Nanoemulsions with All Ionic Liquid Components as Recyclable Nanoreactors

Dielectric Depiction of 1-Butyl-3-methylimidazolium Tetrafluoroborate/1-Butyl-3-methylimidazolium 1,4-Bis(2-ethylhexyl) Sulfosuccinate/Benzene Microemulsions: Percolation, Interface Polarization, and Electrical Parameters

Two dielectric relaxations located at approximately 10 and 300 MHz were analyzed in the microemulsion composed of the polar ionic liquid (PIL) 1-butyl-3-methylimidazolium tetrafluoroborate ([bmim][BF4]), the surface-active ionic liquid (SAIL) 1-butyl-3-methylimidazolium 1,4-bis(2-ethylhexyl) sulfosuccinate ([bmim][AOT]), and benzene. The curve of the dc conductivity vs PIL weight fraction shows two inflection points, namely, 16.69 and 27.90 wt %, which are used to divide the PIL/O, bicontinuous (B.C.), and O/PIL subregions. The critical exponents of percolation u = 0.75, 0.79, and 0.80 are suggested from the scaling dependence of dc conductivity on the PIL weight fraction, together with frequency dependences of both permittivity and loss angle, which all infer that static percolation occurs in the microemulsion. Only one dielectric relaxation at high frequency was observed in the PIL/O subregion, when the concentration increased to the boundary between the PIL/O and B.C. subregions; the second dielectric relaxation appeared at low frequency. The high-frequency relaxation is caused by interfacial polarization. The low-frequency relaxation is attributed to the dipole-oriented polarization of AOT-. When the oil content of the system was reduced, the interface became softer to allow more AOT- to rotate, and the cation shifted from moving around its long axis to rotating along its short axis. The static dielectric constant of [bmim][AOT] was given. The dielectric constants and conductivity of the dispersed and continuous phases in the PIL/O and O/PIL subregions were calculated from the dielectric parameters of high-frequency relaxation.

Water-pluronic-ionic liquid based microemulsions: Preparation, characterization and application as micro-reactor for enhanced catalytic activity of Cytochrome-c

Microemulsions (µEs), comprising water as polar component, pluronic (normal, L35 and reverse, 10R5) as surfactant and a hydrophobic ionic liquid (HIL) as non-polar component have been prepared and characterized. Owing to higher surface activity, pluronics have promoted the formation of µEs without the use of co-surfactant. Thus prepared µEs have been utilized as nano-reactors for the oxidation of guaiacol in the presence of Cytochrome-c (Cyt-c) at 15, 20, and 25 °C. A 3.2- and 1.3-fold increase in the rate of formation of product of enzymatic catalysis in direct µE (HIL-in-water) with reverse pluronic (10R5) is observed at 15 and 20 °C as compared to that in buffer. However, negligible enzymatic activity is observed in the direct µE formed by normal pluronic (L35). The catalytic activity of Cyt-c decreases in reverse µEs (water-in-HIL) as compared to direct µEs irrespective of the nature of pluronic used. The contrasting nature of nano-interfaces formed by pluronics in µEs and the extent of hydration of these nano-interfaces controlled by temperature exerts varying influence on the catalytic activity of Cyt-c. It is expected that the present work would result in providing a versatile platform for the creation of new IL and pluronic-based µEs for bio-catalytic applications, which have never been reported.

The Trend of Organic Based Nanoparticles in the Treatment of Diabetes and Its Perspectives

Diabetes is an untreatable metabolic disorder characterized by alteration in blood sugar homeostasis, with submucosal insulin therapy being the primary treatment option. This route of drug administration is attributed to low patient comfort due to the risk of pain, distress, and local inflammation/infections. Nanoparticles have indeed been suggested as insulin carriers to allow the drug to be administered via less invasive routes other than injection, such as orally or nasally. The organic-based nanoparticles can be derived from various organic materials (for instance, polysaccharides, lipids, and so on) and thus are prevalently used to enhance the physical and chemical consistency of loaded bioactive compounds (drug) and thus their bioavailability. This review presents various forms of organic nanoparticles (for example, chitosan, dextron, gums, nanoemulsion, alginate, and so on) for enhanced hypoglycemic drug delivery relative to traditional therapies.

Ionic Liquid-Based Colloidal Formulations for the Synthesis of Nano-MOFs: Applications in Gas Adsorption and Water Desalination

Microemulsions (MEs) comprising choline dioctylsulfosuccinate [Cho][AOT], a biobased ionic liquid (IL) surfactant as an emulsifier, (R)-(+)-limonene (RL) as a nonpolar phase, and ethylene glycol (EG)/ethanolammonium formate (EOAF) as an organic solvent/low-viscosity IL polar component were constructed. Spontaneous aggregation of [Cho][AOT] was observed with a negative ΔH form using isothermal titration calorimetry. The aggregates of [Cho][AOT] in RL showed a critical micellar concentration (cmc) of ∼5.49 mM, EG (cmc ∼3.99 mM), and EOAF (cmc ∼1.56 mM), and these are further characterized by various techniques. These novel IL-based MEs have been used as nanoreactors for the sustainable synthesis of uniform nanosized metal-organic frameworks (N-MOFs), such as MIL-53(Al), HKUST-1, UIO-66-NH₂, and ZIF-8, with a precise control over size and morphology at room temperature. Characterization of N-MOFs has been performed using scanning electron microscopy, powder X-ray diffraction, and Fourier transform infrared spectroscopy. The synthesized N-MOFs have been used to prepare stable and uniform thin film nanocomposite nanofiltration membranes, suitable for desalination of brackish water with excellent flux (31.8 LMH/bar) and rejection (99.0%) of divalent salts.

