The Interaction of Fusarium solani pisi Cutinase with Long Chain Spin Label Esters

Cleavage Product Accumulation Decreases the Activity of Cutinase during PET Hydrolysis

The Fusarium solani cutinase (FsC) is a promising candidate for the enzymatic degradation of the synthetic polyester polyethylene terephthalate (PET) but still suffers from a lack of activity. Using atomic MD simulations with different concentrations of cleavage product ethylene glycol (EG), we show influences of EG on the dynamic of FsC. We observed accumulation of EG in the active site region reducing the local flexibility of FsC. Furthermore, we used a coarse-grained mechanical model to investigate whether substrate binding in the active site causes an induced fit. We observed this supposed induced fit or "breath-like" movement during substrate binding indicating that the active site has to be flexible for substrate conversion. This guides rational design: mutants with an increased flexibility near the active site should be considered to compensate the solvent-mediated reduction in activity.

Thermodynamic and structural investigation of the specific SDS binding of Humicola insolens cutinase

The interaction of lipolytic enzymes with anionic surfactants is of great interest with respect to industrially produced detergents. Here, we report the interaction of cutinase from the thermophilic fungus Humicola insolens with the anionic surfactant SDS, and show the enzyme specifically binds a single SDS molecule under nondenaturing concentrations. Protein interaction with SDS was investigated by NMR, ITC and molecular dynamics simulations. The NMR resonances of the protein were assigned, with large stretches of the protein molecule not showing any detectable resonances. SDS is shown to specifically interact with the loops surrounding the catalytic triad with medium affinity (Ka ≈ 10(5) M(-1) ). The mode of binding is closely similar to that seen previously for binding of amphiphilic molecules and substrate analogues to cutinases, and hence SDS acts as a substrate mimic. In addition, the structure of the enzyme has been solved by X-ray crystallography in its apo form and after cocrystallization with diethyl p-nitrophenyl phosphate (DNPP) leading to a complex with monoethylphosphate (MEP) esterified to the catalytically active serine. The enzyme has the same fold as reported for other cutinases but, unexpectedly, esterification of the active site serine is accompanied by the ethylation of the active site histidine which flips out from its usual position in the triad.

The role of short-range Cys171-Cys178 disulfide bond in maintaining cutinase active site integrity: a molecular dynamics simulation

Understanding structural determinants in enzyme active site integrity can provide a good knowledge to design efficient novel catalytic machineries. Fusarium solani pisi cutinase with classic triad Ser-His-Asp is a promising enzyme to scrutinize these structural determinants. We performed two MD simulations: one, with the native structure, and the other with the broken Cys171-Cys178 disulfide bond. This disulfide bond stabilizes a turn in active site on which catalytic Asp175 is located. Functionally important H-bonds and atomic fluctuations in catalytic pocket have been changed. We proposed that this disulfide bond within active site can be considered as an important determinant of cutinase active site structural integrity.

Aggregation as the basis for complex behaviour of cutinase in different denaturants

We have previously described the complexity of the folding of the lipolytic enzyme cutinase from F. solani pisi in guanidinium chloride. Here we extend the refolding analysis by refolding from the pH-denatured state and analyze the folding behaviour in the presence of the weaker denaturant urea and the stronger denaturant guanidinium thiocyanate. In urea there is excellent consistency between equilibrium and kinetic data, and the intermediate accumulating at low denaturant concentrations is off-pathway. However, in GdmCl, refolding rates, and consequently the stability of the native state, vary significantly depending on whether refolding takes place from the pH- or GdmCl-denatured state, possibly due to transient formation of aggregates during folding from the GdmCl-denatured state. In GdmSCN, stability is reduced by several kcal/mol with significant aggregation in the unfolding transition region. The basis for the large variation in folding behaviour may be the denaturants' differential ability to support formation of exposed hydrophobic regions and consequent changes in aggregative properties during refolding.