Vanadium Pentoxide Catalyst over Carbon-Based Nanomaterials for the Oxidative Dehydrogenation of Propane

Controlled synthesis of MWCNTs/V2O5 nanocomposite by hydrothermal approach for adsorption and photodegradation processes

The current paper outlines the synthesis of pristine multi-wall carbon nanotubes (PMWCNTs)/Vanadium pentoxide V2O5 and functionalized multi-wall carbon nanotubes (FMWCNTs)/V2O5 nanocomposite for photocatalytic applications. The FMWCNTs were obtained by the oxidizing agents (H2SO4 and HNO3) to introduce the oxygenated functional groups. The samples were synthesized by hydrothermal approach and investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy analysis (EDX), and Fourier transform infrared spectroscopy (FTIR). The photocatalytic activity of multi-wall carbon nanotubes (MWCNTs), FMWCNTs/V2O5, and PMWCNTs/V2O5 nanocomposites was assessed via methylene blue (MB) degradation from water under visible light. The results demonstrated that the removal efficiency of MB by PMWCNTs, FMWCNTs/V2O5, and PMWCNTs/V2O5 could reach 90.4, 98.9, and 94.9%, respectively. It was noticed that MB adsorption and photodegradation tend to follow pseudo-second-order kinetics. The mechanism of MB photodegradation by FMWCNTs/V2O5 nanoparticles was explained. MWCNTs/V2O5 nanocomposites will allow further applications to remove other dyes and contaminants from wastewater.

Metal-organic framework derived vanadium oxide supported nanoporous carbon structure as a bifunctional electrocatalyst for potential application in metal air batteries

High-efficiency, sustainable, non-precious metal-based electrocatalysts with bifunctional catalytic activity for the oxygen reduction reaction (ORR) and the oxygen evolution reaction (OER) are essential for metal-air batteries. In this research, a bifunctional electrocatalyst is developed by synthesizing a novel nanoporous vanadium oxide/carbon composite (NVC-900) through pyrolysis of a highly efficient vanadium metal-organic framework, MIL-101 (V). The fabrication process was conveniently carried out by pyrolyzing the synthesized MIL-101 (V) at 900 °C, producing vanadium oxide nanoparticles embedded in the extensively distributed pores of the carbon network. The evenly distributed nanopores substantially improve the performance of the efficient electrocatalyst for both the oxygen reduction reaction and oxygen evolution reactions (ORR/OER) by increasing surface area and facilitating access to stable catalytic active sites. The unique structure was characterized by powder X-ray diffraction (XRD) and scanning electron microscopy (SEM). For oxygen reduction reaction (ORR), the electrocatalyst established a promising limiting current density (J _L) of 5.2 mA cm^-2 at 1600 rpm at an onset potential of 1.18 V and a half-wave potential of 0.82 V, and for OER, a current density of 10 mA cm^-2 was delivered at a potential of 1.48 V. In comparison to 10% Pt/C, the synthesized bifunctional electrocatalyst being almost equally active towards bifunctional activity, showed much better long-term cyclic stability. The one-step thermal pyrolysis strategy to synthesize the nanoporous functional material and the proposed electrocatalytic material's long-term bifunctional activity and durability make it an ideal fit for next-generation portable green metal-air batteries.

Magnetic ZnO Crystal Nanoparticle Growth on Reduced Graphene Oxide for Enhanced Photocatalytic Performance under Visible Light Irradiation

Magnetite zinc oxide (MZ) (Fe₃O₄/ZnO) with different ratios of reduced graphene oxide (rGO) was synthesized using the solid-state method. The structural and optical properties of the nanocomposites were analyzed using transmission electron microscopy (TEM), X-ray diffraction (XRD), Raman spectroscopy, Fourier-transform infrared spectroscopy (FTIR), ultraviolet-visible diffuse reflectance spectroscopy (UV-Vis/DRS), and photoluminescence (PL) spectrophotometry. In particular, the analyses show higher photocatalytic movement for crystalline nanocomposite (MZG) than MZ and ZnO nanoparticles. The photocatalytic degradation of methylene blue (MB) with crystalline ZnO for 1.5 h under visible light was 12%. By contrast, the photocatalytic activity for MZG was more than 98.5%. The superior photocatalytic activity of the crystalline nanocomposite was detected to be due to the synergistic effect between magnetite and zinc oxide in the presence of reduced graphene oxide. Moreover, the fabricated nanocomposite had high electron-hole stability. The crystalline nanocomposite was stable when the material was used several times.