Enhancing Demulsification Performance for Oil-Water Separation through Encapsulating Ionic Liquids in the Pore of MIL-100(Fe)

Emulsion poses a greater challenge for the remediation of oily wastewater, which can be effectively resolved by the metal-organic framework of MIL-100(Fe). The formula Fe₃O(H₂O)₂(OH) (BTC)₂ pronounces that MIL-100(Fe) suffers from an intrinsic defect of less charged atoms, which limits its demulsification performance for oil-water separation. Herein, cations of the ionic liquid (1-allyl-3-methylimidazolium, Amim⁺) were encapsulated in the micropore of MIL-100(Fe) in situ to increase the positive charge density of MIL-100(Fe). Zeta potential demonstrated that the encapsulation of Amim⁺ increased the positive charge amount of MIL-100(Fe). N₂ probe isothermal adsorption/desorption and spectral measurements (X-ray photoelectron spectroscopy, ultraviolet-visible diffuse reflection spectroscopy, and attenuated total-reflectance infrared spectroscopy) revealed the host-guest interactions of π···Fe complexation and π···cation electrostatic attraction between Amim⁺ and MIL-100(Fe) for the composite materials. Amim⁺ encapsulation greatly enhanced the demulsification performance of MIL-100(Fe) for oil-in-water (O/W) emulsion stabilized by sodium dodecyl sulfate. Amim⁺-encapsulated MIL-100(Fe) with an Amim⁺/Fe³⁺ molar ratio of 1:1 [Amim@MIL-100(Fe)-3:3] showed a demulsification efficiency (DE) of 94% within 30 s, compared with MIL-100(Fe) within 30 min. The maximum DE of Amim@MIL-100(Fe)-3:3 was found to be more than 98% within 5 min. The DE lost by MIL-100(Fe) at the third run decreased from 36 to 17% after encapsulating Amim⁺. The analysis of surface charge and interfacial tension implied a demulsification mechanism of capturing-fusion, which could be promoted by the greater electrostatic attraction. Finally, the role of Amim⁺ on the outstanding demulsification performance by Amim⁺-encapsulated MIL-100(Fe) could be explained by the enhanced nonbonded interaction of electrostatic attraction and van der Waals based on the molecular dynamics simulation.

Biocompatible Solvents and Ionic Liquid-Based Surfactants as Sustainable Components to Formulate Environmentally Friendly Organized Systems

In this review, we deal with the formation and application of biocompatible water-in-oil microemulsions commonly known as reverse micelles (RMs). These RMs are extremely important to facilitate the dissolution of hydrophilic and hydrophobic compounds for biocompatibility in applications in drug delivery, food science, and nanomedicine. The combination of two wisely chosen types of compounds such as biocompatible non-polar solvents and ionic liquids (ILs) with amphiphilic character (surface-active ionic liquids, SAILs) can be used to generate organized systems that perfectly align with the Green Chemistry concepts. Thus, we describe the current state of SAILs (protic and aprotic) to prepare RMs using non-polar but safe solvents such as esters derived from fatty acids, among others. Moreover, the use of the biocompatible solvents as the external phase in RMs and microemulsions/nanoemulsions with the other commonly used biocompatible surfactants is detailed showing the diversity of preparations and important applications. As shown by multiple examples, the properties of the RMs can be modified by changes in the type of surfactant and/or external solvents but a key fact to note is that all these modifications generate novel systems with dissimilar properties. These interesting properties cannot be anticipated or extrapolated, and deep analysis is always required. Finally, the works presented provide valuable information about the use of biocompatible RMs, making them a green and promising alternative toward efficient and sustainable chemistry.

Recent advances in ionic liquids and nanotechnology for drug delivery

In drug discovery and drug development, it is estimated that around 40% of commercialized and 90% of under-study drugs have inadequate pharmaceutical properties, severely impairing its therapeutic efficacy. Thus, there is a strong demand to find strategies to enhance the delivery of such drugs. Ionic liquids are a novel class of liquids composed of a combination of organic salts that are of particular interest alone or in combination with drug delivery systems. This review is focused on the recent efforts using ionic liquids in drug solubility, formulation and drug delivery with specific emphasis on nanotechnology. The latest developments using hybrid delivery systems obtained upon the combination of drug delivery systems and ionic liquids will also be addressed.

Combination of a protic ionic liquid-like surfactant and biocompatible solvents to generate environmentally friendly anionic reverse micelles

imim–DEHP, a versatile protic IL-like surfactant to formulate aqueous RMs in biocompatible non-polar solvents.