Kinetics of proton-transfer reactions in aqueous solution. IV. Broensted slope for internally hydrogen-bonded weak acids

Broadband coupling into a single-mode, electroactive integrated optical waveguide for spectroelectrochemical analysis of surface-confined redox couples

A single-mode, electroactive waveguiding platform capable of measuring spectroelectrochemical responses of surface-adsorbed redox-active molecules over a broad spectral bandwidth has been created. This new planar waveguide spectrometer is a combination of the previously developed electroactive integrated optical waveguide (EA-IOW; Dunphy, D. R.; Mendes, S. B.; Saavedra, S. S.; Armstrong, N. R. Anal. Chem. 1997, 69, 3086-3094) with a recently reported simplified approach to broadband coupling (Bradshaw, J. T.; Mendes, S. B.; Saavedra, S. S. Anal. Chem. 2002, 74, 1751-1759). With the use of a commercially available prism as an incoupling element, the EA-IOW can now guide visible light from at least 500 to 700 nm, improving upon its previously demonstrated monochromatic nature. Coupling profiles of various laser lines along with transmission spectra of narrow band-pass filters at various potentials are used to demonstrate the optical characteristics of this broadband EA-IOW and to compare its response to that of a conventional transmission instrument. Assessment of spectral resolution, performed by measuring the fwhm of various laser lines, ranges from 0.6 to 0.8. To demonstrate the capabilities of this technology, we show the acquisition of absorbance spectra of two different adsorbates, cytochrome c and ferrocenedicarboxylic acid, as a function of applied potential. Subtleties in the redox chemistries of adsorbed molecules, which were difficult to monitor with a monochromatic waveguide, are readily apparent when using the broadband coupling scheme.

Spectroelectrochemical sensing based on multimode selectivity simultaneously achievable in a single device. 5. Simulation of sensor response for different excitation potential waveforms

The simulation of the optical response in spectroelectrochemical sensing has been investigated. The sensor consists of a sensing film coated on an optically transparent electrode (OTE). The mode of detection is attenuated total reflection. Only species that partition into the sensing film, undergo electrochemistry at the potentials applied to the OTE, and have changes in their absorbance at the wavelength of light propagated within the glass substrate of the OTE can be sensed. A fundamental question arises regarding the excitation potential waveforms employed to initiate the electrochemical changes observed. Historically, selection has been based solely upon the effectiveness of the waveform to quickly electrolyze any analyte observable by the optical detection method employed. In this report, additional requirements by which the waveform should be selected for use in a remote sensing configuration are discussed. The effectiveness of explicit finite difference simulation as a tool for investigating the applicability of three different excitation potential waveforms (square, triangle, sinusoid) is demonstrated. The simulated response is compared to experimental results obtained from a prototype sensing platform consisting of an indium tin oxide OTE coated with a cation-selective, sol-gel-derived Nafion composite film designed for the detection of a model analyte, tris(2,2'-bipyridyl)ruthenium(II) chloride. Using a diffusion coefficient determined from experimental data (5.8 x 10(-11) cm2 s for 5 x 10(-6) M Ru(bipy)3(2+)), the simulator program was able to accurately predict the magnitude of the absorbance change for each potential waveform (0.497 for square, 0.403 for triangular, and 0.421 for sinusoid), but underestimated the number of cycles required to approach steady state. The simulator program predicted 2 (square), 3 (triangle), and 5 cycles (sinusoid), while 5 (square), 15 (triangle), and 10 (sinusoid) cycles were observed experimentally.