Introducing "Insertive Stripping Voltammetry": Electrochemical Determination of Sodium Ions Using an Iron(III) Phosphate-Modified Electrode

Determination of lithium ions by stripping voltammetry using single-crystal LiFePO4

Determination of lithium ions is very important for extraction of lithium from salt lakes. Electrochemical sensor is an ideal choice, but it is not available so far. Here, a voltammetric sensor based on lithium iron phosphate (LiFePO4) was developed. Single-crystal LiFePO4 dominated by the (010) lattice plane was synthesized using hydrothermal method; it had good selectivity for lithium ions. Lithium ions were preferentially intercalated into LiFePO4 even if molar ratio of sodium ions, potassium ions, magnesium ions or calcium ions to lithium ions reached 10:1. The intercalation and deintercalation of interfering ions should be avoided because this reduced the selectivity of LiFePO4 for lithium ions. Lithium ion concentration of synthetic Uyuni Salt Lake solution was determined using the standard addition method. The measurement result was only 0.34 % higher than the theoretical value. The sensor provides a highly selective lithium ion analysis method at an extremely low cost, which was very promising to be widely used.

Electrochemical Detection of Electrolytes Using a Solid-State Ion-Selective Electrode of Single-Piece Type Membrane

This study aimed to develop simple electrochemical electrodes for the fast detection of chloride, sodium and potassium ions in human serum. A flat thin-film gold electrode was used as the detection electrode for chloride ions; a single-piece type membrane based solid-state ion-selective electrode (ISE), which was formed by covering a flat thin-film gold electrode with a mixture of 7,7,8,8-tetracyanoquinodimethane (TCNQ) and ion-selective membrane (ISM), was developed for sodium and potassium ions detection. Through cyclic voltammetry (CV) and square-wave voltammetry (SWV), the detection data can be obtained within two minutes. The linear detection ranges in the standard samples of chloride, sodium, and potassium ions were 25-200 mM, 50-200 mM, and 2-10 mM, with the average relative standard deviation (RSD) of 0.79%, 1.65%, and 0.47% and the average recovery rates of 101%, 100% and 96%, respectively. Interference experiments with Na+, K+, Cl-, Ca2+, and Mg2+ ions demonstrated that the proposed detection electrodes have good selectivity. Moreover, the proposed detection electrodes have characteristics such as the ability to be prepared under relatively simple process conditions, excellent detection sensitivity, and low RSD, and the detection linear range is suitable for the Cl-, Na+ and K+ concentrations in human serum.

Signal amplification by electro-oligomerisation for improved isoproturon detection

A novel concept is introduced for signal amplification in electrochemical sensing: the electro-oligomerisation stripping voltammetry, which has been applied here to the improved detection of the isoproturon herbicide in spring waters as a proof-of-principle. It involves a potentiostatic accumulation step onto a glassy carbon electrode (at +1.5 V vs Ag/AgCl reference electrode for 300 s) leading to the formation of an oligomeric film, which is then detected by cathodic stripping square wave voltammetry (SWV). The presence and composition of the film are confirmed by confocal Raman spectroscopy. Its characterisation by cyclic voltammetry demonstrates the reversible nature of the electrodeposited material, confirming its interest for sensitive detection by SWV. Adding a mesoporous silica membrane with vertically oriented nanochannels further enhances the sensitivity of the sensor, exhibiting a linear response in the 10-100 μM concentration range. This effect was even more interesting for real media analysis thanks to the permselective properties of such nanoporous coating in rejecting interferences and/or surface fouling agents. The method should be applicable to other analytes that are usually not detectable by conventional accumulation/stripping voltammetry.