkaline conditions has the potential to be fine-tuned via Fe incorporation and with control, or suppression, of the growth of the oxide phase.