Cellulose Mediated Reduction and Immobilization of Cr(VI) in Chromite Ore Processing Residue

It is a great challenge to find an effective method for the treatment of chromite ore processing residue (COPR), due to the highly toxic and mobile characteristic of Cr(VI) in the sludge. This work reported a facile strategy to thoroughly reduce and immobilize Cr(VI) that was encapsulated in COPR by biomass-assistant hydrothermal treatment. After hydrothermal treatment at 160 °C for 180 min, the leaching of Cr(VI) in COPR decreased from 138.6 mg/L to 2.31 mg/L, well below the disposal standard limit (5 mg/L). It was found that in-situ produced volatile synthesis gas (H₂, CO and CH₄) by cellulose under hydrothermal condition, was responsible for Cr(VI) reduction. The reduction kinetics were temperature-dependent and the rate constants increased from 7.8 × 10^-3 min^-1 at 120 °C to 77.9 × 10^-3 min^-1 at 180 °C. Further simulation experiments revealed that (i) Fe-hydrotalcite in COPR acted as the catalyst for the decomposition of cellulose, and (ii) cellulose can hydrothermally produce reductive gas with a high efficiency, where 0.1 g of cellulose can realize the reduction and immobilization of Cr(VI) equivalent to 14 g of COPR by 14 cycles of treatment. This study provided a promising strategy for one-step remediation of COPR by the coupled reduction-stabilization process.

Alkaline aided thermophiles pretreatment of waste activated sludge to increase short chain fatty acids production: Microbial community evolution by alkaline on hydrolysis and fermentation

Adding alkaline into an anaerobic waste activated sludge (WAS) fermentation with thermophilic bacteria pretreatment could efficiently improve short-chain fatty acids (SCFAs) accumulation to 3550 ± 120 mg COD/L. The acidification rate in combined test was 21.2%, while that was 15.6% and 10.7% in sole thermophilic bacteria pretreatment and control tests respectively. Four distinct groups of microbes could be identified with noticeable shifts using the combined pretreatments, and tremendous effects were analyzed on organic content especially of the soluble proteins and SCFAs concentrations. Particularly, alkaline addition would significantly change the functional microbial structures, including the decrease of Caloramator with the function of thermophilic proteolytic and the increase of Acidobacteria TM7 and Petrimonas sp. The results above suggested that alkaline addition could decrease the hydrolytic substances consume by thermotolerance bacteria and final improve SCFAs accumulation in fermentation process.

Propane Oxidative Dehydrogenation on Vanadium-Based Catalysts under Oxygen-Free Atmospheres

Catalytic propane oxidative dehydrogenation (PODH) in the absence of gas phase oxygen is a promising approach for propylene manufacturing. PODH can overcome the issues of over-oxidation, which lower propylene selectivity. PODH has a reduced environmental footprint when compared with conventional oxidative dehydrogenation, which uses molecular oxygen and/or carbon dioxide. This review discusses both the stoichiometry and the thermodynamics of PODH under both oxygen-rich and oxygen-free atmospheres. This article provides a critical review of the promising PODH approach, while also considering vanadium-based catalysts, with lattice oxygen being the only oxygen source. Furthermore, this critical review focuses on the advances that were made in the 2010–2018 period, while considering vanadium-based catalysts, their reaction mechanisms and performances and their postulated kinetics. The resulting kinetic parameters at selected PODH conditions are also addressed.

Structural and toxic effect investigation of vanadium pentoxide

A facile inorganic complex synthesis route has been developed to synthesis V2O5 nanostructures. The effects of varying incubation time on the crystallinity and morphology of the V2O5 phase has been investigated. The obtained XRD result clearly revealed the pure orthorhombic V2O5 crystalline phase. Raman antiphase bridging VO and chaining VO stretching modes peaks at 686 and 521cm(-1) attributed orthorhombic V2O5 characteristics. The V2p3/2 peak at the binding energies of 517eV and V2p1/2 peak at 524eV assigned to V(5+) oxidation state. Bioinspired V2O5 nanostructures as a biocompatible material for anticancer agents show excellent cytotoxicity at higher V2O5 concentration.

Morphological investigations of nanostructured V2O5 over graphene used for the ODHP reaction: from synthesis to physiochemical evaluations

Several V₂O₅ nanostructures, including the rod or belt-like, tube-like, needle-like and flower-like, were synthesized via the reflux and hydrothermal processes utilizing different templates such as monoamine, diamine, aromatic and alcoholic amines